[1/6] musb: save OTG base physical address
diff mbox

Message ID 1274094488-15925-1-git-send-email-ajay.gupta@ti.com
State New, archived
Headers show

Commit Message

Ajay Kumar Gupta May 17, 2010, 11:08 a.m. UTC
None

Patch
diff mbox

diff --git a/drivers/usb/musb/musb_core.c b/drivers/usb/musb/musb_core.c
index 705cc4a..94e787c 100644
--- a/drivers/usb/musb/musb_core.c
+++ b/drivers/usb/musb/musb_core.c
@@ -1867,7 +1867,8 @@  static void musb_free(struct musb *musb)
  *	not yet corrected for platform-specific offsets
  */
 static int __init
-musb_init_controller(struct device *dev, int nIrq, void __iomem *ctrl)
+musb_init_controller(struct device *dev, int nIrq, void __iomem *ctrl,
+			phys_addr_t ctrl_phys_addr)
 {
 	int			status;
 	struct musb		*musb;
@@ -1919,6 +1920,7 @@  bad_config:
 	musb->board_set_power = plat->set_power;
 	musb->set_clock = plat->set_clock;
 	musb->min_power = plat->min_power;
+	musb->ctrl_phys_base = ctrl_phys_addr;
 
 	/* Clock usage is chip-specific ... functional clock (DaVinci,
 	 * OMAP2430), or PHY ref (some TUSB6010 boards).  All this core
@@ -2136,7 +2138,7 @@  static int __init musb_probe(struct platform_device *pdev)
 	/* clobbered by use_dma=n */
 	orig_dma_mask = dev->dma_mask;
 #endif
-	status = musb_init_controller(dev, irq, base);
+	status = musb_init_controller(dev, irq, base, iomem->start);
 	if (status < 0)
 		iounmap(base);
 
diff --git a/drivers/usb/musb/musb_core.h b/drivers/usb/musb/musb_core.h
index ac17b00..d001894 100644
--- a/drivers/usb/musb/musb_core.h
+++ b/drivers/usb/musb/musb_core.h
@@ -367,6 +367,7 @@  struct musb {
 
 	struct device		*controller;
 	void __iomem		*ctrl_base;
+	phys_addr_t		ctrl_phys_base;
 	void __iomem		*mregs;
 
 #ifdef CONFIG_USB_TUSB6010