| Message ID | 1655095653-27892-1-git-send-email-quic_kriskura@quicinc.com (mailing list archive) |
|---|---|
| Headers | show |
| Series | Add QCOM SNPS PHY overriding params support | expand |
On 13-06-22, 10:17, Krishna Kurapati wrote: > Added support for overriding tuning parameters in QCOM SNPS PHY > from device tree. This parameter tuning is required to tune the > hs signal on dp/dm lines for electrical compliance to be successful. Why is [PATCH....] not appearing in title (hint dont touch these manually, use -v 9 in git format-patch to generate...
On 6/17/2022 6:02 AM, Vinod Koul wrote: > On 13-06-22, 10:17, Krishna Kurapati wrote: >> Added support for overriding tuning parameters in QCOM SNPS PHY >> from device tree. This parameter tuning is required to tune the >> hs signal on dp/dm lines for electrical compliance to be successful. > Why is [PATCH....] not appearing in title (hint dont touch these > manually, use -v 9 in git format-patch to generate... My bad. Missed it while pushing v9 patches. Will make sure to take care of this. Regards, Krishna,
Added support for overriding tuning parameters in QCOM SNPS PHY from device tree. This parameter tuning is required to tune the hs signal on dp/dm lines for electrical compliance to be successful. changes in v9: Fixed nitpick in driver code. changes in v8: Fixed nitpick in driver code. changes in v7: Fixed nitpick in driver code and dtsi file. changes in v6: Fixed errors in dt-bindings. Fixed nitpick in driver code. changes in v5: Fixed nitpicks in code. Added minimum and maximum for each parameter added in dt-bindings. Added proper suffixes to each parameter as per dtschema. changes in v4: Fixed nitpicks in code. Initial compliance test results showed overshoot in the middle of eye diagram. The current dt values were put in place to correct it and fix overshoot issue. changes in v3: Added support for phy tuning parameters to be represented in bps and corresponding register values to be written are obtained by traversing through data map declared in the driver. changes in v2: Reading the individual fields in each overriding register from device tree. Krishna Kurapati (2): phy: qcom-snps: Add support for overriding phy tuning parameters arm64: dts: qcom: sc7280: Update SNPS Phy params for SC7280 IDP device Sandeep Maheswaram (1): dt-bindings: phy: qcom,usb-snps-femto-v2: Add phy override params bindings .../bindings/phy/qcom,usb-snps-femto-v2.yaml | 88 +++++++ arch/arm64/boot/dts/qcom/sc7280-idp.dtsi | 6 + drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c | 260 ++++++++++++++++++++- 3 files changed, 352 insertions(+), 2 deletions(-)