@@ -22,6 +22,41 @@
stdout-path = "serial0:115200n8";
};
+ i2c {
+ compatible = "i2c-gpio";
+ sda-gpios = <&pio 4 13 GPIO_ACTIVE_HIGH>;
+ scl-gpios = <&pio 4 12 GPIO_ACTIVE_HIGH>;
+ i2c-gpio,delay-us = <5>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ ov5640: camera@3c {
+ compatible = "ovti,ov5640";
+ reg = <0x3c>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&csi_mclk_pin>;
+ clocks = <&ccu CLK_CSI_MCLK>;
+ clock-names = "xclk";
+
+ AVDD-supply = <®_aldo1>;
+ DOVDD-supply = <®_dldo3>;
+ DVDD-supply = <®_eldo3>;
+ reset-gpios = <&pio 4 14 GPIO_ACTIVE_LOW>; /* CSI-RST-R: PE14 */
+ powerdown-gpios = <&pio 4 15 GPIO_ACTIVE_HIGH>; /* CSI-STBY-R: PE15 */
+
+ port {
+ ov5640_ep: endpoint {
+ remote-endpoint = <&csi_ep>;
+ bus-width = <8>;
+ hsync-active = <1>; /* Active high */
+ vsync-active = <0>; /* Active low */
+ data-active = <1>; /* Active high */
+ pclk-sample = <1>; /* Rising */
+ };
+ };
+ };
+ };
+
wifi_pwrseq: wifi-pwrseq {
compatible = "mmc-pwrseq-simple";
clocks = <&rtc 1>;
@@ -30,6 +65,21 @@
};
};
+&csi {
+ status = "okay";
+
+ port {
+ csi_ep: endpoint {
+ remote-endpoint = <&ov5640_ep>;
+ bus-width = <8>;
+ hsync-active = <1>; /* Active high */
+ vsync-active = <0>; /* Active low */
+ data-active = <1>; /* Active high */
+ pclk-sample = <1>; /* Rising */
+ };
+ };
+};
+
&ehci0 {
status = "okay";
};
Amarula A64-Relic board by default bound with OV5640 camera, so add support for it with below pin information. - PE13, PE12 via i2c-gpio bitbanging - CLK_CSI_MCLK as external clock - PE1 as external clock pin muxing - ALDO1 as AVDD supply - DLDO3 as DOVDD supply - ELDO3 as DVDD supply - PE14 gpio for reset pin - PE15 gpio for powerdown pin Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> --- Changes for v2: - use node name as i2c instead of i2c-csi - drop i2c gpio pin documentation - drop unneeded address, size properties .../allwinner/sun50i-a64-amarula-relic.dts | 50 +++++++++++++++++++ 1 file changed, 50 insertions(+)