@@ -315,11 +315,12 @@ static int arm_lpae_init_pte(struct arm_lpae_io_pgtable *data,
static arm_lpae_iopte arm_lpae_install_table(arm_lpae_iopte *table,
arm_lpae_iopte *ptep,
arm_lpae_iopte curr,
- struct io_pgtable_cfg *cfg)
+ struct arm_lpae_io_pgtable *data)
{
arm_lpae_iopte old, new;
+ struct io_pgtable_cfg *cfg = &data->iop.cfg;
- new = __pa(table) | ARM_LPAE_PTE_TYPE_TABLE;
+ new = paddr_to_iopte(__pa(table), data) | ARM_LPAE_PTE_TYPE_TABLE;
if (cfg->quirks & IO_PGTABLE_QUIRK_ARM_NS)
new |= ARM_LPAE_PTE_NSTABLE;
@@ -380,7 +381,7 @@ static int __arm_lpae_map(struct arm_lpae_io_pgtable *data, unsigned long iova,
if (!cptep)
return -ENOMEM;
- pte = arm_lpae_install_table(cptep, ptep, 0, cfg);
+ pte = arm_lpae_install_table(cptep, ptep, 0, data);
if (pte)
__arm_lpae_free_pages(cptep, tblsz, cfg);
} else if (!cfg->coherent_walk && !(pte & ARM_LPAE_PTE_SW_SYNC)) {
@@ -592,7 +593,7 @@ static size_t arm_lpae_split_blk_unmap(struct arm_lpae_io_pgtable *data,
__arm_lpae_init_pte(data, blk_paddr, pte, lvl, 1, &tablep[i]);
}
- pte = arm_lpae_install_table(tablep, ptep, blk_pte, cfg);
+ pte = arm_lpae_install_table(tablep, ptep, blk_pte, data);
if (pte != blk_pte) {
__arm_lpae_free_pages(tablep, tablesz, cfg);
/*
Table descriptors were being installed without properly formatting the address using paddr_to_iopte, which does not match up with the iopte_deref in __arm_lpae_map. This is incorrect for the LPAE pte format, as it does not handle the high bits properly. This was found on Apple T6000 DARTs, which require a new pte format (different shift); adding support for that to paddr_to_iopte/iopte_to_paddr caused it to break badly, as even <48-bit addresses would end up incorrect in that case. Fixes: 6c89928ff7a0 ("iommu/io-pgtable-arm: Support 52-bit physical address") Acked-by: Robin Murphy <robin.murphy@arm.com> Signed-off-by: Hector Martin <marcan@marcan.st> --- drivers/iommu/io-pgtable-arm.c | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-)