| Message ID | 20200414225029.709-1-vishal.l.verma@intel.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | [v2] mm/memory_hotplug: refrain from adding memory into an impossible node | expand |
On Tue, Apr 14, 2020 at 3:50 PM Vishal Verma <vishal.l.verma@intel.com> wrote: > > A misbehaving qemu created a situation where the ACPI SRAT table > advertised one fewer proximity domains than intended. The NFIT table did > describe all the expected proximity domains. This caused the device dax > driver to assign an impossible target_node to the device, and when > hotplugged as system memory, this would fail with the following > signature: > > [ +0.001627] BUG: kernel NULL pointer dereference, address: 0000000000000088 > [ +0.001331] #PF: supervisor read access in kernel mode > [ +0.000975] #PF: error_code(0x0000) - not-present page > [ +0.000976] PGD 80000001767d4067 P4D 80000001767d4067 PUD 10e0c4067 PMD 0 > [ +0.001338] Oops: 0000 [#1] SMP PTI > [ +0.000676] CPU: 4 PID: 22737 Comm: kswapd3 Tainted: G O 5.6.0-rc5 #9 > [ +0.001457] Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), > BIOS rel-1.13.0-0-gf21b5a4aeb02-prebuilt.qemu.org 04/01/2014 > [ +0.001990] RIP: 0010:prepare_kswapd_sleep+0x7c/0xc0 > [ +0.000780] Code: 89 df e8 87 fd ff ff 89 c2 31 c0 84 d2 74 e6 0f 1f 44 > 00 00 48 8b 05 fb af 7a 01 48 63 93 88 1d 01 00 48 8b > 84 d0 20 0f 00 00 <48> 3b 98 88 00 00 00 75 28 f0 80 a0 > 80 00 00 00 fe f0 80 a3 38 20 > [ +0.002877] RSP: 0018:ffffc900017a3e78 EFLAGS: 00010202 > [ +0.000805] RAX: 0000000000000000 RBX: ffff8881209e0000 RCX: 0000000000000000 > [ +0.001115] RDX: 0000000000000003 RSI: 0000000000000000 RDI: ffff8881209e0e80 > [ +0.001098] RBP: 0000000000000000 R08: 0000000000000000 R09: 0000000000008000 > [ +0.001092] R10: 0000000000000000 R11: 0000000000000003 R12: 0000000000000003 > [ +0.001092] R13: 0000000000000003 R14: 0000000000000000 R15: ffffc900017a3ec8 > [ +0.001091] FS: 0000000000000000(0000) GS:ffff888318c00000(0000) knlGS:0000000000000000 > [ +0.001275] CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 > [ +0.000882] CR2: 0000000000000088 CR3: 0000000120b50002 CR4: 00000000001606e0 > [ +0.001095] Call Trace: > [ +0.000388] kswapd+0x103/0x520 > [ +0.000494] ? finish_wait+0x80/0x80 > [ +0.000547] ? balance_pgdat+0x5a0/0x5a0 > [ +0.000607] kthread+0x120/0x140 > [ +0.000508] ? kthread_create_on_node+0x60/0x60 > [ +0.000706] ret_from_fork+0x3a/0x50 > > Add a check in the add_memory path to ensure that the node to which we > are adding memory is in the node_possible_map > > Cc: David Hildenbrand <david@redhat.com> > Cc: Dan Williams <dan.j.williams@intel.com> > Cc: Dave Hansen <dave.hansen@linux.intel.com> > Signed-off-by: Vishal Verma <vishal.l.verma@intel.com> > --- > mm/memory_hotplug.c | 26 ++++++++++++++++++++++++++ > 1 file changed, 26 insertions(+) > > v2: > - Centralize the check in the add_memory path (David) > - Instead of failing, add the memory to a nearby node, while warning > (and tainting) to call out attention to the firmware bug (Dan) > > diff --git a/mm/memory_hotplug.c b/mm/memory_hotplug.c > index 0a54ffac8c68..022df38a5d8a 100644 > --- a/mm/memory_hotplug.c > +++ b/mm/memory_hotplug.c > @@ -980,6 +980,28 @@ static int check_hotplug_memory_range(u64 start, u64 size) > return 0; > } > > +/* > + * Check that the node provided for adding memory was valid. > + * If not, find the nearest valid node and add the memory there while > + * tainting the kernel and displaying a warning to bring attention to the > + * underlying firmware problem. > + * Return nid if valid, or an adjusted node number that can be used instead > + * if the original nid was not valid > + */ > +static int check_hotplug_node(int nid) > +{ > + int alt_nid; > + > + if (node_possible(nid)) > + return nid; > + > + alt_nid = numa_map_to_online_node(nid); > + WARN_TAINT(1, TAINT_FIRMWARE_WORKAROUND, > + "node %d expected, but was absent from the node_possible_map, using %d instead\n", > + nid, alt_nid); > + return alt_nid; > +} > + > static int online_memory_block(struct memory_block *mem, void *arg) > { > return device_online(&mem->dev); > @@ -1005,6 +1027,10 @@ int __ref add_memory_resource(int nid, struct resource *res) > if (ret) > return ret; > > + nid = check_hotplug_node(nid); > + if (nid < 0) > + return -ENXIO; > + It seems CONFIG_MEMORY_HOTPLUG does not require numa support, so numa_map_to_online_node() might legitimately return NUMA_NO_NODE. So perhaps this error return should be skipped in the CONFIG_NUMA=n case and just use 0 which is the decision that memory_add_physaddr_to_nid() takes.
