| Message ID | 1349335709-13399-1-git-send-email-linus.walleij@linaro.org (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On Thu, Oct 4, 2012 at 9:28 AM, Linus Walleij <linus.walleij@linaro.org> wrote: > The Nomadik NAND driver is really just a subset of the existing > FSMC driver, so let's switch over to using that driver instead, > since it handles more variants of this chip. The callbacks for > setting up the chip is doing stuff now handled by the FSMC > driver. > > Cc: Alessandro Rubini <rubini@unipv.it> > Signed-off-by: Linus Walleij <linus.walleij@linaro.org> > --- > I'm requesting Mike Turquette's ACK on this patch so I can merge > it through ARM SoC. Still requesting Mike's ACK, but not for merging through ARM SoC but through MTD. If you apply Jean-Christophe's patch first (please do that) I will send a v2 of this patch set to be applied onto MTD as well (should be OK). Yours, Linus Walleij
>> The Nomadik NAND driver is really just a subset of the existing >> FSMC driver, >> >> Cc: Alessandro Rubini <rubini@unipv.it> > Still requesting Mike's ACK, but not for merging through ARM SoC > but through MTD. Oh, and please get mine too. Sorry for not noticing the message, busy times... I'm pretty sure there was no fsmc driver back then. But clearly something coming from the vendor and used on several boards is better then something made by an external consultant for a specific evaluation board. So ok to ditch my nand driver. Acked-by: Alessandro Rubini <rubini@unipv.it>
On Thu, 2012-10-04 at 09:28 +0200, Linus Walleij wrote: > The Nomadik NAND driver is really just a subset of the existing > FSMC driver, so let's switch over to using that driver instead, > since it handles more variants of this chip. The callbacks for > setting up the chip is doing stuff now handled by the FSMC > driver. > > Cc: Alessandro Rubini <rubini@unipv.it> > Signed-off-by: Linus Walleij <linus.walleij@linaro.org> Pushed both to l2-mtd.git, thanks!
On 14:07 Thu 11 Oct , Artem Bityutskiy wrote: > On Thu, 2012-10-04 at 09:28 +0200, Linus Walleij wrote: > > The Nomadik NAND driver is really just a subset of the existing > > FSMC driver, so let's switch over to using that driver instead, > > since it handles more variants of this chip. The callbacks for > > setting up the chip is doing stuff now handled by the FSMC > > driver. > > > > Cc: Alessandro Rubini <rubini@unipv.it> > > Signed-off-by: Linus Walleij <linus.walleij@linaro.org> > > Pushed both to l2-mtd.git, thanks! wait on this one Linus said he will send an other version based on my patch for fmsc Best Regards, J. > > -- > Best Regards, > Artem Bityutskiy > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-kernel@lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
On Thu, Oct 11, 2012 at 8:04 PM, Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com> wrote: > On 14:07 Thu 11 Oct , Artem Bityutskiy wrote: >> >> Pushed both to l2-mtd.git, thanks! > > wait on this one Linus said he will send an other version based on my patch > for fmsc I made a fix-up patch instead, that's simpler I guess... mailing out now. Thanks, Linus Walleij
