@@ -57,6 +57,13 @@ config SPI_MEM
comment "SPI Master Controller Drivers"
+config SPI_AIROHA_EN7523
+ bool "Airoha EN7523 SPI controller support"
+ depends on ARCH_AIROHA
+ default ARCH_AIROHA
+ help
+ This enables SPI controller support for the Airoha EN7523 SoC.
+
config SPI_ALTERA
tristate "Altera SPI Controller platform driver"
select SPI_ALTERA_CORE
@@ -14,6 +14,7 @@ obj-$(CONFIG_SPI_SPIDEV) += spidev.o
obj-$(CONFIG_SPI_LOOPBACK_TEST) += spi-loopback-test.o
# SPI master controller drivers (bus)
+obj-$(CONFIG_SPI_AIROHA_EN7523) += spi-en7523.o
obj-$(CONFIG_SPI_ALTERA) += spi-altera-platform.o
obj-$(CONFIG_SPI_ALTERA_CORE) += spi-altera-core.o
obj-$(CONFIG_SPI_ALTERA_DFL) += spi-altera-dfl.o
new file mode 100644
@@ -0,0 +1,305 @@
+// SPDX-License-Identifier: GPL-2.0
+
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/mod_devicetable.h>
+#include <linux/clk.h>
+#include <linux/spi/spi.h>
+#include <dt-bindings/clock/en7523-clk.h>
+
+
+#define ENSPI_READ_IDLE_EN 0x0004
+#define ENSPI_MTX_MODE_TOG 0x0014
+#define ENSPI_RDCTL_FSM 0x0018
+#define ENSPI_MANUAL_EN 0x0020
+#define ENSPI_MANUAL_OPFIFO_EMPTY 0x0024
+#define ENSPI_MANUAL_OPFIFO_WDATA 0x0028
+#define ENSPI_MANUAL_OPFIFO_FULL 0x002C
+#define ENSPI_MANUAL_OPFIFO_WR 0x0030
+#define ENSPI_MANUAL_DFIFO_FULL 0x0034
+#define ENSPI_MANUAL_DFIFO_WDATA 0x0038
+#define ENSPI_MANUAL_DFIFO_EMPTY 0x003C
+#define ENSPI_MANUAL_DFIFO_RD 0x0040
+#define ENSPI_MANUAL_DFIFO_RDATA 0x0044
+#define ENSPI_IER 0x0090
+#define ENSPI_NFI2SPI_EN 0x0130
+
+#define OP_CSH 0x00
+#define OP_CSL 0x01
+#define OP_CK 0x02
+#define OP_OUTS 0x08
+#define OP_OUTD 0x09
+#define OP_OUTQ 0x0A
+#define OP_INS 0x0C
+#define OP_INS0 0x0D
+#define OP_IND 0x0E
+#define OP_INQ 0x0F
+#define OP_OS2IS 0x10
+#define OP_OS2ID 0x11
+#define OP_OS2IQ 0x12
+#define OP_OD2IS 0x13
+#define OP_OD2ID 0x14
+#define OP_OD2IQ 0x15
+#define OP_OQ2IS 0x16
+#define OP_OQ2ID 0x17
+#define OP_OQ2IQ 0x18
+#define OP_OSNIS 0x19
+#define OP_ODNID 0x1A
+
+#define MATRIX_MODE_AUTO 1
+#define CONF_MTX_MODE_AUTO 0
+#define MANUALEN_AUTO 0
+#define MATRIX_MODE_MANUAL 0
+#define CONF_MTX_MODE_MANUAL 9
+#define MANUALEN_MANUAL 1
+
+#define ENSPI_MAX_XFER 0x1ff
+
+#define REG(x) (iobase + x)
+
+static void __iomem *iobase;
+
+
+static void opfifo_write(u32 cmd, u32 len)
+{
+ u32 tmp = ((cmd & 0x1f) << 9) | (len & 0x1ff);
+
+ writel(tmp, REG(ENSPI_MANUAL_OPFIFO_WDATA));
+
+ /* Wait for room in OPFIFO */
+ while (readl(REG(ENSPI_MANUAL_OPFIFO_FULL)))
+ cpu_relax();
+
+ /* Shift command into OPFIFO */
+ writel(1, REG(ENSPI_MANUAL_OPFIFO_WR));
+
+ /* Wait for command to finish */
+ while (!readl(REG(ENSPI_MANUAL_OPFIFO_EMPTY)))
