diff mbox series

[v3,3/6] dt-bindings: fix incorrect bmi160 IRQ note

Message ID 20190127203911.8696-4-martin@martingkelly.com (mailing list archive)
State New, archived
Headers show
Series iio:bmi160: add drdy interrupt support | expand

Commit Message

Martin Kelly Jan. 27, 2019, 8:39 p.m. UTC 
From: Martin Kelly <martin@martingkelly.com>

The bmi160 bindings say that the BMI160 requires level-triggered,
active-low interrupts, but it actually supports all interrupt types, so fix
the note to reflect that.

Signed-off-by: Martin Kelly <martin@martingkelly.com>
---
 Documentation/devicetree/bindings/iio/imu/bmi160.txt | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

Comments

Rob Herring (Arm) Jan. 30, 2019, 4:56 p.m. UTC | #1 
On Sun, 27 Jan 2019 12:39:08 -0800, Martin Kelly wrote:
> From: Martin Kelly <martin@martingkelly.com>
> 
> The bmi160 bindings say that the BMI160 requires level-triggered,
> active-low interrupts, but it actually supports all interrupt types, so fix
> the note to reflect that.
> 
> Signed-off-by: Martin Kelly <martin@martingkelly.com>
> ---
>  Documentation/devicetree/bindings/iio/imu/bmi160.txt | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 

Reviewed-by: Rob Herring <robh@kernel.org>
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/iio/imu/bmi160.txt b/Documentation/devicetree/bindings/iio/imu/bmi160.txt
index 0c1c105fb503..1aec19997fb5 100644
--- a/Documentation/devicetree/bindings/iio/imu/bmi160.txt
+++ b/Documentation/devicetree/bindings/iio/imu/bmi160.txt
@@ -9,7 +9,7 @@  Required properties:
  - spi-max-frequency : set maximum clock frequency (only for SPI)
 
 Optional properties:
- - interrupts : interrupt mapping for IRQ, must be IRQ_TYPE_LEVEL_LOW
+ - interrupts : interrupt mapping for IRQ
  - interrupt-names : set to "INT1" if INT1 pin should be used as interrupt
    input, set to "INT2" if INT2 pin should be used instead
 
@@ -20,7 +20,7 @@  bmi160@68 {
 	reg = <0x68>;
 
 	interrupt-parent = <&gpio4>;
-	interrupts = <12 IRQ_TYPE_LEVEL_LOW>;
+	interrupts = <12 IRQ_TYPE_EDGE_RISING>;
 	interrupt-names = "INT1";
 };