@@ -12,7 +12,7 @@
rtc@6000 {
compatible = "qcom,pm8941-rtc";
- reg = <0x6000 0x6100>;
+ reg = <0x6000>;
reg-names = "rtc", "alarm";
interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
};
@@ -27,7 +27,7 @@
pm8916_gpios: gpios@c000 {
compatible = "qcom,pm8916-gpio";
- reg = <0xc000 0x400>;
+ reg = <0xc000>;
gpio-controller;
#gpio-cells = <2>;
interrupts = <0 0xc0 0 IRQ_TYPE_NONE>,
@@ -38,7 +38,7 @@
pm8916_mpps: mpps@a000 {
compatible = "qcom,pm8916-mpp";
- reg = <0xa000 0x400>;
+ reg = <0xa000>;
gpio-controller;
#gpio-cells = <2>;
interrupts = <0 0xa0 0 IRQ_TYPE_NONE>,
@@ -49,7 +49,7 @@
pm8916_temp: temp-alarm@2400 {
compatible = "qcom,spmi-temp-alarm";
- reg = <0x2400 0x100>;
+ reg = <0x2400>;
interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
io-channels = <&pm8916_vadc VADC_DIE_TEMP>;
io-channel-names = "thermal";
@@ -58,7 +58,7 @@
pm8916_vadc: vadc@3100 {
compatible = "qcom,spmi-vadc";
- reg = <0x3100 0x100>;
+ reg = <0x3100>;
interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
#address-cells = <1>;
#size-cells = <0>;
The #size-cells for the pmics are 0, but we specify a size in the reg property so that MPP and GPIO modules can figure out how many pins there are. Now that we've done that by counting irqs, we can remove the size elements in the reg properties and be DT compliant. Signed-off-by: Stephen Boyd <sboyd@codeaurora.org> --- arch/arm64/boot/dts/qcom/pm8916.dtsi | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)