@@ -12,10 +12,30 @@
/dts-v1/;
#include "imx6q.dtsi"
#include "imx6qdl-gw54xx.dtsi"
+#include <dt-bindings/media/tda1997x.h>
/ {
model = "Gateworks Ventana i.MX6 Dual/Quad GW54XX";
compatible = "gw,imx6q-gw54xx", "gw,ventana", "fsl,imx6q";
+
+ sound-digital {
+ compatible = "simple-audio-card";
+ simple-audio-card,name = "tda1997x-audio";
+
+ simple-audio-card,dai-link@0 {
+ format = "i2s";
+
+ cpu {
+ sound-dai = <&ssi2>;
+ };
+
+ codec {
+ bitclock-master;
+ frame-master;
+ sound-dai = <&tda1997x>;
+ };
+ };
+ };
};
&i2c3 {
@@ -35,6 +55,61 @@
};
};
};
+
+ tda1997x: codec@48 {
+ compatible = "nxp,tda19971";
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_tda1997x>;
+ reg = <0x48>;
+ interrupt-parent = <&gpio1>;
+ interrupts = <7 IRQ_TYPE_LEVEL_LOW>;
+ DOVDD-supply = <®_3p3v>;
+ AVDD-supply = <&sw4_reg>;
+ DVDD-supply = <&sw4_reg>;
+ #sound-dai-cells = <0>;
+ nxp,audout-format = "i2s";
+ nxp,audout-layout = <0>;
+ nxp,audout-width = <16>;
+ nxp,audout-mclk-fs = <128>;
+ /*
+ * The 8bpp YUV422 semi-planar mode outputs CbCr[11:4]
+ * and Y[11:4] across 16bits in the same cycle
+ * which we map to VP[15:08]<->CSI_DATA[19:12]
+ */
+ nxp,vidout-portcfg =
+ /*G_Y_11_8<->VP[15:12]<->CSI_DATA[19:16]*/
+ < TDA1997X_VP24_V15_12 TDA1997X_G_Y_11_8 >,
+ /*G_Y_7_4<->VP[11:08]<->CSI_DATA[15:12]*/
+ < TDA1997X_VP24_V11_08 TDA1997X_G_Y_7_4 >,
+ /*R_CR_CBCR_11_8<->VP[07:04]<->CSI_DATA[11:08]*/
+ < TDA1997X_VP24_V07_04 TDA1997X_R_CR_CBCR_11_8 >,
+ /*R_CR_CBCR_7_4<->VP[03:00]<->CSI_DATA[07:04]*/
+ < TDA1997X_VP24_V03_00 TDA1997X_R_CR_CBCR_7_4 >;
+
+ port {
+ tda1997x_to_ipu1_csi0_mux: endpoint {
+ remote-endpoint = <&ipu1_csi0_mux_from_parallel_sensor>;
+ bus-width = <16>;
+ hsync-active = <1>;
+ vsync-active = <1>;
+ data-active = <1>;
+ };
+ };
+ };
+};
+
+&ipu1_csi0_from_ipu1_csi0_mux {
+ bus-width = <16>;
+};
+
+&ipu1_csi0_mux_from_parallel_sensor {
+ remote-endpoint = <&tda1997x_to_ipu1_csi0_mux>;
+ bus-width = <16>;
+};
+
+&ipu1_csi0 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_ipu1_csi0>;
};
&ipu2_csi1_from_ipu2_csi1_mux {
@@ -63,6 +138,30 @@
>;
};
+ pinctrl_ipu1_csi0: ipu1_csi0grp {
+ fsl,pins = <
+ MX6QDL_PAD_CSI0_DAT4__IPU1_CSI0_DATA04 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT5__IPU1_CSI0_DATA05 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT6__IPU1_CSI0_DATA06 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT7__IPU1_CSI0_DATA07 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT8__IPU1_CSI0_DATA08 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT9__IPU1_CSI0_DATA09 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT10__IPU1_CSI0_DATA10 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT11__IPU1_CSI0_DATA11 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT12__IPU1_CSI0_DATA12 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT13__IPU1_CSI0_DATA13 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT14__IPU1_CSI0_DATA14 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT15__IPU1_CSI0_DATA15 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT16__IPU1_CSI0_DATA16 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT17__IPU1_CSI0_DATA17 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT18__IPU1_CSI0_DATA18 0x1b0b0
