| Message ID | 20220803094801.177490-4-p.raghav@samsung.com (mailing list archive) |
|---|---|
| State | Superseded, archived |
| Delegated to: | Mike Snitzer |
| Headers | show |
| Series | support zoned block devices with non-power-of-2 zone sizes | expand |
On 8/3/22 02:47, Pankaj Raghav wrote: > + if (!is_power_of_2(zone->len) && zone->capacity < zone->len) { > + pr_err("%s: Invalid zone capacity: %lld with non power-of-2 zone size: %lld", > + disk->disk_name, zone->capacity, zone->len); If this patch series needs to be reposted, please leave out the second and third colon (:) from the above error message. Once this comment has been addressed, feel free to add: Reviewed-by: Bart Van Assche <bvanassche@acm.org> -- dm-devel mailing list dm-devel@redhat.com https://listman.redhat.com/mailman/listinfo/dm-devel
On 2022/08/03 2:47, Pankaj Raghav wrote: > Checking if a given sector is aligned to a zone is a common > operation that is performed for zoned devices. Add > bdev_is_zone_start helper to check for this instead of opencoding it > everywhere. > > Convert the calculations on zone size to be generic instead of relying on > power-of-2(po2) based arithmetic in the block layer using the helpers > wherever possible. > > The only hot path affected by this change for zoned devices with po2 > zone size is in blk_check_zone_append() but bdev_is_zone_start() helper is > used to optimize the calculation for po2 zone sizes. > > Finally, allow zoned devices with non po2 zone sizes provided that their > zone capacity and zone size are equal. The main motivation to allow zoned > devices with non po2 zone size is to remove the unmapped LBA between > zone capcity and zone size for devices that cannot have a po2 zone > capacity. > > Reviewed-by: Luis Chamberlain <mcgrof@kernel.org> > Reviewed-by: Hannes Reinecke <hare@suse.de> > Signed-off-by: Pankaj Raghav <p.raghav@samsung.com> > --- > block/blk-core.c | 2 +- > block/blk-zoned.c | 24 ++++++++++++++++++------ > include/linux/blkdev.h | 30 ++++++++++++++++++++++++++++++ > 3 files changed, 49 insertions(+), 7 deletions(-) > > diff --git a/block/blk-core.c b/block/blk-core.c > index a0d1104c5590..1cb519220ffb 100644 > --- a/block/blk-core.c > +++ b/block/blk-core.c > @@ -563,7 +563,7 @@ static inline blk_status_t blk_check_zone_append(struct request_queue *q, > return BLK_STS_NOTSUPP; > > /* The bio sector must point to the start of a sequential zone */ > - if (bio->bi_iter.bi_sector & (bdev_zone_sectors(bio->bi_bdev) - 1) || > + if (!bdev_is_zone_start(bio->bi_bdev, bio->bi_iter.bi_sector) || > !bio_zone_is_seq(bio)) > return BLK_STS_IOERR; > > diff --git a/block/blk-zoned.c b/block/blk-zoned.c > index dce9c95b4bcd..665b822d13f9 100644 > --- a/block/blk-zoned.c > +++ b/block/blk-zoned.c > @@ -285,10 +285,10 @@ int blkdev_zone_mgmt(struct block_device *bdev, enum req_op op, > return -EINVAL; > > /* Check alignment (handle eventual smaller last zone) */ > - if (sector & (zone_sectors - 1)) > + if (!bdev_is_zone_start(bdev, sector)) > return -EINVAL; > > - if ((nr_sectors & (zone_sectors - 1)) && end_sector != capacity) > + if (!bdev_is_zone_start(bdev, nr_sectors) && end_sector != capacity) > return -EINVAL; > > /* > @@ -486,14 +486,26 @@ static int blk_revalidate_zone_cb(struct blk_zone *zone, unsigned int idx, > * smaller last zone. > */ > if (zone->start == 0) { > - if (zone->len == 0 || !is_power_of_2(zone->len)) { > - pr_warn("%s: Invalid zoned device with non power of two zone size (%llu)\n", > - disk->disk_name, zone->len); > + if (zone->len == 0) { > + pr_warn("%s: Invalid zero zone size", disk->disk_name); > + return -ENODEV; > + } > + > + /* > + * Non power-of-2 zone size support was added to remove the > + * gap between zone capacity and zone size. Though it is technically > + * possible to have gaps in a non power-of-2 device, Linux requires > + * the zone size to be equal to zone capacity for non power-of-2 > + * zoned devices. > + */ > + if (!is_power_of_2(zone->len) && zone->capacity < zone->len) { > + pr_err("%s: Invalid zone capacity: %lld with non power-of-2 zone size: %lld", > + disk->disk_name, zone->capacity, zone->len); > return -ENODEV; > } > > args->zone_sectors = zone->len; > - args->nr_zones = (capacity + zone->len - 1) >> ilog2(zone->len); > + args->nr_zones = div64_u64(capacity + zone->len - 1, zone->len); > } else if (zone->start + args->zone_sectors < capacity) { > if (zone->len != args->zone_sectors) { > pr_warn("%s: Invalid zoned device with non constant zone size\n", > diff --git a/include/linux/blkdev.h b/include/linux/blkdev.h > index 22f97427b60b..5aa15172299d 100644 > --- a/include/linux/blkdev.h > +++ b/include/linux/blkdev.h > @@ -709,6 +709,30 @@ static inline unsigned int disk_zone_no(struct gendisk *disk, sector_t sector) > return div64_u64(sector, zone_sectors); > } > > +static