diff mbox

ARM: dts: marzen: Add SDHI0 VCCQ Regulator

Message ID 151904387813.30430.10543147136498508821.sendpatchset@little-apple (mailing list archive)
State Accepted
Commit 56bac953b15087dbced6951248ca05a6f0888831
Delegated to: Simon Horman
Headers show

Commit Message

Magnus Damm Feb. 19, 2018, 12:37 p.m. UTC 
From: Magnus Damm <damm+renesas@opensource.se>

Add support for the on-board voltage regulator hooked up to GPIO3_20
on r8a7779 Marzen. The board schematics describes the regulator as U4
TPS2110A. Input wise, U4 has D0 fixed to ground, D1 tied to GPIO3_20
while IN1 is fixed to 3.3V and IN2 is fixed to 1.8V. OUT goes to the
pull-ups for the data pins of SDHI0.

Signed-off-by: Magnus Damm <damm+renesas@opensource.se>
---

 arch/arm/boot/dts/r8a7779-marzen.dts |   14 ++++++++++++++
 1 file changed, 14 insertions(+)

Comments

Simon Horman Feb. 23, 2018, 4:38 p.m. UTC | #1 
On Mon, Feb 19, 2018 at 09:37:58PM +0900, Magnus Damm wrote:
> From: Magnus Damm <damm+renesas@opensource.se>
> 
> Add support for the on-board voltage regulator hooked up to GPIO3_20
> on r8a7779 Marzen. The board schematics describes the regulator as U4
> TPS2110A. Input wise, U4 has D0 fixed to ground, D1 tied to GPIO3_20
> while IN1 is fixed to 3.3V and IN2 is fixed to 1.8V. OUT goes to the
> pull-ups for the data pins of SDHI0.
> 
> Signed-off-by: Magnus Damm <damm+renesas@opensource.se>

Thanks Magnus, applied.
diff mbox

Patch

--- 0001/arch/arm/boot/dts/r8a7779-marzen.dts
+++ work/arch/arm/boot/dts/r8a7779-marzen.dts	2018-02-19 21:21:14.400607110 +0900
@@ -42,6 +42,19 @@ 
 		regulator-always-on;
 	};
 
+	vccq_sdhi0: regulator-vccq-sdhi0 {
+		compatible = "regulator-gpio";
+
+		regulator-name = "SDHI0 VccQ";
+		regulator-min-microvolt = <1800000>;
+		regulator-max-microvolt = <3300000>;
+
+		gpios = <&gpio3 20 GPIO_ACTIVE_HIGH>;
+		gpios-states = <1>;
+		states = <3300000 1
+			  1800000 0>;
+	};
+
 	ethernet@18000000 {
 		compatible = "smsc,lan9220", "smsc,lan9115";
 		reg = <0x18000000 0x100>;
@@ -243,6 +256,7 @@ 
 	pinctrl-names = "default";
 
 	vmmc-supply = <&fixedregulator3v3>;
+	vqmmc-supply = <&vccq_sdhi0>;
 	bus-width = <4>;
 	status = "okay";
 };