@@ -20,7 +20,7 @@ if NET_VENDOR_ATHEROS
config AG71XX
tristate "Atheros AR7XXX/AR9XXX built-in ethernet mac support"
depends on ATH79
- select PHYLIB
+ select PHYLINK
help
If you wish to compile a kernel for AR7XXX/91XXX and enable
ethernet support, then you should always answer Y to this.
@@ -32,6 +32,7 @@
#include <linux/of_mdio.h>
#include <linux/of_net.h>
#include <linux/of_platform.h>
+#include <linux/phylink.h>
#include <linux/regmap.h>
#include <linux/reset.h>
#include <linux/clk.h>
@@ -314,6 +315,8 @@ struct ag71xx {
dma_addr_t stop_desc_dma;
int phy_if_mode;
+ struct phylink *phylink;
+ struct phylink_config phylink_config;
struct delayed_work restart_work;
struct timer_list oom_timer;
@@ -845,24 +848,20 @@ static void ag71xx_hw_start(struct ag71xx *ag)
netif_wake_queue(ag->ndev);
}
-static void ag71xx_link_adjust(struct ag71xx *ag, bool update)
+static void ag71xx_mac_config(struct phylink_config *config, unsigned int mode,
+ const struct phylink_link_state *state)
{
- struct phy_device *phydev = ag->ndev->phydev;
+ struct ag71xx *ag = netdev_priv(to_net_dev(config->dev));
u32 cfg2;
u32 ifctl;
u32 fifo5;
- if (!phydev->link && update) {
- ag71xx_hw_stop(ag);
- return;
- }
-
if (!ag71xx_is(ag, AR7100) && !ag71xx_is(ag, AR9130))
ag71xx_fast_reset(ag);
cfg2 = ag71xx_rr(ag, AG71XX_REG_MAC_CFG2);
cfg2 &= ~(MAC_CFG2_IF_1000 | MAC_CFG2_IF_10_100 | MAC_CFG2_FDX);
- cfg2 |= (phydev->duplex) ? MAC_CFG2_FDX : 0;
+ cfg2 |= (state->duplex) ? MAC_CFG2_FDX : 0;
ifctl = ag71xx_rr(ag, AG71XX_REG_MAC_IFCTL);
ifctl &= ~(MAC_IFCTL_SPEED);
@@ -870,7 +869,7 @@ static void ag71xx_link_adjust(struct ag71xx *ag, bool update)
fifo5 = ag71xx_rr(ag, AG71XX_REG_FIFO_CFG5);
fifo5 &= ~FIFO_CFG5_BM;
- switch (phydev->speed) {
+ switch (state->speed) {
case SPEED_1000:
cfg2 |= MAC_CFG2_IF_1000;
fifo5 |= FIFO_CFG5_BM;
@@ -883,7 +882,6 @@ static void ag71xx_link_adjust(struct ag71xx *ag, bool update)
cfg2 |= MAC_CFG2_IF_10_100;
break;
default:
- WARN(1, "not supported speed %i\n", phydev->speed);
return;
}
@@ -897,58 +895,76 @@ static void ag71xx_link_adjust(struct ag71xx *ag, bool update)
ag71xx_wr(ag, AG71XX_REG_MAC_CFG2, cfg2);
ag71xx_wr(ag, AG71XX_REG_FIFO_CFG5, fifo5);
ag71xx_wr(ag, AG71XX_REG_MAC_IFCTL, ifctl);
-
- ag71xx_hw_start(ag);
-
- if (update)
- phy_print_status(phydev);
}
-static void ag71xx_phy_link_adjust(struct net_device *ndev)
+static void ag71xx_mac_validate(struct phylink_config *config,
+ unsigned long *supported,
+ struct phylink_link_state *state)
{
- struct ag71xx *ag = netdev_priv(ndev);
+ __ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
+
+ if (state->interface != PHY_INTERFACE_MODE_NA &&
+ state->interface != PHY_INTERFACE_MODE_GMII &&
+ state->interface != PHY_INTERFACE_MODE_MII) {
+ bitmap_zero(supported, __ETHTOOL_LINK_MODE_MASK_NBITS);
+ return;
+ }
+
+ phylink_set(mask, MII);
+
+ /* flow control is not supported */
- ag71xx_link_adjust(ag, true);
+ phylink_set(mask, 10baseT_Half);
+ phylink_set(mask, 10baseT_Full);
+ phylink_set(mask, 100baseT_Half);
+ phylink_set(mask, 100baseT_Full);
+
+ phylink_set(mask, 1000baseT_Full);
+ phylink_set(mask, 1000baseX_Full);
+
+ bitmap_and(supported, supported, mask,
+ __ETHTOOL_LINK_MODE_MASK_NBITS);
+ bitmap_and(state->advertising, state->advertising, mask,
+ __ETHTOOL_LINK_MODE_MASK_NBITS);
}
-static int ag71xx_phy_connect(struct ag71xx *ag)
+static void ag71xx_mac_link_down(struct phylink_config *config,
+ unsigned int mode, phy_interface_t interface)
{
- struct device_node *np = ag->pdev->dev.of_node;
- struct net_device *ndev = ag->ndev;
- struct device_node *phy_node;
- struct phy_device *phydev;
- int ret;
+ struct ag71xx *ag = netdev_priv(to_net_dev(config->dev));
- if (of_phy_is_fixed_link(np)) {
- ret = of_phy_register_fixed_link(np);
- if (ret < 0) {
