[V2,3/3] mmc: tegra: SDMMC pads auto-calibration
diff mbox series

Message ID 1545260153-11338-3-git-send-email-skomatineni@nvidia.com
State New
Headers show
Series
  • [V2,1/3] dt-bindings: mmc: tegra: Add pinctrl for pad drive strength config
Related show

Commit Message

Sowjanya Komatineni Dec. 19, 2018, 10:55 p.m. UTC
Programs initial drive code offsets which will be used by auto
calibration process.

Programs fixed drive strengths for SDMMC pads when auto cal
timeouts. Fixed settings are based on Pre-SI analysis of the
pad design.

Signed-off-by: Sowjanya Komatineni <skomatineni@nvidia.com>
---
 drivers/mmc/host/sdhci-tegra.c | 107 +++++++++++++++++++++++++++++++----------
 1 file changed, 81 insertions(+), 26 deletions(-)

Patch
diff mbox series

diff --git a/drivers/mmc/host/sdhci-tegra.c b/drivers/mmc/host/sdhci-tegra.c
index 7b95d088fdef..f8361249cf57 100644
--- a/drivers/mmc/host/sdhci-tegra.c
+++ b/drivers/mmc/host/sdhci-tegra.c
@@ -75,6 +75,7 @@ 
 #define SDHCI_TEGRA_SDMEM_COMP_PADCTRL_VREF_SEL_MASK	0x0000000f
 #define SDHCI_TEGRA_SDMEM_COMP_PADCTRL_VREF_SEL_VAL	0x7
 #define SDHCI_TEGRA_SDMEM_COMP_PADCTRL_E_INPUT_E_PWRD	BIT(31)
+#define SDHCI_COMP_PADCTRL_DRVUPDN_OFFSET_MASK		0x07FFF000
 
 #define SDHCI_TEGRA_AUTO_CAL_STATUS			0x1ec
 #define SDHCI_TEGRA_AUTO_CAL_ACTIVE			BIT(31)
@@ -121,6 +122,8 @@  struct sdhci_tegra {
 	struct pinctrl *pinctrl_sdmmc;
 	struct pinctrl_state *pinctrl_state_3v3;
 	struct pinctrl_state *pinctrl_state_1v8;
+	struct pinctrl_state *pinctrl_state_3v3_drv;
+	struct pinctrl_state *pinctrl_state_1v8_drv;
 
 	struct sdhci_tegra_autocal_offsets autocal_offsets;
 	ktime_t last_calib;
@@ -130,6 +133,9 @@  struct sdhci_tegra {
 	u32 dqs_trim;
 };
 
+static int tegra_sdhci_set_padctrl(struct sdhci_host *host, int voltage,
+							bool state_drvupdn);
+
 static u16 tegra_sdhci_readw(struct sdhci_host *host, int reg)
 {
 	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
@@ -437,6 +443,7 @@  static void tegra_sdhci_pad_autocalib(struct sdhci_host *host)
 			pdpu = offsets.pull_down_3v3 << 8 | offsets.pull_up_3v3;
 	}
 
+	/* Set initial offset before auto-calibration */
 	tegra_sdhci_set_pad_autocal_offset(host, pdpu);
 
 	card_clk_enabled = tegra_sdhci_configure_card_clk(host, false);
@@ -460,19 +467,15 @@  static void tegra_sdhci_pad_autocalib(struct sdhci_host *host)
 	if (ret) {
 		dev_err(mmc_dev(host->mmc), "Pad autocal timed out\n");
 
-		if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_180)
-			pdpu = offsets.pull_down_1v8_timeout << 8 |
-			       offsets.pull_up_1v8_timeout;
-		else
-			pdpu = offsets.pull_down_3v3_timeout << 8 |
-			       offsets.pull_up_3v3_timeout;
-
-		/* Disable automatic calibration and use fixed offsets */
+		/* Disable automatic cal and use fixed Drive Strengths */
 		reg = sdhci_readl(host, SDHCI_TEGRA_AUTO_CAL_CONFIG);
 		reg &= ~SDHCI_AUTO_CAL_ENABLE;
 		sdhci_writel(host, reg, SDHCI_TEGRA_AUTO_CAL_CONFIG);
 
-		tegra_sdhci_set_pad_autocal_offset(host, pdpu);
+		ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage, false);
+		if (ret < 0)
+			dev_err(mmc_dev(host->mmc),
+			"Setting drive strengths failed %d\n", PTR_ERR(ret));
 	}
 }
 
@@ -743,27 +746,73 @@  static int tegra_sdhci_execute_tuning(struct sdhci_host *host, u32 opcode)
 	return mmc_send_tuning(host->mmc, opcode, NULL);
 }
 
