@@ -1040,7 +1040,7 @@ static int btintel_download_firmware_payload(struct hci_dev *hdev,
* as needed.
*
* Send set of commands with 4 byte alignment from the
- * firmware data buffer as a single Data fragement.
+ * firmware data buffer as a single Data fragment.
*/
if (!(frag_len % 4)) {
err = btintel_secure_send(hdev, 0x01, frag_len, fw_ptr);
@@ -2835,7 +2835,7 @@ void btintel_set_msft_opcode(struct hci_dev *hdev, u8 hw_variant)
case 0x12: /* ThP */
case 0x13: /* HrP */
case 0x14: /* CcP */
- /* All Intel new genration controllers support the Microsoft vendor
+ /* All Intel new generation controllers support the Microsoft vendor
* extension are using 0xFC1E for VsMsftOpCode.
*/
case 0x17:
@@ -324,7 +324,7 @@ int btmtk_setup_firmware(struct hci_dev *hdev, const char *fwname,
wmt_params.data = NULL;
wmt_params.status = NULL;
- /* Activate funciton the firmware providing to */
+ /* Activate function the firmware providing to */
err = wmt_cmd_sync(hdev, &wmt_params);
if (err < 0) {
bt_dev_err(hdev, "Failed to send wmt rst (%d)", err);
@@ -681,7 +681,7 @@ static int btmtksdio_open(struct hci_dev *hdev)
if (err < 0)
goto err_release_irq;
- /* Explitly set write-1-clear method */
+ /* Explicitly set write-1-clear method */
val = sdio_readl(bdev->func, MTK_REG_CHCR, &err);
if (err < 0)
goto err_release_irq;
@@ -1396,7 +1396,7 @@ static int btmtksdio_probe(struct sdio_func *func,
if (pm_runtime_enabled(bdev->dev))
pm_runtime_disable(bdev->dev);
- /* As explaination in drivers/mmc/core/sdio_bus.c tells us:
+ /* As explanation in drivers/mmc/core/sdio_bus.c tells us:
* Unbound SDIO functions are always suspended.
* During probe, the function is set active and the usage count
* is incremented. If the driver supports runtime PM,
@@ -327,7 +327,7 @@ mtk_stp_split(struct btmtkuart_dev *bdev, const unsigned char *data, int count,
if (count <= 0)
return NULL;
- /* Tranlate to how much the size of data H4 can handle so far */
+ /* Translate to how much the size of data H4 can handle so far */
*sz_h4 = min_t(int, count, bdev->stp_dlen);
/* Update the remaining size of STP packet */
@@ -1070,7 +1070,7 @@ static inline void btusb_free_frags(struct btusb_data *data)
static int btusb_recv_event(struct btusb_data *data, struct sk_buff *skb)
{
if (data->intr_interval) {
- /* Trigger dequeue immediatelly if an event is received */
+ /* Trigger dequeue immediately if an event is received */
schedule_delayed_work(&data->rx_work, 0);
}
@@ -594,7 +594,7 @@ static void hci_uart_tty_wakeup(struct tty_struct *tty)
* Called by tty low level driver when receive data is
* available.
*
- * Arguments: tty pointer to tty isntance data
+ * Arguments: tty pointer to tty instance data
* data pointer to received data
* flags pointer to flags for data
* count count of received data in bytes
@@ -305,7 +305,7 @@ static void ll_device_woke_up(struct hci_uart *hu)
hci_uart_tx_wakeup(hu);
}
-/* Enqueue frame for transmittion (padding, crc, etc) */
+/* Enqueue frame for transmission (padding, crc, etc) */
/* may be called from two simultaneous tasklets */
static int ll_enqueue(struct hci_uart *hu, struct sk_buff *skb)
{
@@ -501,7 +501,7 @@ static int nokia_close(struct hci_uart *hu)
return 0;
}
-/* Enqueue frame for transmittion (padding, crc, etc) */
+/* Enqueue frame for transmission (padding, crc, etc) */
static int nokia_enqueue(struct hci_uart *hu, struct sk_buff *skb)
{
struct nokia_bt_dev *btdev = hu->priv;
@@ -873,7 +873,7 @@ static void device_woke_up(struct hci_uart *hu)
hci_uart_tx_wakeup(hu);
}
-/* Enqueue frame for transmittion (padding, crc, etc) may be called from
+/* Enqueue frame for transmission (padding, crc, etc) may be called from
* two simultaneous tasklets.
*/
static int qca_enqueue(struct hci_uart *hu, struct sk_buff *skb)
@@ -1059,7 +1059,7 @@ static void qca_controller_memdump(struct work_struct *work)
if (!seq_no) {
/* This is the first frame of memdump packet from
- * the controller, Disable IBS to recevie dump
+ * the controller, Disable IBS to receive dump
* with out any interruption, ideally time required for
* the controller to send the dump is 8 seconds. let us
* start timer to handle this asynchronous activity.
@@ -2358,7 +2358,7 @@ static int qca_serdev_probe(struct serdev_device *serdev)
* Backward compatibility with old DT sources. If the
* node doesn't have the 'enable-gpios' property then
* let's use the power sequencer. Otherwise, let's
- * drive everything outselves.
+ * drive everything ourselves.
*/
qcadev->bt_power->pwrseq = devm_pwrseq_get(&serdev->dev,
"bluetooth");
@@ -2530,7 +2530,7 @@ static void qca_serdev_shutdown(struct device *dev)
hci_dev_test_flag(hdev, HCI_SETUP))
return;
- /* The serdev must be in open state when conrol logic arrives
+ /* The serdev must be in open state when control logic arrives
* here, so also fix the use-after-free issue caused by that
* the serdev is flushed or wrote after it is closed.
*/
Correctly spelled comments make it easier for the reader to understand the code. Fix typos: 'fragement' ==> 'fragment', 'genration' ==> 'generation', 'funciton' ==> 'function', 'Explitly' ==> 'Explicitly', 'explaination' ==> 'explanation', 'Tranlate' ==> 'Translate', 'immediatelly' ==> 'immediately', 'isntance' ==> 'instance', 'transmittion' ==> 'transmission', 'recevie' ==> 'receive', 'outselves' ==> 'ourselves', 'conrol' ==> 'control'. Signed-off-by: Yan Zhen <yanzhen@vivo.com> --- drivers/bluetooth/btintel.c | 4 ++-- drivers/bluetooth/btmtk.c | 2 +- drivers/bluetooth/btmtksdio.c | 4 ++-- drivers/bluetooth/btmtkuart.c | 2 +- drivers/bluetooth/btusb.c | 2 +- drivers/bluetooth/hci_ldisc.c | 2 +- drivers/bluetooth/hci_ll.c | 2 +- drivers/bluetooth/hci_nokia.c | 2 +- drivers/bluetooth/hci_qca.c | 8 ++++---- 9 files changed, 14 insertions(+), 14 deletions(-)