diff mbox series

[v1,4/5] gpio: stmpe: Make use of device properties

Message ID 20240902133148.2569486-5-andriy.shevchenko@linux.intel.com (mailing list archive)
State New, archived
Headers show
Series gpio: stmpe: A few cleanups | expand

Commit Message

Andy Shevchenko Sept. 2, 2024, 1:30 p.m. UTC 
Convert the module to be property provider agnostic and allow
it to be used on non-OF platforms.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 drivers/gpio/gpio-stmpe.c | 6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)

Comments

Linus Walleij Sept. 5, 2024, 11:35 a.m. UTC | #1 
On Mon, Sep 2, 2024 at 3:32 PM Andy Shevchenko
<andriy.shevchenko@linux.intel.com> wrote:

> Convert the module to be property provider agnostic and allow
> it to be used on non-OF platforms.
>
> Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>

Reviewed-by: Linus Walleij <linus.walleij@linaro.org>

Yours,
Linus Walleij
diff mbox series

Patch

diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
index 7f2911c478ea..c1fb06925e09 100644
--- a/drivers/gpio/gpio-stmpe.c
+++ b/drivers/gpio/gpio-stmpe.c
@@ -11,8 +11,8 @@ 
 #include <linux/slab.h>
 #include <linux/gpio/driver.h>
 #include <linux/interrupt.h>
-#include <linux/of.h>
 #include <linux/mfd/stmpe.h>
+#include <linux/property.h>
 #include <linux/seq_file.h>
 #include <linux/bitops.h>
 
@@ -465,7 +465,6 @@  static int stmpe_gpio_probe(struct platform_device *pdev)
 {
 	struct device *dev = &pdev->dev;
 	struct stmpe *stmpe = dev_get_drvdata(dev->parent);
-	struct device_node *np = dev->of_node;
 	struct stmpe_gpio *stmpe_gpio;
 	int ret, irq;
 
@@ -489,8 +488,7 @@  static int stmpe_gpio_probe(struct platform_device *pdev)
 	if (IS_ENABLED(CONFIG_DEBUG_FS))
                 stmpe_gpio->chip.dbg_show = stmpe_dbg_show;
 
-	of_property_read_u32(np, "st,norequest-mask",
-			&stmpe_gpio->norequest_mask);
+	device_property_read_u32(dev, "st,norequest-mask", &stmpe_gpio->norequest_mask);
 
 	ret = stmpe_enable(stmpe, STMPE_BLOCK_GPIO);
 	if (ret)