-static int tegra_sdhci_set_padctrl(struct sdhci_host *host, int voltage)
+static int tegra_sdhci_set_padctrl(struct sdhci_host *host, int voltage,
+							bool state_drvupdn)
 {
 	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
 	struct sdhci_tegra *tegra_host = sdhci_pltfm_priv(pltfm_host);
-	int ret;
+	struct sdhci_tegra_autocal_offsets offsets =
+					tegra_host->autocal_offsets;
+	struct pinctrl_state *pinctrl_drvupdn = NULL;
+	int ret = 0;
+	u8 drvup = 0, drvdn = 0;
+	u32 reg;
 
-	if (!tegra_host->pad_control_available)
-		return 0;
+	if (!state_drvupdn) {
+		/* PADS Drive Strength */
+		if (voltage == MMC_SIGNAL_VOLTAGE_180) {
+			if (!IS_ERR(tegra_host->pinctrl_state_1v8_drv) &&
+				(tegra_host->pinctrl_state_1v8_drv != NULL)) {
+				pinctrl_drvupdn =
+					tegra_host->pinctrl_state_1v8_drv;
+			} else {
+				drvup = offsets.pull_up_1v8_timeout;
+				drvdn = offsets.pull_down_1v8_timeout;
+			}
+		} else {
+			if (!IS_ERR(tegra_host->pinctrl_state_3v3_drv) &&
+				(tegra_host->pinctrl_state_3v3_drv != NULL)) {
+				pinctrl_drvupdn =
+					tegra_host->pinctrl_state_3v3_drv;
+			} else {
+				drvup = offsets.pull_up_3v3_timeout;
+				drvdn = offsets.pull_down_3v3_timeout;
+			}
+		}
+
+		if (pinctrl_drvupdn != NULL) {
+			ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
+							pinctrl_drvupdn);
+			if (ret < 0)
+				dev_err(mmc_dev(host->mmc),
+					"failed pads drvupdn, ret: %d\n", ret);
+		} else if ((drvup) || (drvdn)) {
+			reg = sdhci_readl(host,
+					SDHCI_TEGRA_SDMEM_COMP_PADCTRL);
+			reg &= ~SDHCI_COMP_PADCTRL_DRVUPDN_OFFSET_MASK;
+			reg |= (drvup << 20) | (drvdn << 12);
+			sdhci_writel(host, reg,
+					SDHCI_TEGRA_SDMEM_COMP_PADCTRL);
+		}
 
-	if (voltage == MMC_SIGNAL_VOLTAGE_180) {
-		ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
-					   tegra_host->pinctrl_state_1v8);
-		if (ret < 0)
-			dev_err(mmc_dev(host->mmc),
-				"setting 1.8V failed, ret: %d\n", ret);
 	} else {
-		ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
-					   tegra_host->pinctrl_state_3v3);
-		if (ret < 0)
-			dev_err(mmc_dev(host->mmc),
-				"setting 3.3V failed, ret: %d\n", ret);
+		/* Dual Voltage PADS Voltage selection */
+		if (!tegra_host->pad_control_available)
+			return 0;
+
+		if (voltage == MMC_SIGNAL_VOLTAGE_180) {
+			ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
+						tegra_host->pinctrl_state_1v8);
+			if (ret < 0)
+				dev_err(mmc_dev(host->mmc),
+					"setting 1.8V failed, ret: %d\n", ret);
+		} else {
+			ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
+						tegra_host->pinctrl_state_3v3);
+			if (ret < 0)
+				dev_err(mmc_dev(host->mmc),
+					"setting 3.3V failed, ret: %d\n", ret);
+		}
 	}
 
 	return ret;
@@ -778,7 +827,7 @@  static int sdhci_tegra_start_signal_voltage_switch(struct mmc_host *mmc,
 	int ret = 0;
 
 	if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_330) {
-		ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage);
+		ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage, true);
 		if (ret < 0)
 			return ret;
 		ret = sdhci_start_signal_voltage_switch(mmc, ios);
@@ -786,7 +835,7 @@  static int sdhci_tegra_start_signal_voltage_switch(struct mmc_host *mmc,
 		ret = sdhci_start_signal_voltage_switch(mmc, ios);
 		if (ret < 0)
 			return ret;
-		ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage);
+		ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage, true);
 	}
 
 	if (tegra_host->pad_calib_required)
@@ -805,6 +854,12 @@  static int tegra_sdhci_init_pinctrl_info(struct device *dev,
 		return -1;
 	}
 
+	tegra_host->pinctrl_state_1v8_drv = pinctrl_lookup_state(
+				tegra_host->pinctrl_sdmmc, "sdmmc-1v8-drv");
+
+	tegra_host->pinctrl_state_3v3_drv = pinctrl_lookup_state(
+				tegra_host->pinctrl_sdmmc, "sdmmc-3v3-drv");
+
 	tegra_host->pinctrl_state_3v3 =
 		pinctrl_lookup_state(tegra_host->pinctrl_sdmmc, "sdmmc-3v3");
 	if (IS_ERR(tegra_host->pinctrl_state_3v3)) {