| Message ID | 1406317464-7525-3-git-send-email-ajaykumar.rs@samsung.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
Hello Ajay, On Fri, Jul 25, 2014 at 9:44 PM, Ajay Kumar <ajaykumar.rs@samsung.com> wrote: > Add DT nodes for ps8622 bridge chip and panel-simple panel. > Add backlight power supply for pwm-backlight. > Also add bridge phandle needed by dp to enable display on peach_pit. > > Note that, peach_pit doesn't support "chunghwa,claa101wb01" panel, > but still we choose to reuse the binding since "chunghwa,claa101wb01" > has similar LCD timings. > > Signed-off-by: Ajay Kumar <ajaykumar.rs@samsung.com> > --- Tested-by: Javier Martinez Canillas <javier.martinez@collabora.co.uk> Best regards, Javier -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
Am 25.07.2014 21:44, schrieb Ajay Kumar: > Add DT nodes for ps8622 bridge chip and panel-simple panel. "simple-panel" > Add backlight power supply for pwm-backlight. > Also add bridge phandle needed by dp to enable display on peach_pit. Note that peach_pi[t] is inconsistent with the file names being peach-pi[t] here and in the two subjects. > > Note that, peach_pit doesn't support "chunghwa,claa101wb01" panel, > but still we choose to reuse the binding since "chunghwa,claa101wb01" > has similar LCD timings. > > Signed-off-by: Ajay Kumar <ajaykumar.rs@samsung.com> > --- > arch/arm/boot/dts/exynos5420-peach-pit.dts | 36 +++++++++++++++------------- > 1 file changed, 19 insertions(+), 17 deletions(-) > > diff --git a/arch/arm/boot/dts/exynos5420-peach-pit.dts b/arch/arm/boot/dts/exynos5420-peach-pit.dts > index 228a6b1..79beba8 100644 > --- a/arch/arm/boot/dts/exynos5420-peach-pit.dts > +++ b/arch/arm/boot/dts/exynos5420-peach-pit.dts > @@ -30,11 +30,12 @@ > i2c20 = "/spi@12d40000/cros-ec@0/i2c-tunnel"; > }; > > - backlight { > + backlight: backlight { > compatible = "pwm-backlight"; > pwms = <&pwm 0 1000000 0>; > brightness-levels = <0 100 500 1000 1500 2000 2500 2800>; > default-brightness-level = <7>; > + power-supply = <&tps65090_fet1>; > pinctrl-0 = <&pwm0_out>; > pinctrl-names = "default"; > }; > @@ -100,6 +101,12 @@ > regulator-boot-on; > regulator-always-on; > }; > + > + panel: panel-simple { Just "panel"? (AF) > + compatible = "chunghwa,claa101wb01", "simple-panel"; Drop "simple-panel" (Thierry) > + power-supply = <&tps65090_fet6>; > + backlight = <&backlight>; > + }; > }; > > &dp { > @@ -113,22 +120,7 @@ > samsung,link-rate = <0x06>; > samsung,lane-count = <2>; > samsung,hpd-gpio = <&gpx2 6 0>; > - > - display-timings { > - native-mode = <&timing1>; > - > - timing1: timing@1 { > - clock-frequency = <70589280>; > - hactive = <1366>; > - vactive = <768>; > - hfront-porch = <40>; > - hback-porch = <40>; > - hsync-len = <32>; > - vback-porch = <10>; > - vfront-porch = <12>; > - vsync-len = <6>; > - }; > - }; > + bridge = <&ps8625>; > }; > > &fimd { > @@ -155,6 +147,16 @@ > pinctrl-names = "default"; > pinctrl-0 = <&max98090_irq>; > }; > + > + ps8625: ps8625-bridge@48 { "lvds-bridge"? (AF) > + compatible = "parade,ps8625"; > + reg = <0x48>; > + sleep-gpios = <&gpx3 5 0>; > + reset-gpios = <&gpy7 7 0>; > + lane-count = <2>; > + panel = <&panel>; > + backlight = <&backlight>; > + }; > }; > > &hsi2c_9 { Regards, Andreas
On Sat, Aug 23, 2014 at 4:05 PM, Andreas Färber <afaerber@suse.de> wrote: > Am 25.07.2014 21:44, schrieb Ajay Kumar: >> Add DT nodes for ps8622 bridge chip and panel-simple panel. > > "simple-panel" Ok. >> Add backlight power supply for pwm-backlight. >> Also add bridge phandle needed by dp to enable display on peach_pit. > > Note that peach_pi[t] is inconsistent with the file names being > peach-pi[t] here and in the two subjects. Ok. >> >> Note that, peach_pit doesn't support "chunghwa,claa101wb01" panel, >> but still we choose to reuse the binding since "chunghwa,claa101wb01" >> has similar LCD timings. >> >> Signed-off-by: Ajay Kumar <ajaykumar.rs@samsung.com> >> --- >> arch/arm/boot/dts/exynos5420-peach-pit.dts | 36 +++++++++++++++------------- >> 1 file changed, 19 insertions(+), 17 deletions(-) >> >> diff --git a/arch/arm/boot/dts/exynos5420-peach-pit.dts