diff mbox series

[v3,2/2] spi-atmel: support inter-word delay

Message ID 20190126163220.26421-3-jonas@norrbonn.se (mailing list archive)
State New, archived
Headers show
Series spi: support inter-word delays | expand

Commit Message

Jonas Bonn Jan. 26, 2019, 4:32 p.m. UTC 
If the SPI slave requires an inter-word delay, configure the DLYBCT
register accordingly.

Tested on a SAMA5D2 board (derived from SAMA5D2-Xplained reference
board).

Signed-off-by: Jonas Bonn <jonas@norrbonn.se>
CC: Nicolas Ferre <nicolas.ferre@microchip.com>
CC: Mark Brown <broonie@kernel.org>
CC: Alexandre Belloni <alexandre.belloni@bootlin.com>
CC: Ludovic Desroches <ludovic.desroches@microchip.com>
CC: linux-spi@vger.kernel.org
CC: linux-arm-kernel@lists.infradead.org
---
 drivers/spi/spi-atmel.c | 18 +++++++++++++-----
 1 file changed, 13 insertions(+), 5 deletions(-)
diff mbox series

Patch

diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
index 74fddcd3282b..24445bfbd74e 100644
--- a/drivers/spi/spi-atmel.c
+++ b/drivers/spi/spi-atmel.c
@@ -1209,13 +1209,21 @@  static int atmel_spi_setup(struct spi_device *spi)
 		csr |= SPI_BIT(CSAAT);
 
 	/* DLYBS is mostly irrelevant since we manage chipselect using GPIOs.
-	 *
-	 * DLYBCT would add delays between words, slowing down transfers.
-	 * It could potentially be useful to cope with DMA bottlenecks, but
-	 * in those cases it's probably best to just use a lower bitrate.
 	 */
 	csr |= SPI_BF(DLYBS, 0);
-	csr |= SPI_BF(DLYBCT, 0);
+
+	/* DLYBCT adds delays between words.  This is useful for slow devices
+	 * that need a bit of time to setup the next transfer.
+	 */
+	if (spi->word_delay) {
+		csr |= SPI_BF(DLYBCT,
+			clamp_t(u8,
+				(as->spi_clk/1000000*spi->word_delay)>>5,
+				1, 255));
+	} else {
+		csr |= SPI_BF(DLYBCT, 0);
+	}
+
 
 	/* chipselect must have been muxed as GPIO (e.g. in board setup) */
 	npcs_pin = (unsigned long)spi->controller_data;