Message ID | 20161117011836.GB8133@dtor-ws (mailing list archive) |
---|---|
State | New, archived |
Headers | show |
On 17/11/16 01:18, Dmitry Torokhov wrote: > On Wed, Nov 16, 2016 at 06:38:22PM +0000, Sudeep Holla wrote: >> Commit 700a38b27eef ("Input: gpio_keys - switch to using generic device >> properties") switched to use generic device properties for GPIO keys and >> commit 5feeca3c1e39 ("Input: gpio_keys - add support for GPIO descriptors") >> switched from legacy GPIO numbers to GPIO descriptors. >> >> Previously devm_gpio_request_one was explicitly passed GPIOF_DIR_IN flag >> to set the GPIO direction as input. However devm_get_gpiod_from_child >> doesn't have such provisions and hence fwnode_get_named_gpiod can't set >> it as input. >> >> This breaks few platforms with the following error: >> " gpiochip_lock_as_irq: tried to flag a GPIO set as output for IRQ >> unable to lock HW IRQ <n> for IRQ >> genirq: Failed to request resources for POWER (irq <x>) on irqchip >> gpio_keys: Unable to claim irq <x>; error -22 >> gpio-keys: probe failed with error -22 " >> >> This patch fixes the issue by setting input direction explicitly for >> gpio input keys. It also remove the existing GPIOF_DIR_IN flag setting >> for the legacy gpios and merges into single gpiod_direction_input call. >> >> Fixes: 700a38b27eef ("Input: gpio_keys - switch to using generic device properties") >> Cc: Dmitry Torokhov <dmitry.torokhov@gmail.com> >> Cc: Linus Walleij <linus.walleij@linaro.org> >> Cc: Geert Uytterhoeven <geert+renesas@glider.be> >> Cc: Mika Westerberg <mika.westerberg@linux.intel.com> >> Signed-off-by: Sudeep Holla <sudeep.holla@arm.com> >> --- >> drivers/input/keyboard/gpio_keys.c | 10 +++++++++- >> drivers/input/keyboard/gpio_keys_polled.c | 10 +++++++++- >> 2 files changed, 18 insertions(+), 2 deletions(-) >> >> v2->v3: >> - Added error handling and error message >> >> diff --git a/drivers/input/keyboard/gpio_keys.c b/drivers/input/keyboard/gpio_keys.c >> index 5576f2ae0b71..ed38a05b3039 100644 >> --- a/drivers/input/keyboard/gpio_keys.c >> +++ b/drivers/input/keyboard/gpio_keys.c >> @@ -502,7 +502,7 @@ static int gpio_keys_setup_key(struct platform_device *pdev, >> * Legacy GPIO number, so request the GPIO here and >> * convert it to descriptor. >> */ >> - unsigned flags = GPIOF_IN; >> + unsigned flags = 0; >> >> if (button->active_low) >> flags |= GPIOF_ACTIVE_LOW; > > Sudeep, I looked into this aa bit deeper, and I have issue with this > part: in absence of GPIOF_IN devm_gpio_request_one() will attempt to > configure GPIO line as output, which may not work. Because of this I > think we should move gpiod_direction_input() call into the "modern" > branch and leave legacy branch as is. > > Does the version below work for you? > Yes it does and in fact I started with something similar and then saw that I can make it common between legacy and new branch conditions. So I am fine with the modified version you sent.
diff --git a/drivers/input/keyboard/gpio_keys.c b/drivers/input/keyboard/gpio_keys.c index 5576f2a..582462d 100644 --- a/drivers/input/keyboard/gpio_keys.c +++ b/drivers/input/keyboard/gpio_keys.c @@ -496,6 +496,13 @@ static int gpio_keys_setup_key(struct platform_device *pdev, error); return error; } + } else { + error = gpiod_direction_input(bdata->gpiod); + if (error) { + dev_err(dev, "Failed to configure GPIO %d as input: %d\n", + desc_to_gpio(bdata->gpiod), error); + return error; + } } } else if (gpio_is_valid(button->gpio)) { /* diff --git a/drivers/input/keyboard/gpio_keys_polled.c b/drivers/input/keyboard/gpio_keys_polled.c index 72b3503..bed4f20 100644 --- a/drivers/input/keyboard/gpio_keys_polled.c +++ b/drivers/input/keyboard/gpio_keys_polled.c @@ -314,6 +314,14 @@ static int gpio_keys_polled_probe(struct platform_device *pdev) fwnode_handle_put(child); return error; } + + error = gpiod_direction_input(bdata->gpiod); + if (error) { + dev_err(dev, "Failed to configure GPIO %d as input: %d\n", + desc_to_gpio(bdata->gpiod), error); + fwnode_handle_put(child); + return error; + } } else if (gpio_is_valid(button->gpio)) { /* * Legacy GPIO number so request the GPIO here and