@@ -9849,6 +9849,11 @@ F: drivers/media/platform/meson/ao-cec.c
F: Documentation/devicetree/bindings/media/meson-ao-cec.txt
T: git git://linuxtv.org/media_tree.git
+METHODE UDPU SUPPORT
+M: Vladimir Vid <vladimir.vid@sartura.hr>
+S: Maintained
+F: arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts
+
MICROBLAZE ARCHITECTURE
M: Michal Simek <monstr@monstr.eu>
W: http://www.monstr.eu/fdt/
@@ -2,6 +2,7 @@
# Mvebu SoC Family
dtb-$(CONFIG_ARCH_MVEBU) += armada-3720-db.dtb
dtb-$(CONFIG_ARCH_MVEBU) += armada-3720-espressobin.dtb
+dtb-$(CONFIG_ARCH_MVEBU) += armada-3720-uDPU.dtb
dtb-$(CONFIG_ARCH_MVEBU) += armada-7040-db.dtb
dtb-$(CONFIG_ARCH_MVEBU) += armada-8040-clearfog-gt-8k.dtb
dtb-$(CONFIG_ARCH_MVEBU) += armada-8040-db.dtb
new file mode 100644
@@ -0,0 +1,178 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Device tree for the uDPU board.
+ * Based on Marvell Armada 3720 development board (DB-88F3720-DDR3)
+ * Copyright (C) 2016 Marvell
+ * Copyright (C) 2018 Methode
+ * Copyright (C) 2018 Telus
+ *
+ * Vladimir Vid <vladimir.vid@sartura.hr>
+ */
+
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include "armada-372x.dtsi"
+
+/ {
+ model = "Methode uDPU Board";
+ compatible = "marvell,armada-3720-db", "marvell,armada3720",
+ "marvell,armada3710";
+
+ chosen {
+ stdout-path = "serial0:115200n8";
+ };
+
+ memory@0 {
+ device_type = "memory";
+ reg = <0x00000000 0x00000000 0x00000000 0x20000000>;
+ };
+
+ leds {
+ pinctrl-names = "default";
+ compatible = "gpio-leds";
+
+ led@487 {
+ gpios = <&gpionb 11 GPIO_ACTIVE_LOW>;
+ default-state = "off";
+ };
+
+ led@488 {
+ gpios = <&gpionb 12 GPIO_ACTIVE_HIGH>;
+ default-state = "off";
+ };
+
+ led@489 {
+ gpios = <&gpionb 13 GPIO_ACTIVE_HIGH>;
+ default-state = "off";
+ };
+
+ led@490 {
+ gpios = <&gpionb 14 GPIO_ACTIVE_HIGH>;
+ default-state = "off";
+ };
+
+ led@491 {
+ gpios = <&gpionb 15 GPIO_ACTIVE_HIGH>;
+ default-state = "off";
+ };
+
+ led@492 {
+ gpios = <&gpionb 16 GPIO_ACTIVE_HIGH>;
+ default-state = "off";
+ };
+ };
+
+ sfp_eth0: sfp-eth0 {
+ compatible = "sff,sfp";
+ i2c-bus = <&i2c0>;
+ los-gpio = <&gpiosb 2 GPIO_ACTIVE_HIGH>;
+ mod-def0-gpio = <&gpiosb 3 GPIO_ACTIVE_LOW>;
+ tx-disable-gpio = <&gpiosb 4 GPIO_ACTIVE_HIGH>;
+ tx-fault-gpio = <&gpiosb 5 GPIO_ACTIVE_HIGH>;
+ };
+
+ sfp_eth1: sfp-eth1 {
+ compatible = "sff,sfp";
+ i2c-bus = <&i2c1>;
+ los-gpio = <&gpiosb 7 GPIO_ACTIVE_HIGH>;
+ mod-def0-gpio = <&gpiosb 8 GPIO_ACTIVE_LOW>;
+ tx-disable-gpio = <&gpiosb 9 GPIO_ACTIVE_HIGH>;
+ tx-fault-gpio = <&gpiosb 10 GPIO_ACTIVE_HIGH>;
+ };
+};
+
+&sdhci0 {
+ non-removable;
+ bus-width = <8>;
+ mmc-ddr-1_8v;
+ mmc-hs400-1_8v;
+ marvell,pad-type = "fixed-1-8v";
+ status = "okay";
+};
+
+&sdhci1 {
+ marvell,xenon-phy-type = "emmc 5.0 phy";
+ cd-gpios = <&gpiosb 2 GPIO_ACTIVE_LOW>;
+ bus-width = <4>;
+ marvell,pad-type = "fixed-1-8v";
+ status = "okay";
+ non-removable;
+ no-sd;
+ no-sdio;
+};
+
+&mdio {
+ status = "okay";
+ phy0: ethernet-phy@0 {
+ reg = <0>;
+ };
+ phy1: ethernet-phy@1 {
+ reg = <1>;
+ };
+};
+
+&spi0 {
+ status = "okay";
+ pinctrl-names = "default";
+ pinctrl-0 = <&spi_quad_pins>;
+
+ m25p80@0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ spi-max-frequency = <54000000>;
+
+ /* bootloader is located on the SPI */
+ partition@0 {
+ label = "uboot";
+ reg = <0 0x400000>;
+ };
+ };
+};
+
+&usb3 {
+ status = "okay";
+ usb-phy = <&usb3_phy>;
+};
+
+&i2c0 {
+ status = "okay";
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2c1_pins>;
+
+ eeprom@50 {
+ compatible = "atmel,24c04";
+ reg = <0x50>;
+ };
+};
+
+&i2c1 {
+ status = "okay";
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2c2_pins>;
+
+ eeprom@50 {
+ compatible = "atmel,24c04";
+ reg = <0x50>;
+ };
+};
+
+ð0 {
+ phy-mode = "sgmii";
+ status = "okay";
+ managed = "in-band-status";
+ sfp = <&sfp_eth0>;
+};
+
+ð1 {
+ phy-mode = "sgmii";
+ status = "okay";
+ managed = "in-band-status";
+ sfp = <&sfp_eth1>;
+};
+
+&uart0 {
+ status = "okay";
+};
This adds initial support for micro-DPU (uDPU) board which is based on Armada-3720 SoC. micro-DPU is the single-port FTTdp distribution point unit made by Methode Electronics which offers complete modularity with replaceable SFP modules both for uplink and downlink (G.hn over twisted-pair, G.hn over coax, 1G and 2.5G Ethernet over Cat-5e cable). On-board features: - 512 MiB DDR3 - 2 x 2.5G SFP via HSGMII SERDES interface to the A3720 SoC - USB 2.0 Type-C connector - 4GB eMMC - ETSI TS 101548 reverse powering via twisted pair (RJ45) or coax (F Type) Cc: Luka Perkov <luka.perkov@sartura.hr> Cc: Luis Torres <luis.torres@methode.com> Cc: Scott Roberts <scott.roberts@telus.com> Cc: Paul Arola <paul.arola@telus.com> Cc: linux-arm-kernel@lists.infradead.org Signed-off-by: Vladimir Vid <vladimir.vid@sartura.hr> --- MAINTAINERS | 5 + arch/arm64/boot/dts/marvell/Makefile | 1 + .../boot/dts/marvell/armada-3720-uDPU.dts | 178 ++++++++++++++++++ 3 files changed, 184 insertions(+) create mode 100644 arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts