diff mbox series

[v1,5/8] PCI: brcmstb: Two more register offsets vary by SOC

Message ID 20240628205430.24775-6-james.quinlan@broadcom.com (mailing list archive)
State New, archived
Headers show
Series PCI: brcnstb: Enable STB 7712 SOC | expand

Commit Message

Jim Quinlan June 28, 2024, 8:54 p.m. UTC 
Our HW design has again changed a register offset which used to be standard
for all Broadcom SOCs with PCIe cores.  This difference is now reconciled.

Signed-off-by: Jim Quinlan <james.quinlan@broadcom.com>
---
 drivers/pci/controller/pcie-brcmstb.c | 33 +++++++++++++++++----------
 1 file changed, 21 insertions(+), 12 deletions(-)

Comments

Bjorn Helgaas July 1, 2024, 5:32 p.m. UTC | #1 
Could mention the registers in the subject, e.g.,

  PCI: brcmstb: Make HARD_DEBUG, INTR2_CPU_BASE offsets SoC-specific

On Fri, Jun 28, 2024 at 04:54:24PM -0400, Jim Quinlan wrote:
> Our HW design has again changed a register offset which used to be standard
> for all Broadcom SOCs with PCIe cores.  This difference is now reconciled.
> 
> Signed-off-by: Jim Quinlan <james.quinlan@broadcom.com>
diff mbox series

Patch

diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
index 0f1c3e1effb1..4e0848e1311f 100644
--- a/drivers/pci/controller/pcie-brcmstb.c
+++ b/drivers/pci/controller/pcie-brcmstb.c
@@ -122,7 +122,6 @@ 
 #define PCIE_MEM_WIN0_LIMIT_HI(win)	\
 		PCIE_MISC_CPU_2_PCIE_MEM_WIN0_LIMIT_HI + ((win) * 8)
 
-#define PCIE_MISC_HARD_PCIE_HARD_DEBUG					0x4204
 #define  PCIE_MISC_HARD_PCIE_HARD_DEBUG_CLKREQ_DEBUG_ENABLE_MASK	0x2
 #define  PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK		0x200000
 #define  PCIE_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK		0x08000000
@@ -131,9 +130,9 @@ 
 	  (PCIE_MISC_HARD_PCIE_HARD_DEBUG_CLKREQ_DEBUG_ENABLE_MASK | \
 	   PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK)
 
-#define PCIE_INTR2_CPU_BASE		0x4300
 #define PCIE_MSI_INTR2_BASE		0x4500
-/* Offsets from PCIE_INTR2_CPU_BASE and PCIE_MSI_INTR2_BASE */
+
+/* Offsets from INTR2_CPU and MSI_INTR2 BASE offsets */
 #define  MSI_INT_STATUS			0x0
 #define  MSI_INT_CLR			0x8
 #define  MSI_INT_MASK_SET		0x10
@@ -187,6 +186,8 @@ 
 #define IDX_ADDR(pcie)			(pcie->reg_offsets[EXT_CFG_INDEX])
 #define DATA_ADDR(pcie)			(pcie->reg_offsets[EXT_CFG_DATA])
 #define PCIE_RGR1_SW_INIT_1(pcie)	(pcie->reg_offsets[RGR1_SW_INIT_1])
+#define	HARD_DEBUG(pcie)		(pcie->reg_offsets[PCIE_HARD_DEBUG])
+#define	INTR2_CPU_BASE(pcie)		(pcie->reg_offsets[PCIE_INTR2_CPU_BASE])
 
 /* Rescal registers */
 #define PCIE_DVT_PMU_PCIE_PHY_CTRL				0xc700
@@ -210,6 +211,8 @@  enum {
 enum {
 	RGR1_SW_INIT_1_INIT_MASK,
 	RGR1_SW_INIT_1_INIT_SHIFT,
+	PCIE_HARD_DEBUG,
+	PCIE_INTR2_CPU_BASE,
 };
 
 enum pcie_type {
@@ -651,7 +654,7 @@  static int brcm_pcie_enable_msi(struct brcm_pcie *pcie)
 	BUILD_BUG_ON(BRCM_INT_PCI_MSI_LEGACY_NR > BRCM_INT_PCI_MSI_NR);
 
 	if (msi->legacy) {
-		msi->intr_base = msi->base + PCIE_INTR2_CPU_BASE;
+		msi->intr_base = msi->base + INTR2_CPU_BASE(pcie);
 		msi->nr = BRCM_INT_PCI_MSI_LEGACY_NR;
 		msi->legacy_shift = 24;
 	} else {
@@ -898,12 +901,12 @@  static int brcm_pcie_setup(struct brcm_pcie *pcie)
 	/* Take the bridge out of reset */
 	pcie->bridge_sw_init_set(pcie, 0);
 
