| Message ID | 2c6313a3f7c04b70b8a06a50934fe27a@SRV177.busymouse24.de (mailing list archive) |
|---|---|
| State | Superseded |
| Headers | show |
| Series | [Bug] altera_cvp registers a PCI device (Altera/Intel FPGA) without verifying that it supports CVP | expand |
Hi Andreas, On Fri, Oct 19, 2018 at 03:53:02PM +0000, Andreas Puhm wrote: > Hello, > > I hope the following information is descriptive enough. > If this is no the case, I will provide further details. > > -------------------------------------------------------------------- > Full description: > The altera_cvp probe function only checks, > if the Altera/Intel PCI device configuration space contains a vendor specific entry (VSEC Capability Header 0x000b) at offset 0x200. > But the probe function does not verify, if the PCI device (and further the FPGA), > for which it has been called, actually supports the Configure-via-Protocol feature. > > The PCI device (FPGA) can explicitly disable the Configur-via-Protocol (CvP) feature by setting the CVP_EN bit, index 20 of CVP_STATUS register, to '0'. > As the altera_cvp probe function does not check this it registers the device in any way. > At this point, the altera_cvp module cannot be used to program this device via CvP. > In addition no other module can use the device, as it is still registered by altera_cvp. > > Keywords: altera_cvp module, PCI, Configure-via-Protocol > > Kernel version: problem occured with v4.15, should occur from 4.14+ > > Instructions to reproduce: > Proper hardware is necessary to reproduce this, i.e., FPGA with instantiated Altera/Intel PCIe IP Core with disabled CvP feature. > > Workaround: > It is possible to circumvent this problem by manually unloading or blacklisting the altera_cvp module. > > Suggested Patch: > This patch was successfully build and tested for 4.15 and 4.18 > > Subject: [PATCH] register device only, if it supports CvP operation Could you make this: 'fpga: altera_cvp: Conditionalize registration' or something along those lines? > > This patch is based on: git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tag/?h=v4.18 Put some of the extensive description you made above in the git commit message, please, such that future us will know why the change was made :) Thanks for your patch, Moritz
diff --git a/drivers/fpga/altera-cvp.c b/drivers/fpga/altera-cvp.c index 7fa793672a7a..838abcfca0fb 100644 --- a/drivers/fpga/altera-cvp.c +++ b/drivers/fpga/altera-cvp.c @@ -403,6 +403,7 @@ static int altera_cvp_probe(struct pci_dev *pdev, struct altera_cvp_conf *conf; struct fpga_manager *mgr; u16 cmd, val; + u32 val32; int ret; /* @@ -416,6 +417,14 @@ static int altera_cvp_probe(struct pci_dev *pdev, return -ENODEV; } + pci_read_config_dword(pdev, VSE_CVP_STATUS, &val32); + if (!(val32 & VSE_CVP_STATUS_CVP_EN)) { + dev_err(&pdev->dev, + "CVP is disabled for this device: CVP_STATUS Reg 0x%x\n", + val32); + return -ENODEV; + } + conf = devm_kzalloc(&pdev->dev, sizeof(*conf), GFP_KERNEL); if (!conf) return -ENOMEM;
Hello, I hope the following information is descriptive enough. If this is no the case, I will provide further details. -------------------------------------------------------------------- Full description: The altera_cvp probe function only checks, if the Altera/Intel PCI device configuration space contains a vendor specific entry (VSEC Capability Header 0x000b) at offset 0x200. But the probe function does not verify, if the PCI device (and further the FPGA), for which it has been called, actually supports the Configure-via-Protocol feature. The PCI device (FPGA) can explicitly disable the Configur-via-Protocol (CvP) feature by setting the CVP_EN bit, index 20 of CVP_STATUS register, to '0'. As the altera_cvp probe function does not check this it registers the device in any way. At this point, the altera_cvp module cannot be used to program this device via CvP. In addition no other module can use the device, as it is still registered by altera_cvp. Keywords: altera_cvp module, PCI, Configure-via-Protocol Kernel version: problem occured with v4.15, should occur from 4.14+ Instructions to reproduce: Proper hardware is necessary to reproduce this, i.e., FPGA with instantiated Altera/Intel PCIe IP Core with disabled CvP feature. Workaround: It is possible to circumvent this problem by manually unloading or blacklisting the altera_cvp module. Suggested Patch: This patch was successfully build and tested for 4.15 and 4.18 Subject: [PATCH] register device only, if it supports CvP operation This patch is based on: git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tag/?h=v4.18 Signed-off-by: Andreas Puhm <puhm@oregano.at> --- drivers/fpga/altera-cvp.c | 9 +++++++++ 1 file changed, 9 insertions(+) -- With best regards, Andreas Puhm <puhm@oregano.at>