@@ -1150,18 +1150,16 @@ static int xgbe_set_gpio(struct xgbe_prv_data *pdata, unsigned int gpio)
return 0;
}
-static int xgbe_read_mmd_regs_v2(struct xgbe_prv_data *pdata, int prtad,
- int mmd_reg)
+static unsigned int get_mmd_address(struct xgbe_prv_data *pdata, int mmd_reg)
{
- unsigned long flags;
- unsigned int mmd_address, index, offset;
- int mmd_data;
-
- if (mmd_reg & XGBE_ADDR_C45)
- mmd_address = mmd_reg & ~XGBE_ADDR_C45;
- else
- mmd_address = (pdata->mdio_mmd << 16) | (mmd_reg & 0xffff);
+ return (mmd_reg & XGBE_ADDR_C45) ?
+ mmd_reg & ~XGBE_ADDR_C45 :
+ (pdata->mdio_mmd << 16) | (mmd_reg & 0xffff);
+}
+static void get_pcs_index_and_offset(struct xgbe_prv_data *pdata, unsigned int mmd_address,
+ unsigned int *index, unsigned int *offset)
+{
/* The PCS registers are accessed using mmio. The underlying
* management interface uses indirect addressing to access the MMD
* register sets. This requires accessing of the PCS register in two
@@ -1172,8 +1170,20 @@ static int xgbe_read_mmd_regs_v2(struct xgbe_prv_data *pdata, int prtad,
* offset 1 bit and reading 16 bits of data.
*/
mmd_address <<= 1;
- index = mmd_address & ~pdata->xpcs_window_mask;
- offset = pdata->xpcs_window + (mmd_address & pdata->xpcs_window_mask);
+ *index = mmd_address & ~pdata->xpcs_window_mask;
+ *offset = pdata->xpcs_window + (mmd_address & pdata->xpcs_window_mask);
+}
+
+static int xgbe_read_mmd_regs_v2(struct xgbe_prv_data *pdata, int prtad,
+ int mmd_reg)
+{
+ unsigned long flags;
+ unsigned int mmd_address, index, offset;
+ int mmd_data;
+
+ mmd_address = get_mmd_address(pdata, mmd_reg);
+
+ get_pcs_index_and_offset(pdata, mmd_address, &index, &offset);
spin_lock_irqsave(&pdata->xpcs_lock, flags);
XPCS32_IOWRITE(pdata, pdata->xpcs_window_sel_reg, index);
@@ -1189,23 +1199,9 @@ static void xgbe_write_mmd_regs_v2(struct xgbe_prv_data *pdata, int prtad,
unsigned long flags;
unsigned int mmd_address, index, offset;
- if (mmd_reg & XGBE_ADDR_C45)
- mmd_address = mmd_reg & ~XGBE_ADDR_C45;
- else
- mmd_address = (pdata->mdio_mmd << 16) | (mmd_reg & 0xffff);
+ mmd_address = get_mmd_address(pdata, mmd_reg);
- /* The PCS registers are accessed using mmio. The underlying
- * management interface uses indirect addressing to access the MMD
- * register sets. This requires accessing of the PCS register in two
- * phases, an address phase and a data phase.
- *
- * The mmio interface is based on 16-bit offsets and values. All
- * register offsets must therefore be adjusted by left shifting the
- * offset 1 bit and writing 16 bits of data.
