@@ -225,6 +225,114 @@ static int mmc_clock_opt_set(void *data, u64 val)
DEFINE_SIMPLE_ATTRIBUTE(mmc_clock_fops, mmc_clock_opt_get, mmc_clock_opt_set,
"%llu\n");
+static int mmc_caps_show(struct seq_file *s, void *unused)
+{
+ static const char * const mmc_host_capabilities[] = {
+ "4-bit transfers allowed",/* MMC_CAP_4_BIT_DATA (1 << 0) */
+ /* MMC_CAP_MMC_HIGHSPEED (1 << 1)*/
+ "Supports MMC high-speed timing",
+ /* MMC_CAP_SD_HIGHSPEED (1 << 2)*/
+ "Supports SD high-speed timing",
+ "Can signal pending SDIO IRQs",/* MMC_CAP_SDIO_IRQ (1 << 3) */
+ "Talks only SPI protocols",/* MMC_CAP_SPI (1 << 4) */
+ /* MMC_CAP_NEEDS_POLL (1 << 5)*/
+ "Needs polling for card-detection",
+ "8 bit transfers allowed",/* MMC_CAP_8_BIT_DATA (1 << 6) */
+ "Suspends (e)MMC/SD at idle",/*MMC_CAP_AGGRESSIVE_PM (1 << 7)*/
+ "Nonremovable",/* MMC_CAP_NONREMOVABLE (1 << 8) */
+ "Waits while card is busy",/*MMC_CAP_WAIT_WHILE_BUSY (1 << 9)*/
+ "Allows erase/trim commands",/* MMC_CAP_ERASE (1 << 10) */
+ "Supports DDR mode at 3.3V",/* MMC_CAP_3_3V_DDR (1 << 11) */
+ "Supports DDR mode at 1.8V",/* MMC_CAP_1_8V_DDR (1 << 12) */
+ "Supports DDR mode at 1.2V",/* MMC_CAP_1_2V_DDR (1 << 13) */
+ "Can power off after boot",/*MMC_CAP_POWER_OFF_CARD (1 << 14)*/
+ "CMD14/CMD19 bus width ok",/*MMC_CAP_BUS_WIDTH_TEST (1 << 15)*/
+ "Supports UHS SDR12 mode",/* MMC_CAP_UHS_SDR12 (1 << 16) */
+ "Supports UHS SDR25 mode",/* MMC_CAP_UHS_SDR25 (1 << 17) */
+ "Supports UHS SDR50 mode",/* MMC_CAP_UHS_SDR50 (1 << 18) */
+ "Supports UHS SDR104 mode",/* MMC_CAP_UHS_SDR104 (1 << 19) */
+ "Supports UHS DDR50 mode",/* MMC_CAP_UHS_DDR50 (1 << 20) */
+ "",/* (1 << 21) is free for reuse*/
+ "",/* (1 << 22) */
+ "Supports Driver Type A",/* MMC_CAP_DRIVER_TYPE_A (1 << 23) */
+ "Supports Driver Type C",/* MMC_CAP_DRIVER_TYPE_C (1 << 24) */
+ "Supports Driver Type D",/* MMC_CAP_DRIVER_TYPE_D (1 << 25) */
+ "",/* (1 << 26) */
+ /* MMC_CAP_DONE_COMPLETE (1 << 27) */
+ "RW reqs can be completed within mmc_request_done()",
+ "Supports Enable card detect wake",/*MMC_CAP_CD_WAKE (1 << 28)*/
+ /* MMC_CAP_CMD_DURING_TFR (1 << 29) */
+ "Can send commands during data transfer",
+ "CMD23 supported",/* MMC_CAP_CMD23 (1 << 30) */
+ "Supports Hardware reset"/* MMC_CAP_HW_RESET (1 << 31) */
+ };
+
+ static const char * const mmc_host_capabilities2[] = {
+ /* MMC_CAP2_BOOTPART_NOACC (1 << 0) */
+ "No access to Boot partition",
+ "",/* (1 << 1) */
+ "Can do full power cycle",/* MMC_CAP2_FULL_PWR_CYCLE (1 << 2) */
+ "",/* (1 << 3) */
+ "",/* (1 << 4) */
+ "Supports HS200 1.8V SDR",/* MMC_CAP2_HS200_1_8V_SDR (1 << 5) */
+ "Supports HS200 1.2V SDR",/* MMC_CAP2_HS200_1_2V_SDR (1 << 6) */
+ "",/* (1 << 7) */
+ "",/* (1 << 8) */
+ "",/* (1 << 9) */
+ /* MMC_CAP2_CD_ACTIVE_HIGH (1 << 10) */
+ "Card-detect signal active high",
+ /* MMC_CAP2_RO_ACTIVE_HIGH (1 << 11) */
+ "Write-protect signal active high",
+ "",/* (1 << 12) */
+ "",/* (1 << 13) */
+ /* MMC_CAP2_NO_PRESCAN_POWERUP (1 << 14) */
+ "Can do complete power cycle of the card",
+ "Supports HS400 1.8V",/* MMC_CAP2_HS400_1_8V (1 << 15) */
