diff mbox series

[3/3] ARM: dts: stm32: add ethernet1 for STM32MP135F-DK board

Message ID 20240610080309.290444-4-christophe.roullier@foss.st.com (mailing list archive)
State New, archived
Headers show
Series Series DTs to deliver Ethernet for STM32MP13 | expand

Commit Message

Christophe Roullier June 10, 2024, 8:03 a.m. UTC 
Ethernet1: RMII with crystal
Ethernet2: RMII with no cristal, need "phy-supply" property to work,
today this property was managed by Ethernet glue, but should be present
and managed in PHY node. So I will push second Ethernet in next step.

PHYs used are SMSC (LAN8742A)

Signed-off-by: Christophe Roullier <christophe.roullier@foss.st.com>
---
 arch/arm/boot/dts/st/stm32mp135f-dk.dts | 23 +++++++++++++++++++++++
 1 file changed, 23 insertions(+)

Comments

Marek Vasut June 10, 2024, 10:42 a.m. UTC | #1 
On 6/10/24 10:03 AM, Christophe Roullier wrote:
> Ethernet1: RMII with crystal
> Ethernet2: RMII with no cristal

crystal, with Y

With that fixed:

Reviewed-by: Marek Vasut <marex@denx.de>
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/st/stm32mp135f-dk.dts b/arch/arm/boot/dts/st/stm32mp135f-dk.dts
index 567e53ad285fa..cf65d09e89156 100644
--- a/arch/arm/boot/dts/st/stm32mp135f-dk.dts
+++ b/arch/arm/boot/dts/st/stm32mp135f-dk.dts
@@ -19,6 +19,7 @@  / {
 	compatible = "st,stm32mp135f-dk", "st,stm32mp135";
 
 	aliases {
+		ethernet0 = &ethernet1;
 		serial0 = &uart4;
 		serial1 = &usart1;
 		serial2 = &uart8;
@@ -141,6 +142,28 @@  &cryp {
 	status = "okay";
 };
 
+&ethernet1 {
+	status = "okay";
+	pinctrl-0 = <&eth1_rmii_pins_a>;
+	pinctrl-1 = <&eth1_rmii_sleep_pins_a>;
+	pinctrl-names = "default", "sleep";
+	phy-mode = "rmii";
+	phy-handle = <&phy0_eth1>;
+
+	mdio {
+		#address-cells = <1>;
+		#size-cells = <0>;
+		compatible = "snps,dwmac-mdio";
+
+		phy0_eth1: ethernet-phy@0 {
+			compatible = "ethernet-phy-id0007.c131";
+			reg = <0>;
+			reset-gpios = <&mcp23017 9 GPIO_ACTIVE_LOW>;
+			wakeup-source;
+		};
+	};
+};
+
 &i2c1 {
 	pinctrl-names = "default", "sleep";
 	pinctrl-0 = <&i2c1_pins_a>;