diff mbox series

[v3,21/50] dt-bindings: pinctrl: at91: add sam9x7

Message ID 20230728102647.266359-1-varshini.rajendran@microchip.com (mailing list archive)
State New, archived
Headers show
Series [v3,01/50] dt-bindings: microchip: atmel,at91rm9200-tcb: add sam9x60, sam9x7 compatible | expand

Commit Message

Varshini Rajendran July 28, 2023, 10:26 a.m. UTC 
Add device tree binding for SAM9X7 pin controller.

Signed-off-by: Varshini Rajendran <varshini.rajendran@microchip.com>
---
 .../devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt          | 2 ++
 1 file changed, 2 insertions(+)

Comments

Krzysztof Kozlowski July 28, 2023, 12:42 p.m. UTC | #1 
On 28/07/2023 12:26, Varshini Rajendran wrote:
> Add device tree binding for SAM9X7 pin controller.
> 
> Signed-off-by: Varshini Rajendran <varshini.rajendran@microchip.com>
> ---
>  .../devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt          | 2 ++
>  1 file changed, 2 insertions(+)


Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>

Best regards,
Krzysztof
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt
index e8abbdad7b5d..0aa1a53012d6 100644
--- a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt
+++ b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt
@@ -20,6 +20,7 @@  such as pull-up, multi drive, etc.
 Required properties for iomux controller:
 - compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl"
 		or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pinctrl"
+		or "microchip,sam9x7-pinctrl", "microchip,sam9x60-pinctrl"
 - atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be
   configured in this periph mode. All the periph and bank need to be describe.
 
@@ -120,6 +121,7 @@  Some requirements for using atmel,at91rm9200-pinctrl binding:
 For each bank the required properties are:
 - compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or
   "microchip,sam9x60-gpio"
+  or "microchip,sam9x7-gpio", "microchip,sam9x60-gpio", "atmel,at91rm9200-gpio"
 - reg: physical base address and length of the controller's registers
 - interrupts: interrupt outputs from the controller
 - interrupt-controller: marks the device node as an interrupt controller