inline sector_t bdev_offset_from_zone_start(struct block_device *bdev, > + sector_t sec) > +{ > + sector_t zone_sectors = bdev_zone_sectors(bdev); > + u64 remainder = 0; > + > + if (!bdev_is_zoned(bdev)) > + return 0; > + > + if (is_power_of_2(zone_sectors)) > + return sec & (zone_sectors - 1); > + > + div64_u64_rem(sec, zone_sectors, &remainder); > + return remainder; > +} > + > +static inline bool bdev_is_zone_start(struct block_device *bdev, sector_t sec) > +{ > + if (!bdev_is_zoned(bdev)) > + return false; > + > + return bdev_offset_from_zone_start(bdev, sec) == 0; > +} > + > static inline bool disk_zone_is_seq(struct gendisk *disk, sector_t sector) > { > if (!blk_queue_is_zoned(disk->queue)) > @@ -753,6 +777,12 @@ static inline unsigned int disk_zone_no(struct gendisk *disk, sector_t sector) > { > return 0; > } > + > +static inline bool bdev_is_zone_start(struct block_device *bdev, sector_t sec) > +{ > + return false; > +} Is this one really necessary ? Any caller of this would also depend on CONFIG_BLK_DEV_ZONED and not compiled if not enabled. So there should be no callers of this for the !CONFIG_BLK_DEV_ZONED case. > + > static inline unsigned int bdev_max_open_zones(struct block_device *bdev) > { > return 0;
diff --git a/block/blk-core.c b/block/blk-core.c index a0d1104c5590..1cb519220ffb 100644 --- a/block/blk-core.c +++ b/block/blk-core.c @@ -563,7 +563,7 @@ static inline blk_status_t blk_check_zone_append(struct request_queue *q, return BLK_STS_NOTSUPP; /* The bio sector must point to the start of a sequential zone */ - if (bio->bi_iter.bi_sector & (bdev_zone_sectors(bio->bi_bdev) - 1) || + if (!bdev_is_zone_start(bio->bi_bdev, bio->bi_iter.bi_sector) || !bio_zone_is_seq(bio)) return BLK_STS_IOERR; diff --git a/block/blk-zoned.c b/block/blk-zoned.c index dce9c95b4bcd..665b822d13f9 100644 --- a/block/blk-zoned.c +++ b/block/blk-zoned.c @@ -285,10 +285,10 @@ int blkdev_zone_mgmt(struct block_device *bdev, enum req_op op, return -EINVAL; /* Check alignment (handle eventual smaller last zone) */ - if (sector & (zone_sectors - 1)) + if (!bdev_is_zone_start(bdev, sector)) return -EINVAL; - if ((nr_sectors & (zone_sectors - 1)) && end_sector != capacity) + if (!bdev_is_zone_start(bdev, nr_sectors) && end_sector != capacity) return -EINVAL; /* @@ -486,14 +486,26 @@ static int blk_revalidate_zone_cb(struct blk_zone *zone, unsigned int idx, * smaller last zone. */ if (zone->start == 0) { - if (zone->len == 0 || !is_power_of_2(zone->len)) { - pr_warn("%s: Invalid zoned device with non power of two zone size (%llu)\n", - disk->disk_name, zone->len); + if (zone->len == 0) { + pr_warn("%s: Invalid zero zone size", disk->disk_name); + return -ENODEV; + } + + /* + * Non power-of-2 zone size support was added to remove the + * gap between zone capacity and zone size. Though it is technically + * possible to have gaps in a non power-of-2 device, Linux requires + * the zone size to be equal to zone capacity for non power-of-2 + * zoned devices. + */ + if (!is_power_of_2(zone->len) && zone->capacity < zone->len) { + pr_err("%s: Invalid zone capacity: %lld with non power-of-2 zone size: %lld", + disk->disk_name, zone->capacity, zone->len); return -ENODEV; } args->zone_sectors = zone->len; - args->nr_zones = (capacity + zone->len - 1) >> ilog2(zone->len); + args->nr_zones = div64_u64(capacity + zone->len - 1, zone->len); } else if (zone->start + args->zone_sectors < capacity) { if (zone->len != args->zone_sectors) { pr_warn("%s: Invalid zoned device with non constant zone size\n", diff --git a/include/linux/blkdev.h b/include/linux/blkdev.h index 22f97427b60b..5aa15172299d 100644 --- a/include/linux/blkdev.h +++ b/include/linux/blkdev.h @@ -709,6 +709,30 @@ static inline unsigned int disk_zone_no(struct gendisk *disk, sector_t sector) return div64_u64(sector, zone_sectors); } +static inline sector_t bdev_offset_from_zone_start(struct block_device *bdev, + sector_t sec) +{ + sector_t zone_sectors = bdev_zone_sectors(bdev); + u64 remainder = 0; + + if (!bdev_is_zoned(bdev)) + return 0; + + if (is_power_of_2(zone_sectors)) + return sec & (zone_sectors - 1); + + div64_u64_rem(sec, zone_sectors, &remainder); + return remainder; +} + +static inline bool bdev_is_zone_start(struct block_device *bdev, sector_t sec) +{ + if (!bdev_is_zoned(bdev)) + return false; + + return bdev_offset_from_zone_start(bdev, sec) == 0; +} + static inline bool disk_zone_is_seq(struct gendisk *disk, sector_t sector) { if (!blk_queue_is_zoned(disk->queue)) @@ -753,6 +777,12 @@ static inline unsigned int disk_zone_no(struct gendisk *disk, sector_t sector) { return 0; } + +static inline bool bdev_is_zone_start(struct block_device *bdev, sector_t sec) +{ + return false; +} + static inline unsigned int bdev_max_open_zones(struct block_device *bdev) { return 0;