@@ -129,6 +129,7 @@ enum I2C_REGS_OFFSET {
OFFSET_HS,
OFFSET_SOFTRESET,
OFFSET_DCM_EN,
+ OFFSET_MULTI_DMA,
OFFSET_PATH_DIR,
OFFSET_DEBUGSTAT,
OFFSET_DEBUGCTRL,
@@ -196,6 +197,7 @@ enum I2C_REGS_OFFSET {
[OFFSET_TRANSFER_LEN_AUX] = 0x44,
[OFFSET_CLOCK_DIV] = 0x48,
[OFFSET_SOFTRESET] = 0x50,
+ [OFFSET_MULTI_DMA] = 0x8c,
[OFFSET_SCL_MIS_COMP_POINT] = 0x90,
[OFFSET_DEBUGSTAT] = 0xe4,
[OFFSET_DEBUGCTRL] = 0xe8,
@@ -837,6 +839,57 @@ static int mtk_i2c_set_speed(struct mtk_i2c *i2c, unsigned int parent_clk)
return 0;
}
+static void i2c_dump_register(struct mtk_i2c *i2c)
+{
+ dev_err(i2c->dev, "SLAVE_ADDR: 0x%x, INTR_MASK: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_SLAVE_ADDR),
+ mtk_i2c_readw(i2c, OFFSET_INTR_MASK));
+ dev_err(i2c->dev, "INTR_STAT: 0x%x, CONTROL: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_INTR_STAT),
+ mtk_i2c_readw(i2c, OFFSET_CONTROL));
+ dev_err(i2c->dev, "TRANSFER_LEN: 0x%x, TRANSAC_LEN: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_TRANSFER_LEN),
+ mtk_i2c_readw(i2c, OFFSET_TRANSAC_LEN));
+ dev_err(i2c->dev, "DELAY_LEN: 0x%x, HTIMING: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_DELAY_LEN),
+ mtk_i2c_readw(i2c, OFFSET_TIMING));
+ dev_err(i2c->dev, "START: 0x%x, EXT_CONF: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_START),
+ mtk_i2c_readw(i2c, OFFSET_EXT_CONF));
+ dev_err(i2c->dev, "HS: 0x%x, IO_CONFIG: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_HS),
+ mtk_i2c_readw(i2c, OFFSET_IO_CONFIG));
+ dev_err(i2c->dev, "DCM_EN: 0x%x, TRANSFER_LEN_AUX: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_DCM_EN),
+ mtk_i2c_readw(i2c, OFFSET_TRANSFER_LEN_AUX));
+ dev_err(i2c->dev, "CLOCK_DIV: 0x%x, FIFO_STAT: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_CLOCK_DIV),
+ mtk_i2c_readw(i2c, OFFSET_FIFO_STAT));
+ dev_err(i2c->dev, "DEBUGCTRL : 0x%x, DEBUGSTAT: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_DEBUGCTRL),
+ mtk_i2c_readw(i2c, OFFSET_DEBUGSTAT));
+ if (i2c->dev_comp->regs == mt_i2c_regs_v2) {
+ dev_err(i2c->dev, "LTIMING: 0x%x, MULTI_DMA: 0x%x\n",
+ mtk_i2c_readw(i2c, OFFSET_LTIMING),
+ mtk_i2c_readw(i2c, OFFSET_MULTI_DMA));
+ }
+ dev_err(i2c->dev, "\nDMA_INT_FLAG: 0x%x, DMA_INT_EN: 0x%x\n",
+ readl(i2c->pdmabase + OFFSET_INT_FLAG),
+ readl(i2c->pdmabase + OFFSET_INT_EN));
+ dev_err(i2c->dev, "DMA_EN: 0x%x, DMA_CON: 0x%x\n",
+ readl(i2c->pdmabase + OFFSET_EN),
+ readl(i2c->pdmabase + OFFSET_CON));
+ dev_err(i2c->dev, "DMA_TX_MEM_ADDR: 0x%x, DMA_RX_MEM_ADDR: 0x%x\n",
+ readl(i2c->pdmabase + OFFSET_TX_MEM_ADDR),
+ readl(i2c->pdmabase + OFFSET_RX_MEM_ADDR));
+ dev_err(i2c->dev, "DMA_TX_LEN: 0x%x, DMA_RX_LEN: 0x%x\n",
+ readl(i2c->pdmabase + OFFSET_TX_LEN),
+ readl(i2c->pdmabase + OFFSET_RX_LEN));
+ dev_err(i2c->dev, "DMA_TX_4G_MODE: 0x%x, DMA_RX_4G_MODE: 0x%x",
+ readl(i2c->pdmabase + OFFSET_TX_4G_MODE),
+ readl(i2c->pdmabase + OFFSET_RX_4G_MODE));
+}
+
static int mtk_i2c_do_transfer(struct mtk_i2c *i2c, struct i2c_msg *msgs,
int num, int left_num)
{
@@ -1065,7 +1118,8 @@ static int mtk_i2c_do_transfer(struct mtk_i2c *i2c, struct i2c_msg *msgs,
}
if (ret == 0) {
- dev_dbg(i2c->dev, "addr: %x, transfer timeout\n", msgs->addr);
+ dev_err(i2c->dev, "addr: %x, transfer timeout\n", msgs->addr);
+ i2c_dump_register(i2c);
mtk_i2c_init_hw(i2c);
return -ETIMEDOUT;
}
When a timeout error occurs in i2c transter, it is usually related to the i2c/dma IP hardware configuration. Therefore, the purpose of this patch is to dump the key register values of i2c/dma when a timeout occurs in i2c for debugging. Signed-off-by: Kewei Xu <kewei.xu@mediatek.com> --- drivers/i2c/busses/i2c-mt65xx.c | 56 ++++++++++++++++++++++++++++++++++++++++- 1 file changed, 55 insertions(+), 1 deletion(-)