| Message ID | 20220123152241.1480-1-jszhang@kernel.org (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | net: dsa|ethernet: use bool values to pass bool param of phy_init_eee | expand |
On Sun, Jan 23, 2022 at 11:22:41PM +0800, Jisheng Zhang wrote: > The 2nd param of phy_init_eee(): clk_stop_enable is a bool param, use > true or false instead of 1/0. > > Signed-off-by: Jisheng Zhang <jszhang@kernel.org> Reviewed-by: Andrew Lunn <andrew@lunn.ch> Andrew
On 1/23/2022 7:22 AM, Jisheng Zhang wrote: > The 2nd param of phy_init_eee(): clk_stop_enable is a bool param, use > true or false instead of 1/0. > > Signed-off-by: Jisheng Zhang <jszhang@kernel.org> Reviewed-by: Florian Fainelli <f.fainelli@gmail.com> Nit: for future changes, if your patch spans multiple subsystems/directories, just go with the top-most subject prefix, for instance here "net: " would have been sufficient. Thanks!
On Sun, 23 Jan 2022 23:22:41 +0800 Jisheng Zhang wrote: > The 2nd param of phy_init_eee(): clk_stop_enable is a bool param, use > true or false instead of 1/0. > > Signed-off-by: Jisheng Zhang <jszhang@kernel.org> Applied, thanks!
diff --git a/drivers/net/dsa/b53/b53_common.c b/drivers/net/dsa/b53/b53_common.c index 3867f3d4545f..a3b98992f180 100644 --- a/drivers/net/dsa/b53/b53_common.c +++ b/drivers/net/dsa/b53/b53_common.c @@ -2186,7 +2186,7 @@ int b53_eee_init(struct dsa_switch *ds, int port, struct phy_device *phy) { int ret; - ret = phy_init_eee(phy, 0); + ret = phy_init_eee(phy, false); if (ret) return 0; diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c index b82512e5b33b..bc77a26c825a 100644 --- a/drivers/net/dsa/mt7530.c +++ b/drivers/net/dsa/mt7530.c @@ -2846,7 +2846,7 @@ static void mt753x_phylink_mac_link_up(struct dsa_switch *ds, int port, mcr |= PMCR_RX_FC_EN; } - if (mode == MLO_AN_PHY && phydev && phy_init_eee(phydev, 0) >= 0) { + if (mode == MLO_AN_PHY && phydev && phy_init_eee(phydev, false) >= 0) { switch (speed) { case SPEED_1000: mcr |= PMCR_FORCE_EEE1G; diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c index 87f1056e29ff..cfe09117fe6c 100644 --- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c +++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c @@ -1368,7 +1368,7 @@ static int bcmgenet_set_eee(struct net_device *dev, struct ethtool_eee *e) if (!p->eee_enabled) { bcmgenet_eee_enable_set(dev, false); } else { - ret = phy_init_eee(dev->phydev, 0); + ret = phy_init_eee(dev->phydev, false); if (ret) { netif_err(priv, hw, dev, "EEE initialization failed\n"); return ret; diff --git a/drivers/net/ethernet/freescale/fec_main.c b/drivers/net/ethernet/freescale/fec_main.c index 796133de527e..11227f51404c 100644 --- a/drivers/net/ethernet/freescale/fec_main.c +++ b/drivers/net/ethernet/freescale/fec_main.c @@ -2797,7 +2797,7 @@ static int fec_enet_eee_mode_set(struct net_device *ndev, bool enable) int ret = 0; if (enable) { - ret = phy_init_eee(ndev->phydev, 0); + ret = phy_init_eee(ndev->phydev, false); if (ret) return ret; diff --git a/drivers/net/ethernet/marvell/mvneta.c b/drivers/net/ethernet/marvell/mvneta.c index 83c8908f0cc7..7f44b73024a0 100644 --- a/drivers/net/ethernet/marvell/mvneta.c +++ b/drivers/net/ethernet/marvell/mvneta.c @@ -4169,7 +4169,7 @@ static void mvneta_mac_link_up(struct phylink_config *config, mvneta_port_up(pp); if (phy && pp->eee_enabled) { - pp->eee_active = phy_init_eee(phy, 0) >= 0; + pp->eee_active = phy_init_eee(phy, false) >= 0; mvneta_set_eee(pp, pp->eee_active && pp->tx_lpi_enabled); } } diff --git a/drivers/net/ethernet/microchip/lan743x_ethtool.c b/drivers/net/ethernet/microchip/lan743x_ethtool.c index 91a755efe2e6..5f1e7b8bad4f 100644 --- a/drivers/net/ethernet/microchip/lan743x_ethtool.c +++ b/drivers/net/ethernet/microchip/lan743x_ethtool.c @@ -750,7 +750,7 @@ static int lan743x_ethtool_set_eee(struct net_device *netdev, } if (eee->eee_enabled) { - ret = phy_init_eee(phydev, 0); + ret = phy_init_eee(phydev, false); if (ret) { netif_err(adapter, drv, adapter->netdev, "EEE initialization failed\n"); diff --git a/drivers/net/ethernet/samsung/sxgbe/sxgbe_main.c b/drivers/net/ethernet/samsung/sxgbe/sxgbe_main.c index 32161a56726c..77a0d9d7e65a 100644 --- a/drivers/net/ethernet/samsung/sxgbe/sxgbe_main.c +++ b/drivers/net/ethernet/samsung/sxgbe/sxgbe_main.c @@ -127,7 +127,7 @@ bool sxgbe_eee_init(struct sxgbe_priv_data * const priv) /* MAC core supports the EEE feature. */ if (priv->hw_cap.eee) { /* Check if the PHY supports EEE */ - if (phy_init_eee(ndev->phydev, 1)) + if (phy_init_eee(ndev->phydev, true)) return false; priv->eee_active = 1;
The 2nd param of phy_init_eee(): clk_stop_enable is a bool param, use true or false instead of 1/0. Signed-off-by: Jisheng Zhang <jszhang@kernel.org> --- drivers/net/dsa/b53/b53_common.c | 2 +- drivers/net/dsa/mt7530.c | 2 +- drivers/net/ethernet/broadcom/genet/bcmgenet.c | 2 +- drivers/net/ethernet/freescale/fec_main.c | 2 +- drivers/net/ethernet/marvell/mvneta.c | 2 +- drivers/net/ethernet/microchip/lan743x_ethtool.c | 2 +- drivers/net/ethernet/samsung/sxgbe/sxgbe_main.c | 2 +- 7 files changed, 7 insertions(+), 7 deletions(-)