deleted file mode 100644
@@ -1,50 +0,0 @@
-* Marvell Armada 370 / Armada XP / Armada 3700 Ethernet Controller (NETA)
-
-Required properties:
-- compatible: could be one of the following:
- "marvell,armada-370-neta"
- "marvell,armada-xp-neta"
- "marvell,armada-3700-neta"
- "marvell,armada-ac5-neta"
-- reg: address and length of the register set for the device.
-- interrupts: interrupt for the device
-- phy: See ethernet.txt file in the same directory.
-- phy-mode: See ethernet.txt file in the same directory
-- clocks: List of clocks for this device. At least one clock is
- mandatory for the core clock. If several clocks are given, then the
- clock-names property must be used to identify them.
-
-Optional properties:
-- tx-csum-limit: maximum mtu supported by port that allow TX checksum.
- Value is presented in bytes. If not used, by default 1600B is set for
- "marvell,armada-370-neta" and 9800B for others.
-- clock-names: List of names corresponding to clocks property; shall be
- "core" for core clock and "bus" for the optional bus clock.
-- phys: comphy for the ethernet port, see ../phy/phy-bindings.txt
-
-Optional properties (valid only for Armada XP/38x):
-
-- buffer-manager: a phandle to a buffer manager node. Please refer to
- Documentation/devicetree/bindings/net/marvell-neta-bm.txt
-- bm,pool-long: ID of a pool, that will accept all packets of a size
- higher than 'short' pool's threshold (if set) and up to MTU value.
- Obligatory, when the port is supposed to use hardware
- buffer management.
-- bm,pool-short: ID of a pool, that will be used for accepting
- packets of a size lower than given threshold. If not set, the port
- will use a single 'long' pool for all packets, as defined above.
-
-Example:
-
-ethernet@70000 {
- compatible = "marvell,armada-370-neta";
- reg = <0x70000 0x2500>;
- interrupts = <8>;
- clocks = <&gate_clk 4>;
- tx-csum-limit = <9800>
- phy = <&phy0>;
- phy-mode = "rgmii-id";
- buffer-manager = <&bm>;
- bm,pool-long = <0>;
- bm,pool-short = <1>;
-};
new file mode 100644
@@ -0,0 +1,102 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/net/marvell-armada-370-neta.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Marvell Armada 370 / Armada XP / Armada 3700 Ethernet Controller (NETA)
+
+allOf:
+ - $ref: ethernet-controller.yaml#
+ - $ref: ethernet-controller.yaml#/$defs/phylink
+
+maintainers:
+ - Arınç ÜNAL <arinc.unal@arinc9.com>
+
+properties:
+ compatible:
+ enum:
+ - marvell,armada-370-neta
+ - marvell,armada-xp-neta
+ - marvell,armada-3700-neta
+ - marvell,armada-ac5-neta
+
+ reg:
+ maxItems: 1
+
+ interrupts:
+ maxItems: 1
+
+ clocks:
+ description:
+ List of clocks for this device. At least one clock is mandatory for the
+ core clock. If several clocks are given, then the clock-names property
+ must be used to identify them.
+
+ tx-csum-limit:
+ description:
+ Maximum mtu supported by port that allow TX checksum. Value is presented
+ in bytes. If not used, by default 1600B is set for
+ "marvell,armada-370-neta" and 9800B for others.
+
+ clock-names:
+ description:
+ List of names corresponding to clocks property; shall be "core" for core
+ clock and "bus" for the optional bus clock.
+
+ phys:
+ description:
+ comphy for the ethernet port, see ../phy/phy-bindings.txt.
+
+if:
+ properties:
+ compatible:
+ enum:
+ - marvell,armada-370-neta
+ - marvell,armada-xp-neta
+then:
+ properties:
+ buffer-manager:
+ description:
+ A phandle to a buffer manager node. Please refer to
+ Documentation/devicetree/bindings/net/marvell-neta-bm.txt.
+
+ bm,pool-long:
+ description:
+ ID of a pool, that will accept all packets of a size higher than 'short'
+ pool's threshold (if set) and up to MTU value. Obligatory, when the port
+ is supposed to use hardware buffer management.
+
+ bm,pool-short:
+ description:
+ ID of a pool, that will be used for accepting packets of a size lower
+ than given threshold. If not set, the port will use a single 'long' pool
+ for all packets, as defined above.
+
+required:
+ - compatible
+ - reg
+ - interrupts
+ - phy-mode
+ - clocks
+
+unevaluatedProperties: false
+
+examples:
+ - |
+ ethernet@70000 {
+ compatible = "marvell,armada-370-neta";
+ reg = <0x70000 0x2500>;
+ interrupts = <8>;
+ clocks = <&gate_clk 4>;
+ tx-csum-limit = <9800>;
+ phy-mode = "rgmii-id";
+ buffer-manager = <&bm>;
+ bm,pool-long = <0>;
+ bm,pool-short = <1>;
+
+ fixed-link {
+ speed = <1000>;
+ full-duplex;
+ };
+ };
Convert the document for Marvell Armada 370 / Armada XP / Armada 3700 Ethernet Controller (NETA) to json-schema. Signed-off-by: Arınç ÜNAL <arinc.unal@arinc9.com> --- .../bindings/net/marvell-armada-370-neta.txt | 50 --------- .../bindings/net/marvell-armada-370-neta.yaml | 102 ++++++++++++++++++ 2 files changed, 102 insertions(+), 50 deletions(-) delete mode 100644 Documentation/devicetree/bindings/net/marvell-armada-370-neta.txt create mode 100644 Documentation/devicetree/bindings/net/marvell-armada-370-neta.yaml