@@ -160,6 +160,13 @@ config NR_CPUS
default "8" if ARCH_XGENE
default "4"
+config HOTPLUG_CPU
+ bool "Support for hot-pluggable CPUs"
+ depends on SMP
+ help
+ Say Y here to experiment with turning CPUs off and on. CPUs
+ can be controlled through /sys/devices/system/cpu.
+
source kernel/Kconfig.preempt
config HZ
@@ -34,6 +34,11 @@ struct device_node;
* @cpu_boot: Boots a cpu into the kernel.
* @cpu_postboot: Optionally, perform any post-boot cleanup or necesary
* synchronisation. Called from the cpu being booted.
+ * @cpu_disable: Prepares a cpu to die. May fail for some mechanism-specific
+ * reason, which will cause the hot unplug to be aborted. Called
+ * from the cpu to be killed.
+ * @cpu_die: Makes the a leave the kernel. Must not fail. Called from the
+ * cpu being killed.
*/
struct cpu_operations {
const char *name;
@@ -41,6 +46,10 @@ struct cpu_operations {
int (*cpu_prepare)(unsigned int);
int (*cpu_boot)(unsigned int);
void (*cpu_postboot)(void);
+#ifdef CONFIG_HOTPLUG_CPU
+ int (*cpu_disable)(unsigned int cpu);
+ void (*cpu_die)(unsigned int cpu);
+#endif
};
extern const struct cpu_operations *cpu_ops[NR_CPUS];
@@ -4,6 +4,7 @@
#include <asm-generic/irq.h>
extern void (*handle_arch_irq)(struct pt_regs *);
+extern void migrate_irqs(void);
extern void set_handle_irq(void (*handle_irq)(struct pt_regs *));
#endif
@@ -65,4 +65,9 @@ extern void secondary_entry(void);
extern void arch_send_call_function_single_ipi(int cpu);
extern void arch_send_call_function_ipi_mask(const struct cpumask *mask);
+extern int __cpu_disable(void);
+
+extern void __cpu_die(unsigned int cpu);
+extern void cpu_die(void);
+
#endif /* ifndef __ASM_SMP_H */
@@ -22,7 +22,7 @@
extern unsigned long __cpu_setup(void);
-struct cpu_info __initdata cpu_table[] = {
+struct cpu_info cpu_table[] = {
{
.cpu_id_val = 0x000f0000,
.cpu_id_mask = 0x000f0000,
@@ -81,3 +81,64 @@ void __init init_IRQ(void)
if (!handle_arch_irq)
panic("No interrupt controller found.");
}
+
+#ifdef CONFIG_HOTPLUG_CPU
+static bool migrate_one_irq(struct irq_desc *desc)
+{
+ struct irq_data *d = irq_desc_get_irq_data(desc);
+ const struct cpumask *affinity = d->affinity;
+ struct irq_chip *c;
+ bool ret = false;
+
+ /*
+ * If this is a per-CPU interrupt, or the affinity does not
+ * include this CPU, then we have nothing to do.
+ */
+ if (irqd_is_per_cpu(d) || !cpumask_test_cpu(smp_processor_id(), affinity))
+ return false;
+
+ if (cpumask_any_and(affinity, cpu_online_mask) >= nr_cpu_ids) {
+ affinity = cpu_online_mask;
+ ret = true;
+ }
+
+ c = irq_data_get_irq_chip(d);
+ if (!c->irq_set_affinity)
+ pr_debug("IRQ%u: unable to set affinity\n", d->irq);
+ else if (c->irq_set_affinity(d, affinity, true) == IRQ_SET_MASK_OK && ret)
+ cpumask_copy(d->affinity, affinity);
+
+ return ret;
+}
+
+/*
+ * The current CPU has been marked offline. Migrate IRQs off this CPU.
+ * If the affinity settings do not allow other CPUs, force them onto any
+ * available CPU.
+ *
+ * Note: we must iterate over all IRQs, whether they have an attached
+ * action structure or not, as we need to get chained interrupts too.