+ cpu_relax();
+}
+
+static void set_cs(int state)
+{
+ if (state)
+ opfifo_write(OP_CSH, 1);
+ else
+ opfifo_write(OP_CSL, 1);
+}
+
+static void manual_begin_cmd(void)
+{
+ /* Disable read idle state */
+ writel(0, REG(ENSPI_READ_IDLE_EN));
+
+ /* Wait for FSM to reach idle state */
+ while (readl(REG(ENSPI_RDCTL_FSM)))
+ cpu_relax();
+
+ /* Set SPI core to manual mode */
+ writel(CONF_MTX_MODE_MANUAL, REG(ENSPI_MTX_MODE_TOG));
+ writel(MANUALEN_MANUAL, REG(ENSPI_MANUAL_EN));
+}
+
+static void manual_end_cmd(void)
+{
+ /* Set SPI core to auto mode */
+ writel(CONF_MTX_MODE_AUTO, REG(ENSPI_MTX_MODE_TOG));
+ writel(MANUALEN_AUTO, REG(ENSPI_MANUAL_EN));
+
+ /* Enable read idle state */
+ writel(1, REG(ENSPI_READ_IDLE_EN));
+}
+
+static void dfifo_read(u8 *buf, int len)
+{
+ int i;
+
+ for (i = 0; i < len; i++) {
+ /* Wait for requested data to show up in DFIFO */
+ while (readl(REG(ENSPI_MANUAL_DFIFO_EMPTY)))
+ cpu_relax();
+ buf[i] = readl(REG(ENSPI_MANUAL_DFIFO_RDATA));
+ /* Queue up next byte */
+ writel(1, REG(ENSPI_MANUAL_DFIFO_RD));
+ }
+}
+
+static void dfifo_write(const u8 *buf, int len)
+{
+ int i;
+
+ for (i = 0; i < len; i++) {
+ /* Wait for room in DFIFO */
+ while (readl(REG(ENSPI_MANUAL_DFIFO_FULL)))
+ cpu_relax();
+ writel(buf[i], REG(ENSPI_MANUAL_DFIFO_WDATA));
+ }
+}
+
+static int init_hw(struct device *dev)
+{
+ struct clk *clk;
+ int ret;
+
+ /* Disable manual/auto mode clash interrupt */
+ writel(0, REG(ENSPI_IER));
+
+ /* Disable DMA */
+ writel(0, REG(ENSPI_NFI2SPI_EN));
+
+ clk = devm_clk_get(dev, NULL);
+ if (IS_ERR(clk))
+ return PTR_ERR(clk);
+
+ ret = clk_prepare_enable(clk);
+ if (ret)
+ return ret;
+
+ ret = clk_set_rate(clk, 40000000);
+ if (ret) {
+ clk_disable_unprepare(clk);
+ return ret;
+ }
+
+ return 0;
+}
+
+static int xfer_read(struct spi_transfer *xfer)
+{
+ int opcode;
+ uint8_t *buf = xfer->rx_buf;
+
+ switch (xfer->rx_nbits) {
+ case SPI_NBITS_SINGLE:
+ opcode = OP_INS;
+ break;
+ case SPI_NBITS_DUAL:
+ opcode = OP_IND;
+ break;
+ }
+
+ opfifo_write(opcode, xfer->len);
+ dfifo_read(buf, xfer->len);
+
+ return xfer->len;
+}
+
+static int xfer_write(struct spi_transfer *xfer, int next_xfer_is_rx)
+{
+ int opcode;
+ const uint8_t *buf = xfer->tx_buf;
+
+ if (next_xfer_is_rx) {
+ /* need to use Ox2Ix opcode to set the core to input afterwards */
+ switch (xfer->tx_nbits) {
+ case SPI_NBITS_SINGLE:
+ opcode = OP_OS2IS;
+ break;
+ case SPI_NBITS_DUAL:
+ opcode = OP_OD2ID;
+ break;
+ }
+ } else {
+ switch (xfer->tx_nbits) {
+ case SPI_NBITS_SINGLE:
+ opcode = OP_OUTS;
+ break;
+ case SPI_NBITS_DUAL:
+ opcode = OP_OUTD;
+ break;
+ }
+ }
+
