diff mbox series

[1/6] spi: stm32: fixes pm_runtime calls in probe/remove

Message ID 1625042723-661-2-git-send-email-alain.volmat@foss.st.com (mailing list archive)
State New, archived
Headers show
Series spi: stm32: various fixes & cleanup | expand

Commit Message

Alain Volmat June 30, 2021, 8:45 a.m. UTC 
the pm_runtime is not fully configured (delay not setted).
Add pm_runtime calls in probe/probe error path and remove
in order to be consistent in all places in ordering and
ensure that pm_runtime is disabled prior to resources used
by the SPI controller.

This patch also fixes the 2 following warnings on driver remove:
WARNING: CPU: 0 PID: 743 at drivers/clk/clk.c:594 clk_core_disable_lock+0x18/0x24
WARNING: CPU: 0 PID: 743 at drivers/clk/clk.c:476 clk_unprepare+0x24/0x2c

Fixes: 038ac869c9d2 ("spi: stm32: add runtime PM support")

Signed-off-by: Amelie Delaunay <amelie.delaunay@foss.st.com>
Signed-off-by: Alain Volmat <alain.volmat@foss.st.com>
---
 drivers/spi/spi-stm32.c | 20 +++++++++++++++++++-
 1 file changed, 19 insertions(+), 1 deletion(-)

Comments

Mark Brown June 30, 2021, 12:34 p.m. UTC | #1 
On Wed, Jun 30, 2021 at 10:45:18AM +0200, Alain Volmat wrote:

> +	pm_runtime_set_autosuspend_delay(&pdev->dev,
> +					 STM32_SPI_AUTOSUSPEND_DELAY);
> +	pm_runtime_use_autosuspend(&pdev->dev);

The driver wasn't using autosuspend at all prior to this patch so
there's no fix from that part of the change, the enabling of autosuspend
ought to be split out into a separate patch.
diff mbox series

Patch

diff --git a/drivers/spi/spi-stm32.c b/drivers/spi/spi-stm32.c
index 8ffcffbb8157..fe35c5cfb820 100644
--- a/drivers/spi/spi-stm32.c
+++ b/drivers/spi/spi-stm32.c
@@ -162,6 +162,8 @@ 
 #define SPI_3WIRE_TX		3
 #define SPI_3WIRE_RX		4
 
+#define STM32_SPI_AUTOSUSPEND_DELAY		1	/* 1 ms */
+
 /*
  * use PIO for small transfers, avoiding DMA setup/teardown overhead for drivers
  * without fifo buffers.
@@ -1924,7 +1926,11 @@  static int stm32_spi_probe(struct platform_device *pdev)
 	if (spi->dma_tx || spi->dma_rx)
 		master->can_dma = stm32_spi_can_dma;
 
+	pm_runtime_set_autosuspend_delay(&pdev->dev,
+					 STM32_SPI_AUTOSUSPEND_DELAY);
+	pm_runtime_use_autosuspend(&pdev->dev);
 	pm_runtime_set_active(&pdev->dev);
+	pm_runtime_get_noresume(&pdev->dev);
 	pm_runtime_enable(&pdev->dev);
 
 	ret = spi_register_master(master);
@@ -1934,12 +1940,18 @@  static int stm32_spi_probe(struct platform_device *pdev)
 		goto err_pm_disable;
 	}
 
+	pm_runtime_mark_last_busy(&pdev->dev);
+	pm_runtime_put_autosuspend(&pdev->dev);
+
 	dev_info(&pdev->dev, "driver initialized\n");
 
 	return 0;
 
 err_pm_disable:
 	pm_runtime_disable(&pdev->dev);
+	pm_runtime_put_noidle(&pdev->dev);
+	pm_runtime_set_suspended(&pdev->dev);
+	pm_runtime_dont_use_autosuspend(&pdev->dev);
 err_dma_release:
 	if (spi->dma_tx)
 		dma_release_channel(spi->dma_tx);
@@ -1956,9 +1968,16 @@  static int stm32_spi_remove(struct platform_device *pdev)
 	struct spi_master *master = platform_get_drvdata(pdev);
 	struct stm32_spi *spi = spi_master_get_devdata(master);
 
+	pm_runtime_get_sync(&pdev->dev);
+
 	spi_unregister_master(master);
 	spi->cfg->disable(spi);
 
+	pm_runtime_disable(&pdev->dev);
+	pm_runtime_put_noidle(&pdev->dev);
+	pm_runtime_set_suspended(&pdev->dev);
+	pm_runtime_dont_use_autosuspend(&pdev->dev);
+
 	if (master->dma_tx)
 		dma_release_channel(master->dma_tx);
 	if (master->dma_rx)
@@ -1966,7 +1985,6 @@  static int stm32_spi_remove(struct platform_device *pdev)
 
 	clk_disable_unprepare(spi->clk);
 
-	pm_runtime_disable(&pdev->dev);
 
 	pinctrl_pm_select_sleep_state(&pdev->dev);