+ */
+void migrate_irqs(void)
+{
+ unsigned int i;
+ struct irq_desc *desc;
+ unsigned long flags;
+
+ local_irq_save(flags);
+
+ for_each_irq_desc(i, desc) {
+ bool affinity_broken;
+
+ raw_spin_lock(&desc->lock);
+ affinity_broken = migrate_one_irq(desc);
+ raw_spin_unlock(&desc->lock);
+
+ if (affinity_broken)
+ pr_warn_ratelimited("IRQ%u no longer affine to CPU%u\n",
+ i, smp_processor_id());
+ }
+
+ local_irq_restore(flags);
+}
+#endif /* CONFIG_HOTPLUG_CPU */
@@ -102,6 +102,13 @@ void arch_cpu_idle(void)
local_irq_enable();
}
+#ifdef CONFIG_HOTPLUG_CPU
+void arch_cpu_idle_dead(void)
+{
+ cpu_die();
+}
+#endif
+
void machine_shutdown(void)
{
#ifdef CONFIG_SMP
@@ -167,6 +167,103 @@ asmlinkage void secondary_start_kernel(void)
cpu_startup_entry(CPUHP_ONLINE);
}
+#ifdef CONFIG_HOTPLUG_CPU
+static int op_cpu_disable(unsigned int cpu)
+{
+ /*
+ * If we don't have a cpu_die method, abort before we reach the point
+ * of no return. CPU0 may not have an cpu_ops, so test for it.
+ */
+ if (!cpu_ops[cpu] || !cpu_ops[cpu]->cpu_die)
+ return -EOPNOTSUPP;
+
+ /*
+ * We may need to abort a hot unplug for some other mechanism-specific
+ * reason.
+ */
+ if (cpu_ops[cpu]->cpu_disable)
+ return cpu_ops[cpu]->cpu_disable(cpu);
+
+ return 0;
+}
+
+/*
+ * __cpu_disable runs on the processor to be shutdown.
+ */
+int __cpu_disable(void)
+{
+ unsigned int cpu = smp_processor_id();
+ int ret;
+
+ ret = op_cpu_disable(cpu);
+ if (ret)
+ return ret;
+
+ /*
+ * Take this CPU offline. Once we clear this, we can't return,
+ * and we must not schedule until we're ready to give up the cpu.
+ */
+ set_cpu_online(cpu, false);
+
+ /*
+ * OK - migrate IRQs away from this CPU
+ */
+ migrate_irqs();
+
+ /*
+ * Remove this CPU from the vm mask set of all processes.
+ */
+ clear_tasks_mm_cpumask(cpu);
+
+ return 0;
+}
+
+static DECLARE_COMPLETION(cpu_died);
+
+/*
+ * called on the thread which is asking for a CPU to be shutdown -
+ * waits until shutdown has completed, or it is timed out.
+ */
+void __cpu_die(unsigned int cpu)
+{
+ if (!wait_for_completion_timeout(&cpu_died, msecs_to_jiffies(5000))) {
+ pr_crit("CPU%u: cpu didn't die\n", cpu);
+ return;
+ }
+ pr_notice("CPU%u: shutdown\n", cpu);
+}
+
+/*
+ * Called from the idle thread for the CPU which has been shutdown.
+ *
+ * Note that we disable IRQs here, but do not re-enable them
+ * before returning to the caller. This is also the behaviour
+ * of the other hotplug-cpu capable cores, so presumably coming
+ * out of idle fixes this.
+ */
+void __ref cpu_die(void)
+{
+ unsigned int cpu = smp_processor_id();
+
+ idle_task_exit();
+
+ local_irq_disable();
+ mb();
+
+ /* Tell __cpu_die() that this CPU is now safe to dispose of */
+ complete(&cpu_died);
+
+ /*
+ * Actually shutdown the CPU. This must never fail. The specific hotplug
+ * mechanism must perform all required cache maintenance to ensure that
+ * no dirty lines are lost in the process of shutting down the CPU.
+ */
+ cpu_ops[cpu]->cpu_die(cpu);
+
+ BUG();
+}
+#endif
+
void __init smp_cpus_done(unsigned int max_cpus)
{
pr_info("SMP: Total of %d processors activated.\n", num_online_cpus());
This patch adds the basic infrastructure necessary to support CPU_HOTPLUG on arm64, based on the arm implementation. Actual hotplug support will depend on an implementation's cpu_operations (e.g. PSCI). Signed-off-by: Mark Rutland <mark.rutland@arm.com> --- arch/arm64/Kconfig | 7 +++ arch/arm64/include/asm/cpu_ops.h | 9 ++++ arch/arm64/include/asm/irq.h | 1 + arch/arm64/include/asm/smp.h | 5 +++ arch/arm64/kernel/cputable.c | 2 +- arch/arm64/kernel/irq.c | 61 +++++++++++++++++++++++++ arch/arm64/kernel/process.c | 7 +++ arch/arm64/kernel/smp.c | 97 ++++++++++++++++++++++++++++++++++++++++ 8 files changed, 188 insertions(+), 1 deletion(-)