| Message ID | 20190402165743.28106-3-d-gerlach@ti.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | ARM: OMAP2+: AM43x: Support DDR HW leveling suspend/resume | expand |
diff --git a/arch/arm/mach-omap2/sleep43xx.S b/arch/arm/mach-omap2/sleep43xx.S index 5b9343b58fc7..0c1031442571 100644 --- a/arch/arm/mach-omap2/sleep43xx.S +++ b/arch/arm/mach-omap2/sleep43xx.S @@ -368,6 +368,9 @@ wait_emif_enable1: mov r1, #AM43XX_EMIF_POWEROFF_DISABLE str r1, [r2, #0x0] + ldr r1, [r9, #EMIF_PM_RUN_HW_LEVELING] + blx r1 + #ifdef CONFIG_CACHE_L2X0 ldr r2, l2_cache_base ldr r0, [r2, #L2X0_CTRL]
When returning from DeepSleep mode on AM437x platforms the EMIF must run DDR hardware leveling, same as done during u-boot, to properly restore the EMIF PHY to it's operational state on platforms using DDR3. Call the ti-emif-sram-pm run_hw_leveling routine to perform this. This happens after all other EMIF values are restored so the exact same configuration used at boot is used at the end of EMIF resume as well. Signed-off-by: Dave Gerlach <d-gerlach@ti.com> --- arch/arm/mach-omap2/sleep43xx.S | 3 +++ 1 file changed, 3 insertions(+)