Quoting Linus Walleij (2012-10-05 05:52:06) > On Thu, Oct 4, 2012 at 9:28 AM, Linus Walleij <linus.walleij@linaro.org> wrote: > > > The Nomadik NAND driver is really just a subset of the existing > > FSMC driver, so let's switch over to using that driver instead, > > since it handles more variants of this chip. The callbacks for > > setting up the chip is doing stuff now handled by the FSMC > > driver. > > > > Cc: Alessandro Rubini <rubini@unipv.it> > > Signed-off-by: Linus Walleij <linus.walleij@linaro.org> > > --- > > I'm requesting Mike Turquette's ACK on this patch so I can merge > > it through ARM SoC. > > Still requesting Mike's ACK, but not for merging through ARM SoC > but through MTD. > Sorry for the late response but I just returned from vacation. Might be too late but: Acked-by: Mike Turquette <mturquette@linaro.org> Thanks, Mike > If you apply Jean-Christophe's patch first (please do that) I will > send a v2 of this patch set to be applied onto MTD as well > (should be OK). > > Yours, > Linus Walleij
diff --git a/arch/arm/configs/nhk8815_defconfig b/arch/arm/configs/nhk8815_defconfig index bf123c5..9a8adfd 100644 --- a/arch/arm/configs/nhk8815_defconfig +++ b/arch/arm/configs/nhk8815_defconfig @@ -58,7 +58,7 @@ CONFIG_MTD_BLOCK=y CONFIG_MTD_NAND=y CONFIG_MTD_NAND_ECC_SMC=y CONFIG_MTD_NAND_VERIFY_WRITE=y -CONFIG_MTD_NAND_NOMADIK=y +CONFIG_MTD_NAND_FSMC=y CONFIG_MTD_ONENAND=y CONFIG_MTD_ONENAND_VERIFY_WRITE=y CONFIG_MTD_ONENAND_GENERIC=y diff --git a/arch/arm/mach-nomadik/board-nhk8815.c b/arch/arm/mach-nomadik/board-nhk8815.c index bfa1eab..a105d1b 100644 --- a/arch/arm/mach-nomadik/board-nhk8815.c +++ b/arch/arm/mach-nomadik/board-nhk8815.c @@ -19,6 +19,7 @@ #include <linux/gpio.h> #include <linux/mtd/mtd.h> #include <linux/mtd/nand.h> +#include <linux/mtd/fsmc.h> #include <linux/mtd/onenand.h> #include <linux/mtd/partitions.h> #include <linux/i2c.h> @@ -36,7 +37,6 @@ #include <plat/mtu.h> #include <plat/pincfg.h> -#include <linux/platform_data/mtd-nomadik-nand.h> #include <mach/fsmc.h> #include "cpu-8815.h" @@ -48,36 +48,18 @@ /* These addresses span 16MB, so use three individual pages */ static struct resource nhk8815_nand_resources[] = { { - .name = "nand_addr", - .start = NAND_IO_ADDR, - .end = NAND_IO_ADDR + 0xfff, - .flags = IORESOURCE_MEM, - }, { - .name = "nand_cmd", - .start = NAND_IO_CMD, - .end = NAND_IO_CMD + 0xfff, + .name = "nand_data", + .start = 0x40000000, + .end = 0x40000000 + SZ_16K - 1, .flags = IORESOURCE_MEM, }, { - .name = "nand_data", - .start = NAND_IO_DATA, - .end = NAND_IO_DATA + 0xfff, + .name = "fsmc_regs", + .start = NOMADIK_FSMC_BASE, + .end = NOMADIK_FSMC_BASE + SZ_4K - 1, .flags = IORESOURCE_MEM, - } + }, }; -static int nhk8815_nand_init(void) -{ - /* FSMC setup for nand chip select (8-bit nand in 8815NHK) */ - writel(0x0000000E, FSMC_PCR(0)); - writel(0x000D0A00, FSMC_PMEM(0)); - writel(0x00100A00, FSMC_PATT(0)); - - /* enable access to the chip select area */ - writel(readl(FSMC_PCR(0)) | 0x04, FSMC_PCR(0)); - - return 0; -} - /* * These partitions are the same as those used in the 2.6.20 release * shipped by the vendor; the first two partitions are mandated @@ -111,20 +93,30 @@ static struct mtd_partition nhk8815_partitions[] = { } }; -static struct nomadik_nand_platform_data nhk8815_nand_data = { - .parts = nhk8815_partitions, - .nparts = ARRAY_SIZE(nhk8815_partitions), - .options = NAND_COPYBACK | NAND_CACHEPRG | NAND_NO_PADDING, - .init = nhk8815_nand_init, +static struct fsmc_nand_timings nhk8815_nand_timings = { + .thiz = 0, + .thold = 0x10, + .twait = 0x0A, + .tset = 0, +}; + +static struct fsmc_nand_platform_data nhk8815_nand_platform_data = { + .nand_timings = &nhk8815_nand_timings, + .partitions = nhk8815_partitions, + .nr_partitions = ARRAY_SIZE(nhk8815_partitions), + .width = FSMC_NAND_BW8, + .ale_off = 0x1000000, + .cle_off = 0x800000, }; static struct platform_device nhk8815_nand_device = { - .name = "nomadik_nand", - .dev = { - .platform_data = &nhk8815_nand_data, + .name = "fsmc-nand", + .id = -1, + .resource = nhk8815_nand_resources, + .num_resources = ARRAY_SIZE(nhk8815_nand_resources), + .dev = { + .platform_data = &nhk8815_nand_platform_data, }, - .resource = nhk8815_nand_resources, - .num_resources = ARRAY_SIZE(nhk8815_nand_resources), }; /* These are the partitions for the OneNand device, different from above */ diff --git a/arch/arm/mach-nomadik/include/mach/fsmc.h b/arch/arm/mach-nomadik/include/mach/fsmc.h deleted file mode 100644 index 8c2c051..0000000 --- a/arch/arm/mach-nomadik/include/mach/fsmc.h +++ /dev/null @@ -1,29 +0,0 @@ - -/* Definitions for the Nomadik FSMC "Flexible Static Memory controller" */ - -#ifndef __ASM_ARCH_FSMC_H -#define __ASM_ARCH_FSMC_H - -#include <mach/hardware.h> -/* - * Register list - */ - -/* bus control reg. and bus timing reg. for CS0..CS3 */ -#define FSMC_BCR(x) (NOMADIK_FSMC_VA + (x << 3)) -#define FSMC_BTR(x) (NOMADIK_FSMC_VA + (x << 3) + 0x04) - -/* PC-card and NAND: - * PCR = control register - * PMEM = memory timing - * PATT = attribute timing - * PIO = I/O timing - * PECCR = ECC result - */ -#define FSMC_PCR(x) (NOMADIK_FSMC_VA + ((2 + x) << 5) + 0x00) -#define FSMC_PMEM(x) (NOMADIK_FSMC_VA + ((2 + x) << 5) + 0x08) -#define FSMC_PATT(x) (NOMADIK_FSMC_VA + ((2 + x) << 5) + 0x0c) -#define FSMC_PIO(x) (NOMADIK_FSMC_VA + ((2 + x) << 5) + 0x10) -#define FSMC_PECCR(x) (NOMADIK_FSMC_VA + ((2 + x) << 5) + 0x14) - -#endif /* __ASM_ARCH_FSMC_H */ diff --git a/drivers/clk/clk-nomadik.c b/drivers/clk/clk-nomadik.c index 517a8ff..6b4c70f 100644 --- a/drivers/clk/clk-nomadik.c +++ b/drivers/clk/clk-nomadik.c @@ -20,6 +20,7 @@ void __init nomadik_clk_init(void) clk_register_clkdev(clk, NULL, "gpio.2"); clk_register_clkdev(clk, NULL, "gpio.3"); clk_register_clkdev(clk, NULL, "rng"); + clk_register_clkdev(clk, NULL, "fsmc-nand"); /* * The 2.4 MHz TIMCLK reference clock is active at boot time, this is
The Nomadik NAND driver is really just a subset of the existing FSMC driver, so let's switch over to using that driver instead, since it handles more variants of this chip. The callbacks for setting up the chip is doing stuff now handled by the FSMC driver. Cc: Alessandro Rubini <rubini@unipv.it> Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- I'm requesting Mike Turquette's ACK on this patch so I can merge it through ARM SoC. --- arch/arm/configs/nhk8815_defconfig | 2 +- arch/arm/mach-nomadik/board-nhk8815.c | 64 ++++++++++++++----------------- arch/arm/mach-nomadik/include/mach/fsmc.h | 29 -------------- drivers/clk/clk-nomadik.c | 1 + 4 files changed, 30 insertions(+), 66 deletions(-) delete mode 100644 arch/arm/mach-nomadik/include/mach/fsmc.h