- */
- mmd_address <<= 1;
- index = mmd_address & ~pdata->xpcs_window_mask;
- offset = pdata->xpcs_window + (mmd_address & pdata->xpcs_window_mask);
+ get_pcs_index_and_offset(pdata, mmd_address, &index, &offset);
spin_lock_irqsave(&pdata->xpcs_lock, flags);
XPCS32_IOWRITE(pdata, pdata->xpcs_window_sel_reg, index);
@@ -1220,10 +1216,7 @@ static int xgbe_read_mmd_regs_v1(struct xgbe_prv_data *pdata, int prtad,
unsigned int mmd_address;
int mmd_data;
- if (mmd_reg & XGBE_ADDR_C45)
- mmd_address = mmd_reg & ~XGBE_ADDR_C45;
- else
- mmd_address = (pdata->mdio_mmd << 16) | (mmd_reg & 0xffff);
+ mmd_address = get_mmd_address(pdata, mmd_reg);
/* The PCS registers are accessed using mmio. The underlying APB3
* management interface uses indirect addressing to access the MMD
@@ -1248,10 +1241,7 @@ static void xgbe_write_mmd_regs_v1(struct xgbe_prv_data *pdata, int prtad,
unsigned int mmd_address;
unsigned long flags;
- if (mmd_reg & XGBE_ADDR_C45)
- mmd_address = mmd_reg & ~XGBE_ADDR_C45;
- else
- mmd_address = (pdata->mdio_mmd << 16) | (mmd_reg & 0xffff);
+ mmd_address = get_mmd_address(pdata, mmd_reg);
/* The PCS registers are accessed using mmio. The underlying APB3
* management interface uses indirect addressing to access the MMD
@@ -274,20 +274,27 @@ static int xgbe_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id)
/* Set the PCS indirect addressing definition registers */
rdev = pci_get_domain_bus_and_slot(0, 0, PCI_DEVFN(0, 0));
- if (rdev &&
- (rdev->vendor == PCI_VENDOR_ID_AMD) && (rdev->device == 0x15d0)) {
- pdata->xpcs_window_def_reg = PCS_V2_RV_WINDOW_DEF;
- pdata->xpcs_window_sel_reg = PCS_V2_RV_WINDOW_SELECT;
- } else if (rdev && (rdev->vendor == PCI_VENDOR_ID_AMD) &&
- (rdev->device == 0x14b5)) {
- pdata->xpcs_window_def_reg = PCS_V2_YC_WINDOW_DEF;
- pdata->xpcs_window_sel_reg = PCS_V2_YC_WINDOW_SELECT;
-
- /* Yellow Carp devices do not need cdr workaround */
- pdata->vdata->an_cdr_workaround = 0;
-
- /* Yellow Carp devices do not need rrc */
- pdata->vdata->enable_rrc = 0;
+ if (rdev && rdev->vendor == PCI_VENDOR_ID_AMD) {
+ switch (rdev->device) {
+ case XGBE_RV_PCI_DEVICE_ID:
+ pdata->xpcs_window_def_reg = PCS_V2_RV_WINDOW_DEF;
+ pdata->xpcs_window_sel_reg = PCS_V2_RV_WINDOW_SELECT;
+ break;
+ case XGBE_YC_PCI_DEVICE_ID:
+ pdata->xpcs_window_def_reg = PCS_V2_YC_WINDOW_DEF;
+ pdata->xpcs_window_sel_reg = PCS_V2_YC_WINDOW_SELECT;
+
+ /* Yellow Carp devices do not need cdr workaround */
+ pdata->vdata->an_cdr_workaround = 0;
+
+ /* Yellow Carp devices do not need rrc */
+ pdata->vdata->enable_rrc = 0;
+ break;
+ default:
+ pdata->xpcs_window_def_reg = PCS_V2_WINDOW_DEF;
+ pdata->xpcs_window_sel_reg = PCS_V2_WINDOW_SELECT;
+ break;
+ }
} else {
pdata->xpcs_window_def_reg = PCS_V2_WINDOW_DEF;
pdata->xpcs_window_sel_reg = PCS_V2_WINDOW_SELECT;
@@ -347,6 +347,10 @@
(_src)->link_modes._sname, \
__ETHTOOL_LINK_MODE_MASK_NBITS)
+/* XGBE PCI device id */
+#define XGBE_RV_PCI_DEVICE_ID 0x15d0
+#define XGBE_YC_PCI_DEVICE_ID 0x14b5
+
struct xgbe_prv_data;
struct xgbe_packet_data {
The xgbe_{read/write}_mmd_regs_v* functions have common code which can be moved to helper functions. Also, the xgbe_pci_probe() needs reorganization. Add new helper functions to calculate the mmd_address for v1/v2 of xpcs access. And, convert if/else statements in xgbe_pci_probe() to switch case. This helps code look cleaner. Signed-off-by: Raju Rangoju <Raju.Rangoju@amd.com> --- drivers/net/ethernet/amd/xgbe/xgbe-dev.c | 62 ++++++++++-------------- drivers/net/ethernet/amd/xgbe/xgbe-pci.c | 35 +++++++------ drivers/net/ethernet/amd/xgbe/xgbe.h | 4 ++ 3 files changed, 51 insertions(+), 50 deletions(-)