- netif_err(ag, probe, ndev, "Failed to register fixed PHY link: %d\n",
- ret);
- return ret;
- }
+ ag71xx_hw_stop(ag);
+}
- phy_node = of_node_get(np);
- } else {
- phy_node = of_parse_phandle(np, "phy-handle", 0);
- }
+static void ag71xx_mac_link_up(struct phylink_config *config, unsigned int mode,
+ phy_interface_t interface,
+ struct phy_device *phy)
+{
+ struct ag71xx *ag = netdev_priv(to_net_dev(config->dev));
- if (!phy_node) {
- netif_err(ag, probe, ndev, "Could not find valid phy node\n");
- return -ENODEV;
- }
+ ag71xx_hw_start(ag);
+}
- phydev = of_phy_connect(ag->ndev, phy_node, ag71xx_phy_link_adjust,
- 0, ag->phy_if_mode);
+static const struct phylink_mac_ops ag71xx_phylink_mac_ops = {
+ .validate = ag71xx_mac_validate,
+ .mac_config = ag71xx_mac_config,
+ .mac_link_down = ag71xx_mac_link_down,
+ .mac_link_up = ag71xx_mac_link_up,
+};
- of_node_put(phy_node);
+static int ag71xx_phy_setup(struct ag71xx *ag)
+{
+ struct phylink *phylink;
- if (!phydev) {
- netif_err(ag, probe, ndev, "Could not connect to PHY device\n");
- return -ENODEV;
- }
+ ag->phylink_config.dev = &ag->ndev->dev;
+ ag->phylink_config.type = PHYLINK_NETDEV;
- phy_attached_info(phydev);
+ phylink = phylink_create(&ag->phylink_config, ag->pdev->dev.fwnode,
+ ag->phy_if_mode, &ag71xx_phylink_mac_ops);
+ if (IS_ERR(phylink))
+ return PTR_ERR(phylink);
+ ag->phylink = phylink;
return 0;
}
@@ -1239,6 +1255,13 @@ static int ag71xx_open(struct net_device *ndev)
unsigned int max_frame_len;
int ret;
+ ret = phylink_of_phy_connect(ag->phylink, ag->pdev->dev.of_node, 0);
+ if (ret) {
+ netif_info(ag, link, ndev, "phylink_of_phy_connect filed with err: %i\n",
+ ret);
+ goto err;
+ }
+
max_frame_len = ag71xx_max_frame_len(ndev->mtu);
ag->rx_buf_size =
SKB_DATA_ALIGN(max_frame_len + NET_SKB_PAD + NET_IP_ALIGN);
@@ -1251,11 +1274,7 @@ static int ag71xx_open(struct net_device *ndev)
if (ret)
goto err;
- ret = ag71xx_phy_connect(ag);
- if (ret)
- goto err;
-
- phy_start(ndev->phydev);
+ phylink_start(ag->phylink);
return 0;
@@ -1268,8 +1287,7 @@ static int ag71xx_stop(struct net_device *ndev)
{
struct ag71xx *ag = netdev_priv(ndev);
- phy_stop(ndev->phydev);
- phy_disconnect(ndev->phydev);
+ phylink_stop(ag->phylink);
ag71xx_hw_disable(ag);
return 0;
@@ -1396,10 +1414,9 @@ static netdev_tx_t ag71xx_hard_start_xmit(struct sk_buff *skb,
static int ag71xx_do_ioctl(struct net_device *ndev, struct ifreq *ifr, int cmd)
{
- if (!ndev->phydev)
- return -EINVAL;
+ struct ag71xx *ag = netdev_priv(ndev);
- return phy_mii_ioctl(ndev->phydev, ifr, cmd);
+ return phylink_mii_ioctl(ag->phylink, ifr, cmd);
}
static void ag71xx_oom_timer_handler(struct timer_list *t)
@@ -1422,13 +1439,14 @@ static void ag71xx_restart_work_func(struct work_struct *work)
{
struct ag71xx *ag = container_of(work, struct ag71xx,
restart_work.work);
- struct net_device *ndev = ag->ndev;
rtnl_lock();
ag71xx_hw_disable(ag);
ag71xx_hw_enable(ag);
- if (ndev->phydev->link)
- ag71xx_link_adjust(ag, false);
+
+ phylink_stop(ag->phylink);
+ phylink_start(ag->phylink);
+
rtnl_unlock();
}
@@ -1769,6 +1787,12 @@ static int ag71xx_probe(struct platform_device *pdev)
platform_set_drvdata(pdev, ndev);
+ err = ag71xx_phy_setup(ag);
+ if (err) {
+ netif_err(ag, probe, ndev, "failed to setup phy (%d)\n", err);
+ goto err_mdio_remove;
+ }
+
err = register_netdev(ndev);
if (err) {
netif_err(ag, probe, ndev, "unable to register net device\n");
The port to phylink was done as close as possible to initial functionality. Theoretically this HW can support flow control, practically seems to be not enough to just enable it. So, more work should be done. Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de> --- drivers/net/ethernet/atheros/Kconfig | 2 +- drivers/net/ethernet/atheros/ag71xx.c | 144 +++++++++++++++----------- 2 files changed, 85 insertions(+), 61 deletions(-)