b/arch/arm/boot/dts/exynos5420-peach-pit.dts >> index 228a6b1..79beba8 100644 >> --- a/arch/arm/boot/dts/exynos5420-peach-pit.dts >> +++ b/arch/arm/boot/dts/exynos5420-peach-pit.dts >> @@ -30,11 +30,12 @@ >> i2c20 = "/spi@12d40000/cros-ec@0/i2c-tunnel"; >> }; >> >> - backlight { >> + backlight: backlight { >> compatible = "pwm-backlight"; >> pwms = <&pwm 0 1000000 0>; >> brightness-levels = <0 100 500 1000 1500 2000 2500 2800>; >> default-brightness-level = <7>; >> + power-supply = <&tps65090_fet1>; >> pinctrl-0 = <&pwm0_out>; >> pinctrl-names = "default"; >> }; >> @@ -100,6 +101,12 @@ >> regulator-boot-on; >> regulator-always-on; >> }; >> + >> + panel: panel-simple { > > Just "panel"? (AF) > >> + compatible = "chunghwa,claa101wb01", "simple-panel"; > > Drop "simple-panel" (Thierry) Right. >> + power-supply = <&tps65090_fet6>; >> + backlight = <&backlight>; >> + }; >> }; >> >> &dp { >> @@ -113,22 +120,7 @@ >> samsung,link-rate = <0x06>; >> samsung,lane-count = <2>; >> samsung,hpd-gpio = <&gpx2 6 0>; >> - >> - display-timings { >> - native-mode = <&timing1>; >> - >> - timing1: timing@1 { >> - clock-frequency = <70589280>; >> - hactive = <1366>; >> - vactive = <768>; >> - hfront-porch = <40>; >> - hback-porch = <40>; >> - hsync-len = <32>; >> - vback-porch = <10>; >> - vfront-porch = <12>; >> - vsync-len = <6>; >> - }; >> - }; >> + bridge = <&ps8625>; >> }; >> >> &fimd { >> @@ -155,6 +147,16 @@ >> pinctrl-names = "default"; >> pinctrl-0 = <&max98090_irq>; >> }; >> + >> + ps8625: ps8625-bridge@48 { > > "lvds-bridge"? (AF) Ok. I will fix all these nits and resend along with the driver patches. Ajay >> + compatible = "parade,ps8625"; >> + reg = <0x48>; >> + sleep-gpios = <&gpx3 5 0>; >> + reset-gpios = <&gpy7 7 0>; >> + lane-count = <2>; >> + panel = <&panel>; >> + backlight = <&backlight>; >> + }; >> }; >> >> &hsi2c_9 { > > Regards, > Andreas > > -- > SUSE LINUX Products GmbH, Maxfeldstr. 5, 90409 Nürnberg, Germany > GF: Jeff Hawn, Jennifer Guild, Felix Imendörffer; HRB 16746 AG Nürnberg -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
diff --git a/arch/arm/boot/dts/exynos5420-peach-pit.dts b/arch/arm/boot/dts/exynos5420-peach-pit.dts index 228a6b1..79beba8 100644 --- a/arch/arm/boot/dts/exynos5420-peach-pit.dts +++ b/arch/arm/boot/dts/exynos5420-peach-pit.dts @@ -30,11 +30,12 @@ i2c20 = "/spi@12d40000/cros-ec@0/i2c-tunnel"; }; - backlight { + backlight: backlight { compatible = "pwm-backlight"; pwms = <&pwm 0 1000000 0>; brightness-levels = <0 100 500 1000 1500 2000 2500 2800>; default-brightness-level = <7>; + power-supply = <&tps65090_fet1>; pinctrl-0 = <&pwm0_out>; pinctrl-names = "default"; }; @@ -100,6 +101,12 @@ regulator-boot-on; regulator-always-on; }; + + panel: panel-simple { + compatible = "chunghwa,claa101wb01", "simple-panel"; + power-supply = <&tps65090_fet6>; + backlight = <&backlight>; + }; }; &dp { @@ -113,22 +120,7 @@ samsung,link-rate = <0x06>; samsung,lane-count = <2>; samsung,hpd-gpio = <&gpx2 6 0>; - - display-timings { - native-mode = <&timing1>; - - timing1: timing@1 { - clock-frequency = <70589280>; - hactive = <1366>; - vactive = <768>; - hfront-porch = <40>; - hback-porch = <40>; - hsync-len = <32>; - vback-porch = <10>; - vfront-porch = <12>; - vsync-len = <6>; - }; - }; + bridge = <&ps8625>; }; &fimd { @@ -155,6 +147,16 @@ pinctrl-names = "default"; pinctrl-0 = <&max98090_irq>; }; + + ps8625: ps8625-bridge@48 { + compatible = "parade,ps8625"; + reg = <0x48>; + sleep-gpios = <&gpx3 5 0>; + reset-gpios = <&gpy7 7 0>; + lane-count = <2>; + panel = <&panel>; + backlight = <&backlight>; + }; }; &hsi2c_9 {
Add DT nodes for ps8622 bridge chip and panel-simple panel. Add backlight power supply for pwm-backlight. Also add bridge phandle needed by dp to enable display on peach_pit. Note that, peach_pit doesn't support "chunghwa,claa101wb01" panel, but still we choose to reuse the binding since "chunghwa,claa101wb01" has similar LCD timings. Signed-off-by: Ajay Kumar <ajaykumar.rs@samsung.com> --- arch/arm/boot/dts/exynos5420-peach-pit.dts | 36 +++++++++++++++------------- 1 file changed, 19 insertions(+), 17 deletions(-)