@@ -73,6 +73,16 @@ SCMI provides an API to access the various sensors on the SoC.
as used by the firmware. Refer to platform details
for your implementation for the IDs to use.
+Reset signal bindings for the reset domains based on SCMI Message Protocol
+------------------------------------------------------------
+
+This binding for the SCMI reset domain providers uses the generic reset
+signal binding[5].
+
+Required properties:
+ - #reset-cells : Should be 1. Contains the reset domain ID value used
+ by SCMI commands.
+
SRAM and Shared Memory for SCMI
-------------------------------
@@ -93,6 +103,7 @@ Each sub-node represents the reserved area for SCMI.
[2] Documentation/devicetree/bindings/power/power_domain.txt
[3] Documentation/devicetree/bindings/thermal/thermal.txt
[4] Documentation/devicetree/bindings/sram/sram.txt
+[5] Documentation/devicetree/bindings/reset/reset.txt
Example:
@@ -152,6 +163,11 @@ firmware {
reg = <0x15>;
#thermal-sensor-cells = <1>;
};
+
+ scmi_reset: protocol@16 {
+ reg = <0x16>;
+ #reset-cells = <1>;
+ };
};
};
@@ -166,6 +182,7 @@ hdlcd@7ff60000 {
reg = <0 0x7ff60000 0 0x1000>;
clocks = <&scmi_clk 4>;
power-domains = <&scmi_devpd 1>;
+ resets = <&scmi_reset 10>;
};
thermal-zones {
SCMIv2.0 adds a new Reset Management Protocol to manage various reset states a given device or domain can enter. Extend the existing SCMI bindings to add reset protocol support by re-using the reset bindings for bothe reset providers and consumers. Cc: Philipp Zabel <p.zabel@pengutronix.de> Cc: Rob Herring <robh+dt@kernel.org> Cc: Mark Rutland <mark.rutland@arm.com> Cc: devicetree@vger.kernel.org Signed-off-by: Sudeep Holla <sudeep.holla@arm.com> --- .../devicetree/bindings/arm/arm,scmi.txt | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)