diff mbox series

[v5,4/5] usb: host: Stops USB controller init if PLL fails to lock

Message ID 20190508060608.33882-4-yinbo.zhu@nxp.com (mailing list archive)
State Superseded
Headers show
Series [v5,1/5] usb: fsl: Set USB_EN bit to select ULPI phy | expand

Commit Message

Yinbo Zhu May 8, 2019, 6:04 a.m. UTC
From: Ramneek Mehresh <ramneek.mehresh@freescale.com>

USB erratum-A006918 workaround tries to start internal PHY inside
uboot (when PLL fails to lock). However, if the workaround also
fails, then USB initialization is also stopped inside Linux.
Erratum-A006918 workaround failure creates "fsl,erratum_a006918"
node in device-tree. Presence of this node in device-tree is
used to stop USB controller initialization in Linux

Signed-off-by: Ramneek Mehresh <ramneek.mehresh@freescale.com>
Signed-off-by: Suresh Gupta <suresh.gupta@freescale.com>
Signed-off-by: Yinbo Zhu <yinbo.zhu@nxp.com>
---
Change in v5:
		use dev_warn() instead of pr_warn()

 drivers/usb/host/ehci-fsl.c      |    5 +++++
 drivers/usb/host/fsl-mph-dr-of.c |    3 ++-
 2 files changed, 7 insertions(+), 1 deletions(-)

Comments

Alan Stern May 8, 2019, 4:50 p.m. UTC | #1
On Wed, 8 May 2019, Yinbo Zhu wrote:

> From: Ramneek Mehresh <ramneek.mehresh@freescale.com>
> 
> USB erratum-A006918 workaround tries to start internal PHY inside
> uboot (when PLL fails to lock). However, if the workaround also
> fails, then USB initialization is also stopped inside Linux.
> Erratum-A006918 workaround failure creates "fsl,erratum_a006918"
> node in device-tree. Presence of this node in device-tree is
> used to stop USB controller initialization in Linux
> 
> Signed-off-by: Ramneek Mehresh <ramneek.mehresh@freescale.com>
> Signed-off-by: Suresh Gupta <suresh.gupta@freescale.com>
> Signed-off-by: Yinbo Zhu <yinbo.zhu@nxp.com>
> ---
> Change in v5:
> 		use dev_warn() instead of pr_warn()
> 
>  drivers/usb/host/ehci-fsl.c      |    5 +++++
>  drivers/usb/host/fsl-mph-dr-of.c |    3 ++-
>  2 files changed, 7 insertions(+), 1 deletions(-)
> 
> diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
> index 1634ac8..90550a6 100644
> --- a/drivers/usb/host/ehci-fsl.c
> +++ b/drivers/usb/host/ehci-fsl.c
> @@ -236,6 +236,11 @@ static int ehci_fsl_setup_phy(struct usb_hcd *hcd,
>  		portsc |= PORT_PTS_PTW;
>  		/* fall through */
>  	case FSL_USB2_PHY_UTMI:
> +		if (pdata->has_fsl_erratum_a006918) {
> +			dev_warn(dev, "USB PHY clock invalid\n");
> +			return -EINVAL;
> +		}
> +

You need to add a "Fall through" comment between these two cases.

>  	case FSL_USB2_PHY_UTMI_DUAL:
>  		/* PHY_CLK_VALID bit is de-featured from all controller
>  		 * versions below 2.4 and is to be checked only for

