| Message ID | 1355129761-8088-8-git-send-email-lee.jones@linaro.org (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On Mon, Dec 10, 2012 at 9:55 AM, Lee Jones <lee.jones@linaro.org> wrote: > If not specified, the GPIO control bit is inverted by default i.e. > low-enable and high-disable. This is not the case with the MMCI > regulator, hence it will turn on during a disable and off when > regulator_enable() is invoked. > > Signed-off-by: Lee Jones <lee.jones@linaro.org> Acked-by: Linus Walleij <linus.walleij@linaro.org> Yours, Linus Walleij
diff --git a/arch/arm/boot/dts/dbx5x0.dtsi b/arch/arm/boot/dts/dbx5x0.dtsi index bbea89a..0523681 100644 --- a/arch/arm/boot/dts/dbx5x0.dtsi +++ b/arch/arm/boot/dts/dbx5x0.dtsi @@ -638,6 +638,8 @@ regulator-name = "mmci-reg"; regulator-type = "voltage"; + enable-active-high; + states = <1800000 0x1 3300000 0x0>;
If not specified, the GPIO control bit is inverted by default i.e. low-enable and high-disable. This is not the case with the MMCI regulator, hence it will turn on during a disable and off when regulator_enable() is invoked. Signed-off-by: Lee Jones <lee.jones@linaro.org> --- arch/arm/boot/dts/dbx5x0.dtsi | 2 ++ 1 file changed, 2 insertions(+)