+ opfifo_write(opcode, xfer->len);
+ dfifo_write(buf, xfer->len);
+
+ return xfer->len;
+}
+
+static size_t max_transfer_size(struct spi_device *spi)
+{
+ return ENSPI_MAX_XFER;
+}
+
+static int transfer_one_message(struct spi_controller *ctrl, struct spi_message *msg)
+{
+ struct spi_transfer *xfer;
+ int next_xfer_is_rx = 0;
+
+ manual_begin_cmd();
+ set_cs(0);
+ list_for_each_entry(xfer, &msg->transfers, transfer_list) {
+ if (xfer->tx_buf) {
+ if (!list_is_last(&xfer->transfer_list, &msg->transfers)
+ && list_next_entry(xfer, transfer_list)->rx_buf != NULL)
+ next_xfer_is_rx = 1;
+ else
+ next_xfer_is_rx = 0;
+ msg->actual_length += xfer_write(xfer, next_xfer_is_rx);
+ } else if (xfer->rx_buf) {
+ msg->actual_length += xfer_read(xfer);
+ }
+ }
+ set_cs(1);
+ manual_end_cmd();
+
+ msg->status = 0;
+ spi_finalize_current_message(ctrl);
+
+ return 0;
+}
+
+static int spi_probe(struct platform_device *pdev)
+{
+ struct spi_controller *ctrl;
+ int err;
+
+ ctrl = devm_spi_alloc_master(&pdev->dev, 0);
+ if (!ctrl) {
+ dev_err(&pdev->dev, "Error allocating SPI controller\n");
+ return -ENOMEM;
+ }
+
+ iobase = devm_platform_get_and_ioremap_resource(pdev, 0, NULL);
+ if (IS_ERR(iobase)) {
+ dev_err(&pdev->dev, "Could not map SPI register address");
+ return -ENOMEM;
+ }
+
+ err = init_hw(&pdev->dev);
+ if (err)
+ return err;
+
+ ctrl->dev.of_node = pdev->dev.of_node;
+ ctrl->flags = SPI_CONTROLLER_HALF_DUPLEX;
+ ctrl->mode_bits = SPI_RX_DUAL | SPI_TX_DUAL;
+ ctrl->max_transfer_size = max_transfer_size;
+ ctrl->transfer_one_message = transfer_one_message;
+ err = devm_spi_register_controller(&pdev->dev, ctrl);
+ if (err) {
+ dev_err(&pdev->dev, "Could not register SPI controller\n");
+ return -ENODEV;
+ }
+
+ return 0;
+}
+
+static const struct of_device_id spi_of_ids[] = {
+ { .compatible = "airoha,en7523-spi" },
+ { /* sentinel */ }
+};
+MODULE_DEVICE_TABLE(of, spi_of_ids);
+
+static struct platform_driver spi_driver = {
+ .probe = spi_probe,
+ .driver = {
+ .name = "airoha-en7523-spi",
+ .of_match_table = spi_of_ids,
+ },
+};
+
+module_platform_driver(spi_driver);
+
+MODULE_LICENSE("GPL");
+MODULE_AUTHOR("Bert Vermeulen <bert@biot.com>");
+MODULE_DESCRIPTION("Airoha EN7523 SPI driver");
This SPI driver primarily drives the SoC-internal state machine doing the actual transfers. This allows transfers to be transparently queued in hardware. DMA mode is not yet supported. Signed-off-by: Bert Vermeulen <bert@biot.com> --- drivers/spi/Kconfig | 7 + drivers/spi/Makefile | 1 + drivers/spi/spi-en7523.c | 305 +++++++++++++++++++++++++++++++++++++++ 3 files changed, 313 insertions(+) create mode 100644 drivers/spi/spi-en7523.c