+ MX6QDL_PAD_CSI0_DAT19__IPU1_CSI0_DATA19 0x1b0b0
+ MX6QDL_PAD_CSI0_MCLK__IPU1_CSI0_HSYNC 0x1b0b0
+ MX6QDL_PAD_CSI0_PIXCLK__IPU1_CSI0_PIXCLK 0x1b0b0
+ MX6QDL_PAD_CSI0_VSYNC__IPU1_CSI0_VSYNC 0x1b0b0
+ >;
+ };
+
pinctrl_ipu2_csi1: ipu2_csi1grp {
fsl,pins = <
MX6QDL_PAD_EIM_EB2__IPU2_CSI1_DATA19 0x1b0b0
@@ -78,4 +177,10 @@
MX6QDL_PAD_EIM_A16__IPU2_CSI1_PIXCLK 0x1b0b0
>;
};
+
+ pinctrl_tda1997x: tda1997xgrp {
+ fsl,pins = <
+ MX6QDL_PAD_GPIO_7__GPIO1_IO07 0x1b0b0
+ >;
+ };
};
@@ -10,6 +10,7 @@
*/
#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/sound/fsl-imx-audmux.h>
/ {
/* these are used by bootloader for disabling nodes */
@@ -114,12 +115,12 @@
};
};
- sound {
+ sound-analog {
compatible = "fsl,imx6q-ventana-sgtl5000",
"fsl,imx-audio-sgtl5000";
model = "sgtl5000-audio";
ssi-controller = <&ssi1>;
- audio-codec = <&codec>;
+ audio-codec = <&sgtl5000>;
audio-routing =
"MIC_IN", "Mic Jack",
"Mic Jack", "Mic Bias",
@@ -133,6 +134,25 @@
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_audmux>; /* AUD4<->sgtl5000 */
status = "okay";
+
+ ssi2 {
+ fsl,audmux-port = <1>;
+ fsl,port-config = <
+ (IMX_AUDMUX_V2_PTCR_TFSDIR |
+ IMX_AUDMUX_V2_PTCR_TFSEL(4+8) | /* RXFS */
+ IMX_AUDMUX_V2_PTCR_TCLKDIR |
+ IMX_AUDMUX_V2_PTCR_TCSEL(4+8) | /* RXC */
+ IMX_AUDMUX_V2_PTCR_SYN)
+ IMX_AUDMUX_V2_PDCR_RXDSEL(4)
+ >;
+ };
+
+ aud5 {
+ fsl,audmux-port = <4>;
+ fsl,port-config = <
+ IMX_AUDMUX_V2_PTCR_SYN
+ IMX_AUDMUX_V2_PDCR_RXDSEL(1)>;
+ };
};
&can1 {
@@ -331,7 +351,7 @@
pinctrl-0 = <&pinctrl_i2c3>;
status = "okay";
- codec: sgtl5000@a {
+ sgtl5000: codec@a {
compatible = "fsl,sgtl5000";
reg = <0x0a>;
clocks = <&clks IMX6QDL_CLK_CKO>;
@@ -475,6 +495,9 @@
MX6QDL_PAD_SD2_DAT2__AUD4_TXD 0x110b0
MX6QDL_PAD_SD2_DAT1__AUD4_TXFS 0x130b0
MX6QDL_PAD_GPIO_0__CCM_CLKO1 0x130b0 /* AUD4_MCK */
+ MX6QDL_PAD_EIM_D25__AUD5_RXC 0x130b0
+ MX6QDL_PAD_DISP0_DAT19__AUD5_RXD 0x130b0
+ MX6QDL_PAD_EIM_D24__AUD5_RXFS 0x130b0
>;
};
The GW54xx has a front-panel microHDMI connector routed to a TDA19971 which is connected the the IPU CSI when using IMX6Q. Signed-off-by: Tim Harvey <tharvey@gateworks.com> --- v5: - remove leading 0 from unit address - add newline between property list and child node v4: no changes v3: no changes v2: - add HDMI audio input support arch/arm/boot/dts/imx6q-gw54xx.dts | 105 ++++++++++++++++++++++++++++++++++ arch/arm/boot/dts/imx6qdl-gw54xx.dtsi | 29 +++++++++- 2 files changed, 131 insertions(+), 3 deletions(-)