new file mode 100644
@@ -0,0 +1,17 @@
+MSM SoC HSUSB controllers
+
+EHCI
+
+Required properties:
+- compatible: Should contain "qcom,ehci-host"
+- regs: offset and length of the register set in the memory map
+- usb-phy: phandle for the PHY device
+
+Example EHCI controller device node:
+
+ ehci: ehci@f9a55000 {
+ compatible = "qcom,ehci-host";
+ reg = <0xf9a55000 0x400>;
+ usb-phy = <&usb_otg>;
+ };
+
@@ -108,10 +108,14 @@ static int ehci_msm_probe(struct platform_device *pdev)
* powering up VBUS, mapping of registers address space and power
* management.
*/
- phy = devm_usb_get_phy(&pdev->dev, USB_PHY_TYPE_USB2);
+ if (pdev->dev.of_node)
+ phy = devm_usb_get_phy_by_phandle(&pdev->dev, "usb-phy", 0);
+ else
+ phy = devm_usb_get_phy(&pdev->dev, USB_PHY_TYPE_USB2);
+
if (IS_ERR(phy)) {
dev_err(&pdev->dev, "unable to find transceiver\n");
- ret = -ENODEV;
+ ret = -EPROBE_DEFER;
goto put_hcd;
}
@@ -187,12 +191,19 @@ static const struct dev_pm_ops ehci_msm_dev_pm_ops = {
.resume = ehci_msm_pm_resume,
};
+static struct of_device_id msm_ehci_dt_match[] = {
+ { .compatible = "qcom,ehci-host", },
+ {}
+};
+MODULE_DEVICE_TABLE(of, msm_ehci_dt_match);
+
static struct platform_driver ehci_msm_driver = {
.probe = ehci_msm_probe,
.remove = ehci_msm_remove,
.driver = {
.name = "msm_hsusb_host",
.pm = &ehci_msm_dev_pm_ops,
+ .of_match_table = msm_ehci_dt_match,
},
};