@@ -64,6 +64,19 @@
};
};
+ mdio0: ethernet-phy {
+ compatible = "virtual,mdio-gpio";
+ gpios = <&gpio0 22 GPIO_ACTIVE_HIGH>, /* MDC */
+ <&gpio0 21 GPIO_ACTIVE_HIGH>; /* MDIO */
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ phy0: ethernet-phy@0 {
+ reg = <1>;
+ device_type = "ethernet-phy";
+ };
+ };
+
soc {
flash@30000000 {
status = "okay";
@@ -58,6 +58,19 @@
};
};
+ mdio0: ethernet-phy {
+ compatible = "virtual,mdio-gpio";
+ gpios = <&gpio0 22 GPIO_ACTIVE_HIGH>, /* MDC */
+ <&gpio0 21 GPIO_ACTIVE_HIGH>; /* MDIO */
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ phy0: ethernet-phy@0 {
+ reg = <1>;
+ device_type = "ethernet-phy";
+ };
+ };
+
soc {
flash@30000000 {
status = "okay";
@@ -69,6 +69,19 @@
};
};
+ mdio0: ethernet-phy {
+ compatible = "virtual,mdio-gpio";
+ gpios = <&gpio0 22 GPIO_ACTIVE_HIGH>, /* MDC */
+ <&gpio0 21 GPIO_ACTIVE_HIGH>; /* MDIO */
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ phy0: ethernet-phy@0 {
+ reg = <1>;
+ device_type = "ethernet-phy";
+ };
+ };
+
soc {
flash@30000000 {
status = "okay";
@@ -69,6 +69,24 @@
};
};
+ mdio0: ethernet-phy {
+ compatible = "virtual,mdio-gpio";
+ gpios = <&gpio0 22 GPIO_ACTIVE_HIGH>, /* MDC */
+ <&gpio0 21 GPIO_ACTIVE_HIGH>; /* MDIO */
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ phy0: ethernet-phy@0 {
+ reg = <1>;
+ device_type = "ethernet-phy";
+ };
+
+ phy1: ethernet-phy@5 {
+ reg = <3>;
+ device_type = "ethernet-phy";
+ };
+ };
+
soc {
flash@30000000 {
status = "okay";
These Gemini boards have Ethernet PHY on GPIO bit-banged MDIO, clearly defined in the corresponding OpenWRT ethernet patches since ages. Add them in accordance with the OpenWRT patch so we can use them when we add ethernet support. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- arch/arm/boot/dts/gemini-nas4220b.dts | 13 +++++++++++++ arch/arm/boot/dts/gemini-rut1xx.dts | 13 +++++++++++++ arch/arm/boot/dts/gemini-wbd111.dts | 13 +++++++++++++ arch/arm/boot/dts/gemini-wbd222.dts | 18 ++++++++++++++++++ 4 files changed, 57 insertions(+)