diff --git a/mm/memory_hotplug.c b/mm/memory_hotplug.c index 0a54ffac8c68..022df38a5d8a 100644 --- a/mm/memory_hotplug.c +++ b/mm/memory_hotplug.c @@ -980,6 +980,28 @@ static int check_hotplug_memory_range(u64 start, u64 size) return 0; } +/* + * Check that the node provided for adding memory was valid. + * If not, find the nearest valid node and add the memory there while + * tainting the kernel and displaying a warning to bring attention to the + * underlying firmware problem. + * Return nid if valid, or an adjusted node number that can be used instead + * if the original nid was not valid + */ +static int check_hotplug_node(int nid) +{ + int alt_nid; + + if (node_possible(nid)) + return nid; + + alt_nid = numa_map_to_online_node(nid); + WARN_TAINT(1, TAINT_FIRMWARE_WORKAROUND, + "node %d expected, but was absent from the node_possible_map, using %d instead\n", + nid, alt_nid); + return alt_nid; +} + static int online_memory_block(struct memory_block *mem, void *arg) { return device_online(&mem->dev); @@ -1005,6 +1027,10 @@ int __ref add_memory_resource(int nid, struct resource *res) if (ret) return ret; + nid = check_hotplug_node(nid); + if (nid < 0) + return -ENXIO; + mem_hotplug_begin(); /*
A misbehaving qemu created a situation where the ACPI SRAT table advertised one fewer proximity domains than intended. The NFIT table did describe all the expected proximity domains. This caused the device dax driver to assign an impossible target_node to the device, and when hotplugged as system memory, this would fail with the following signature: [ +0.001627] BUG: kernel NULL pointer dereference, address: 0000000000000088 [ +0.001331] #PF: supervisor read access in kernel mode [ +0.000975] #PF: error_code(0x0000) - not-present page [ +0.000976] PGD 80000001767d4067 P4D 80000001767d4067 PUD 10e0c4067 PMD 0 [ +0.001338] Oops: 0000 [#1] SMP PTI [ +0.000676] CPU: 4 PID: 22737 Comm: kswapd3 Tainted: G O 5.6.0-rc5 #9 [ +0.001457] Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS rel-1.13.0-0-gf21b5a4aeb02-prebuilt.qemu.org 04/01/2014 [ +0.001990] RIP: 0010:prepare_kswapd_sleep+0x7c/0xc0 [ +0.000780] Code: 89 df e8 87 fd ff ff 89 c2 31 c0 84 d2 74 e6 0f 1f 44 00 00 48 8b 05 fb af 7a 01 48 63 93 88 1d 01 00 48 8b 84 d0 20 0f 00 00 <48> 3b 98 88 00 00 00 75 28 f0 80 a0 80 00 00 00 fe f0 80 a3 38 20 [ +0.002877] RSP: 0018:ffffc900017a3e78 EFLAGS: 00010202 [ +0.000805] RAX: 0000000000000000 RBX: ffff8881209e0000 RCX: 0000000000000000 [ +0.001115] RDX: 0000000000000003 RSI: 0000000000000000 RDI: ffff8881209e0e80 [ +0.001098] RBP: 0000000000000000 R08: 0000000000000000 R09: 0000000000008000 [ +0.001092] R10: 0000000000000000 R11: 0000000000000003 R12: 0000000000000003 [ +0.001092] R13: 0000000000000003 R14: 0000000000000000 R15: ffffc900017a3ec8 [ +0.001091] FS: 0000000000000000(0000) GS:ffff888318c00000(0000) knlGS:0000000000000000 [ +0.001275] CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 [ +0.000882] CR2: 0000000000000088 CR3: 0000000120b50002 CR4: 00000000001606e0 [ +0.001095] Call Trace: [ +0.000388] kswapd+0x103/0x520 [ +0.000494] ? finish_wait+0x80/0x80 [ +0.000547] ? balance_pgdat+0x5a0/0x5a0 [ +0.000607] kthread+0x120/0x140 [ +0.000508] ? kthread_create_on_node+0x60/0x60 [ +0.000706] ret_from_fork+0x3a/0x50 Add a check in the add_memory path to ensure that the node to which we are adding memory is in the node_possible_map Cc: David Hildenbrand <david@redhat.com> Cc: Dan Williams <dan.j.williams@intel.com> Cc: Dave Hansen <dave.hansen@linux.intel.com> Signed-off-by: Vishal Verma <vishal.l.verma@intel.com> --- mm/memory_hotplug.c | 26 ++++++++++++++++++++++++++ 1 file changed, 26 insertions(+) v2: - Centralize the check in the add_memory path (David) - Instead of failing, add the memory to a nearby node, while warning (and tainting) to call out attention to the firmware bug (Dan)