+ "Support HS400 1.2V",/* MMC_CAP2_HS400_1_2V (1 << 16) */
+ "SDIO IRQ - Nothread",/* MMC_CAP2_SDIO_IRQ_NOTHREAD (1 << 17) */
+ /* MMC_CAP2_NO_WRITE_PROTECT (1 << 18) */
+ "No physical write protect pin, assume always read-write",
+ /* MMC_CAP2_NO_SDIO (1 << 19) */
+ "Do not send SDIO commands during initialization",
+ "Supports enhanced strobe",/* MMC_CAP2_HS400_ES (1 << 20) */
+ /* MMC_CAP2_NO_SD (1 << 21) */
+ "Do not send SD commands during initialization",
+ /* MMC_CAP2_NO_MMC (1 << 22) */
+ "Do not send (e)MMC commands during initialization",
+ "Has eMMC command queue engine",/* MMC_CAP2_CQE (1 << 23) */
+ "CQE can issue a direct command",/*MMC_CAP2_CQE_DCMD (1 << 24)*/
+ "",/* (1 << 25) */
+ "",/* (1 << 26) */
+ "",/* (1 << 27) */
+ "",/* (1 << 28) */
+ "",/* (1 << 29) */
+ "",/* (1 << 30) */
+ ""/* (1 << 31) */
+ };
+
+ struct mmc_host *host = s->private;
+ u32 caps = host->caps;
+ u32 caps2 = host->caps2;
+ int bit;
+ int size = sizeof(u32) * BITS_PER_BYTE;
+
+ seq_puts(s, "MMC Host capabilities are:\n");
+ seq_puts(s, "=============================================\n");
+
+ for_each_set_bit(bit, (const unsigned long *)&caps, size)
+ seq_printf(s, "%s\n", mmc_host_capabilities[bit]);
+
+ seq_puts(s, "=============================================\n");
+ seq_puts(s, "MMC Host additional capabilities are:\n");
+ seq_puts(s, "=============================================\n");
+
+ for_each_set_bit(bit, (const unsigned long *)&caps2, size)
+ seq_printf(s, "%s\n", mmc_host_capabilities2[bit]);
+
+ return 0;
+}
+DEFINE_SHOW_ATTRIBUTE(mmc_caps);
+
void mmc_add_host_debugfs(struct mmc_host *host)
{
struct dentry *root;
@@ -243,6 +351,9 @@ void mmc_add_host_debugfs(struct mmc_host *host)
if (!debugfs_create_file("ios", S_IRUSR, root, host, &mmc_ios_fops))
goto err_node;
+ if (!debugfs_create_file("caps", S_IRUSR, root, host, &mmc_caps_fops))
+ goto err_node;
+
if (!debugfs_create_file("clock", S_IRUSR | S_IWUSR, root, host,
&mmc_clock_fops))
goto err_node;
This patch exports the host capabilities to debugfs This idea of sharing host capabilities over debugfs came up from Abbas Raza <Abbas_Raza@mentor.com> Earlier discussions: https://lkml.org/lkml/2018/3/5/357 https://www.spinics.net/lists/linux-mmc/msg48219.html Signed-off-by: Harish Jenny K N <harish_kandiga@mentor.com> --- Changes in v8 - Changes to use for_each_set_bit as suggested by Andy Shevchenko. Changes in v7 - Moved additional capabilities also to caps file as mentioned by Ulf Hansson - compacting the code with macros Changes in v6: - Used DEFINE_SHOW_ATTRIBUTE Changes in v5: - Added parser logic in kernel by using debugfs_create_file for caps and caps2 instead of debugfs_create_x32 - Changed Author Changes in v4: - Moved the creation of nodes to mmc_add_host_debugfs - Exported caps2 - Renamed host_caps to caps Changes in v3: - Removed typecasting of &host->caps to (u32 *) Changes in v2: - Changed Author drivers/mmc/core/debugfs.c | 111 +++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 111 insertions(+) -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html