[v2,0/5] add NXP imx8mp usb support

Message

Jun Li July 6, 2020, 9:44 a.m. UTC

NXP imx8MPlus integrates 2 indentical dwc3 3.30b IP with additional wakeup
logic to support low power, this wakeup logic has a separated interrupt
which can generate events with suspend clock(32K); due to SoC integration
limitation, a few quriks required, instead of create new properties flags,
introduce platform data and pass it from glue layer to dwc3 core, those xhci
private data can further pass to xhci-plat.

Changes for v2:
- Drop the 2 patches for new property("snps,xhci-dis-64bit-support-quirk")
  introduction, as suggested, imply by SoC compatible string, this is done
  by introduce dwc3 core platform data and pass the xhci_plat_priv to
  xhci-plat for those xhci quirks, so a new patch added:
  [1/5] usb: dwc3: add platform data to dwc3 core device to pass data.
  this patch is based on Peter's one patch which is also in review:
  https://patchwork.kernel.org/patch/11640945/
- dts change, use the USB power function of TRL logic instead of a always-on
  regulator to control vbus on/off.
- Some changes to address Peter's command on patch [2/5].

Li Jun (5):
  usb: dwc3: add platform data to dwc3 core device to pass data
  usb: dwc3: add imx8mp dwc3 glue layer driver
  arm64: dtsi: imx8mp: add usb nodes
  arm64: dts: imx8mp-evk: enable usb1 as host mode
  dt-bindings: usb: dwc3-imx8mp: add imx8mp dwc3 glue bindings

 .../devicetree/bindings/usb/fsl,imx8mp-dwc3.yaml   |  87 +++++
 arch/arm64/boot/dts/freescale/imx8mp-evk.dts       |  21 ++
 arch/arm64/boot/dts/freescale/imx8mp.dtsi          |  77 +++++
 drivers/usb/dwc3/Kconfig                           |  10 +
 drivers/usb/dwc3/Makefile                          |   1 +
 drivers/usb/dwc3/core.h                            |   5 +
 drivers/usb/dwc3/dwc3-imx8mp.c                     | 374 +++++++++++++++++++++
 drivers/usb/dwc3/host.c                            |   9 +
 8 files changed, 584 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/usb/fsl,imx8mp-dwc3.yaml
 create mode 100644 drivers/usb/dwc3/dwc3-imx8mp.c