[2/3] arm64: dts: allwinner: h6: orangepi: Enable USB 2.0 host and OTG ports
diff mbox series

Message ID 20181120065311.30009-3-wens@csie.org
State New, archived
Headers show
Series
  • arm64: dts: allwinner: h6: orangepi: Enable USB 2.0 and LEDs
Related show

Commit Message

Chen-Yu Tsai Nov. 20, 2018, 6:53 a.m. UTC
The Orange Pi Lite 2 and Orange Pi One Plus share the same design for
their USB 2.0 ports. VBUS is directly tied to the board wide 5V rail,
which is also directly tied to the DC jack. There is no current limiting
in this design.

This patch enables all the USB 2.0 related device nodes, and sets the
VBUS regulator supplies and OTG ID detection GPIO.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
 .../dts/allwinner/sun50i-h6-orangepi.dtsi     | 28 +++++++++++++++++++
 1 file changed, 28 insertions(+)

Patch
diff mbox series

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi
index f910d5eb9267..f16b7ffbe797 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi
@@ -32,6 +32,14 @@ 
 	};
 };
 
+&ehci0 {
+	status = "okay";
+};
+
+&ehci3 {
+	status = "okay";
+};
+
 &mmc0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc0_pins>;
@@ -41,6 +49,14 @@ 
 	status = "okay";
 };
 
+&ohci0 {
+	status = "okay";
+};
+
+&ohci3 {
+	status = "okay";
+};
+
 &r_i2c {
 	status = "okay";
 
@@ -165,3 +181,15 @@ 
 	pinctrl-0 = <&uart0_ph_pins>;
 	status = "okay";
 };
+
+&usb2otg {
+	dr_mode = "otg";
+	status = "okay";
+};
+
+&usb2phy {
+	usb0_id_det-gpios = <&pio 2 6 GPIO_ACTIVE_HIGH>; /* PC6 */
+	usb0_vbus-supply = <&reg_vcc5v>;
+	usb3_vbus-supply = <&reg_vcc5v>;
+	status = "okay";
+};