Alan Stern
Yinbo Zhu May 9, 2019, 3:58 a.m. UTC | #2
> -----Original Message-----
> From: Alan Stern [mailto:stern@rowland.harvard.edu]
> Sent: 2019年5月9日 0:50
> To: Yinbo Zhu <yinbo.zhu@nxp.com>
> Cc: Xiaobo Xie <xiaobo.xie@nxp.com>; Greg Kroah-Hartman
> <gregkh@linuxfoundation.org>; Ramneek Mehresh
> <ramneek.mehresh@freescale.com>; Nikhil Badola
> <nikhil.badola@freescale.com>; Ran Wang <ran.wang_1@nxp.com>;
> linux-usb@vger.kernel.org; linux-kernel@vger.kernel.org; Jiafei Pan
> <jiafei.pan@nxp.com>; Suresh Gupta <suresh.gupta@freescale.com>
> Subject: [EXT] Re: [PATCH v5 4/5] usb: host: Stops USB controller init if PLL fails to
> lock
> 
> Caution: EXT Email
> 
> On Wed, 8 May 2019, Yinbo Zhu wrote:
> 
> > From: Ramneek Mehresh <ramneek.mehresh@freescale.com>
> >
> > USB erratum-A006918 workaround tries to start internal PHY inside
> > uboot (when PLL fails to lock). However, if the workaround also fails,
> > then USB initialization is also stopped inside Linux.
> > Erratum-A006918 workaround failure creates "fsl,erratum_a006918"
> > node in device-tree. Presence of this node in device-tree is used to
> > stop USB controller initialization in Linux
> >
> > Signed-off-by: Ramneek Mehresh <ramneek.mehresh@freescale.com>
> > Signed-off-by: Suresh Gupta <suresh.gupta@freescale.com>
> > Signed-off-by: Yinbo Zhu <yinbo.zhu@nxp.com>
> > ---
> > Change in v5:
> >               use dev_warn() instead of pr_warn()
> >
> >  drivers/usb/host/ehci-fsl.c      |    5 +++++
> >  drivers/usb/host/fsl-mph-dr-of.c |    3 ++-
> >  2 files changed, 7 insertions(+), 1 deletions(-)
> >
> > diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
> > index 1634ac8..90550a6 100644
> > --- a/drivers/usb/host/ehci-fsl.c
> > +++ b/drivers/usb/host/ehci-fsl.c
> > @@ -236,6 +236,11 @@ static int ehci_fsl_setup_phy(struct usb_hcd *hcd,
> >               portsc |= PORT_PTS_PTW;
> >               /* fall through */
> >       case FSL_USB2_PHY_UTMI:
> > +             if (pdata->has_fsl_erratum_a006918) {
> > +                     dev_warn(dev, "USB PHY clock invalid\n");
> > +                     return -EINVAL;
> > +             }
> > +
> 
> You need to add a "Fall through" comment between these two cases.
> >       case FSL_USB2_PHY_UTMI_DUAL:
> >               /* PHY_CLK_VALID bit is de-featured from all controller
> >                * versions below 2.4 and is to be checked only for
> 
> Alan Stern
Hi Alan Stern,

Your meaning is to remove "/* fall through*/" or add the erratum commont replace "/* fall through*/"

Regards,
Yinbo
diff mbox series

Patch

diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
index 1634ac8..90550a6 100644
--- a/drivers/usb/host/ehci-fsl.c
+++ b/drivers/usb/host/ehci-fsl.c
@@ -236,6 +236,11 @@  static int ehci_fsl_setup_phy(struct usb_hcd *hcd,
 		portsc |= PORT_PTS_PTW;
 		/* fall through */
 	case FSL_USB2_PHY_UTMI:
+		if (pdata->has_fsl_erratum_a006918) {
+			dev_warn(dev, "USB PHY clock invalid\n");
+			return -EINVAL;
+		}
+
 	case FSL_USB2_PHY_UTMI_DUAL:
 		/* PHY_CLK_VALID bit is de-featured from all controller
 		 * versions below 2.4 and is to be checked only for
diff --git a/drivers/usb/host/fsl-mph-dr-of.c b/drivers/usb/host/fsl-mph-dr-of.c
index 4f8b8a0..762b976 100644
--- a/drivers/usb/host/fsl-mph-dr-of.c
+++ b/drivers/usb/host/fsl-mph-dr-of.c
@@ -224,13 +224,14 @@  static int fsl_usb2_mph_dr_of_probe(struct platform_device *ofdev)
 		of_property_read_bool(np, "fsl,usb-erratum-a005275");
 	pdata->has_fsl_erratum_a005697 =
 		of_property_read_bool(np, "fsl,usb_erratum-a005697");
+	pdata->has_fsl_erratum_a006918 =
+		of_property_read_bool(np, "fsl,usb_erratum-a006918");
 
 	if (of_get_property(np, "fsl,usb_erratum_14", NULL))
 		pdata->has_fsl_erratum_14 = 1;
 	else
 		pdata->has_fsl_erratum_14 = 0;
 
-
 	/*
 	 * Determine whether phy_clk_valid needs to be checked
 	 * by reading property in device tree