-	tmp = readl(base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+	tmp = readl(base + HARD_DEBUG(pcie));
 	if (is_bmips(pcie))
 		tmp &= ~PCIE_BMIPS_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK;
 	else
 		tmp &= ~PCIE_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK;
-	writel(tmp, base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+	writel(tmp, base + HARD_DEBUG(pcie));
 	/* Wait for SerDes to be stable */
 	usleep_range(100, 200);
 
@@ -1072,7 +1075,7 @@  static void brcm_config_clkreq(struct brcm_pcie *pcie)
 	}
 
 	/* Start out assuming safe mode (both mode bits cleared) */
-	clkreq_cntl = readl(pcie->base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+	clkreq_cntl = readl(pcie->base + HARD_DEBUG(pcie));
 	clkreq_cntl &= ~PCIE_CLKREQ_MASK;
 
 	if (strcmp(mode, "no-l1ss") == 0) {
@@ -1115,7 +1118,7 @@  static void brcm_config_clkreq(struct brcm_pcie *pcie)
 			dev_err(pcie->dev, err_msg);
 		mode = "safe";
 	}
-	writel(clkreq_cntl, pcie->base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+	writel(clkreq_cntl, pcie->base + HARD_DEBUG(pcie));
 
 	dev_info(pcie->dev, "clkreq-mode set to %s\n", mode);
 }
@@ -1337,9 +1340,9 @@  static void brcm_pcie_turn_off(struct brcm_pcie *pcie)
 	writel(tmp, base + PCIE_MISC_PCIE_CTRL);
 
 	/* Turn off SerDes */
-	tmp = readl(base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+	tmp = readl(base + HARD_DEBUG(pcie));
 	u32p_replace_bits(&tmp, 1, PCIE_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK);
-	writel(tmp, base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+	writel(tmp, base + HARD_DEBUG(pcie));
 
 	/* Shutdown PCIe bridge */
 	pcie->bridge_sw_init_set(pcie, 1);
@@ -1425,9 +1428,9 @@  static int brcm_pcie_resume_noirq(struct device *dev)
 	pcie->bridge_sw_init_set(pcie, 0);
 
 	/* SERDES_IDDQ = 0 */
-	tmp = readl(base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+	tmp = readl(base + HARD_DEBUG(pcie));
 	u32p_replace_bits(&tmp, 0, PCIE_MISC_HARD_PCIE_HARD_DEBUG_SERDES_IDDQ_MASK);
-	writel(tmp, base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
+	writel(tmp, base + HARD_DEBUG(pcie));
 
 	/* wait for serdes to be stable */
 	udelay(100);
@@ -1499,12 +1502,16 @@  static const int pcie_offsets[] = {
 	[RGR1_SW_INIT_1] = 0x9210,
 	[EXT_CFG_INDEX]  = 0x9000,
 	[EXT_CFG_DATA]   = 0x9004,
+	[PCIE_HARD_DEBUG] = 0x4204,
+	[PCIE_INTR2_CPU_BASE] = 0x4300,
 };
 
 static const int pcie_offsets_bmips_7425[] = {
 	[RGR1_SW_INIT_1] = 0x8010,
 	[EXT_CFG_INDEX]  = 0x8300,
 	[EXT_CFG_DATA]   = 0x8304,
+	[PCIE_HARD_DEBUG] = 0x4204,
+	[PCIE_INTR2_CPU_BASE] = 0x4300,
 };
 
 static const struct pcie_cfg_data generic_cfg = {
@@ -1539,6 +1546,8 @@  static const int pcie_offset_bcm7278[] = {
 	[RGR1_SW_INIT_1] = 0xc010,
 	[EXT_CFG_INDEX] = 0x9000,
 	[EXT_CFG_DATA] = 0x9004,
+	[PCIE_HARD_DEBUG] = 0x4204,
+	[PCIE_INTR2_CPU_BASE] = 0x4300,
 };
 
 static const struct pcie_cfg_data bcm7278_cfg = {