@@ -274,6 +274,38 @@ static void musb_default_writew(void __iomem *addr, unsigned offset, u16 data)
__raw_writew(data, addr + offset);
}
+static u16 musb_default_get_toggle(struct musb_qh *qh, int is_out)
+{
+ void __iomem *epio = qh->hw_ep->regs;
+ u16 csr;
+
+ if (is_out)
+ csr = musb_readw(epio, MUSB_TXCSR) & MUSB_TXCSR_H_DATATOGGLE;
+ else
+ csr = musb_readw(epio, MUSB_RXCSR) & MUSB_RXCSR_H_DATATOGGLE;
+
+ return csr;
+}
+
+static u16 musb_default_set_toggle(struct musb_qh *qh, int is_out,
+ struct urb *urb)
+{
+ u16 csr;
+ u16 toggle;
+
+ toggle = usb_gettoggle(urb->dev, qh->epnum, is_out);
+
+ if (is_out)
+ csr = toggle ? (MUSB_TXCSR_H_WR_DATATOGGLE
+ | MUSB_TXCSR_H_DATATOGGLE)
+ : MUSB_TXCSR_CLRDATATOG;
+ else
+ csr = toggle ? (MUSB_RXCSR_H_WR_DATATOGGLE
+ | MUSB_RXCSR_H_DATATOGGLE) : 0;
+
+ return csr;
+}
+
/*
* Load an endpoint's FIFO
*/
@@ -2278,6 +2310,16 @@ static void musb_deassert_reset(struct work_struct *work)
else
musb->io.write_fifo = musb_default_write_fifo;
+ if (musb->ops->get_toggle)
+ musb->io.get_toggle = musb->ops->get_toggle;
+ else
+ musb->io.get_toggle = musb_default_get_toggle;
+
+ if (musb->ops->set_toggle)
+ musb->io.set_toggle = musb->ops->set_toggle;
+ else
+ musb->io.set_toggle = musb_default_set_toggle;
+
if (!musb->xceiv->io_ops) {
musb->xceiv->io_dev = musb->controller;
musb->xceiv->io_priv = musb->mregs;
@@ -27,6 +27,7 @@
struct musb;
struct musb_hw_ep;
struct musb_ep;
+struct musb_qh;
/* Helper defines for struct musb->hwvers */
#define MUSB_HWVERS_MAJOR(x) ((x >> 10) & 0x1f)
@@ -123,6 +124,8 @@ enum musb_g_ep0_state {
* @writew: write 16 bits
* @read_fifo: reads the fifo
* @write_fifo: writes to fifo
+ * @get_toggle: platform specific get toggle function
+ * @set_toggle: platform specific set toggle function
* @dma_init: platform specific dma init function
* @dma_exit: platform specific dma exit function
* @init: turns on clocks, sets up platform-specific registers, etc
@@ -167,6 +170,8 @@ struct musb_platform_ops {
void (*writew)(void __iomem *addr, unsigned offset, u16 data);
void (*read_fifo)(struct musb_hw_ep *hw_ep, u16 len, u8 *buf);
void (*write_fifo)(struct musb_hw_ep *hw_ep, u16 len, const u8 *buf);
+ u16 (*get_toggle)(struct musb_qh *qh, int is_out);
+ u16 (*set_toggle)(struct musb_qh *qh, int is_out, struct urb *urb);
struct dma_controller *
(*dma_init) (struct musb *musb, void __iomem *base);
void (*dma_exit)(struct dma_controller *c);
@@ -286,26 +286,6 @@ static void musb_giveback(struct musb *musb, struct urb *urb, int status)
spin_lock(&musb->lock);
}
-/* For bulk/interrupt endpoints only */
-static inline void musb_save_toggle(struct musb_qh *qh, int is_in,
- struct urb *urb)
-{
- void __iomem *epio = qh->hw_ep->regs;
- u16 csr;
-
- /*
- * FIXME: the current Mentor DMA code seems to have
- * problems getting toggle correct.
- */
-
- if (is_in)
- csr = musb_readw(epio, MUSB_RXCSR) & MUSB_RXCSR_H_DATATOGGLE;
- else
- csr = musb_readw(epio, MUSB_TXCSR) & MUSB_TXCSR_H_DATATOGGLE;
-
- usb_settoggle(urb->dev, qh->epnum, !is_in, csr ? 1 : 0);
-}
-
/*
* Advance this hardware endpoint's queue, completing the specified URB and
* advancing to either the next URB queued to that qh, or else invalidating
@@ -320,6 +300,7 @@ static void musb_advance_schedule(struct musb *musb, struct urb *urb,
struct musb_hw_ep *ep = qh->hw_ep;
int ready = qh->is_ready;
int status;
+ u16 toggle;
status = (urb->status == -EINPROGRESS) ? 0 : urb->status;
@@ -327,7 +308,8 @@ static void musb_advance_schedule(struct musb *musb, struct urb *urb,
switch (qh->type) {
case USB_ENDPOINT_XFER_BULK:
case USB_ENDPOINT_XFER_INT:
- musb_save_toggle(qh, is_in, urb);
+ toggle = musb->io.get_toggle(qh, !is_in);
+ usb_settoggle(urb->dev, qh->epnum, !is_in, toggle ? 1 : 0);
break;
case USB_ENDPOINT_XFER_ISOC:
if (status == 0 && urb->error_count)
@@ -772,13 +754,8 @@ static void musb_ep_program(struct musb *musb, u8 epnum,
);
csr |= MUSB_TXCSR_MODE;
- if (!hw_ep->tx_double_buffered) {
- if (usb_gettoggle(urb->dev, qh->epnum, 1))
- csr |= MUSB_TXCSR_H_WR_DATATOGGLE
- | MUSB_TXCSR_H_DATATOGGLE;
- else
- csr |= MUSB_TXCSR_CLRDATATOG;
- }
+ if (!hw_ep->tx_double_buffered)
+ csr |= musb->io.set_toggle(qh, is_out, urb);
musb_writew(epio, MUSB_TXCSR, csr);
/* REVISIT may need to clear FLUSHFIFO ... */
@@ -860,17 +837,12 @@ static void musb_ep_program(struct musb *musb, u8 epnum,
/* IN/receive */
} else {
- u16 csr;
+ u16 csr = 0;
if (hw_ep->rx_reinit) {
musb_rx_reinit(musb, qh, epnum);
+ csr |= musb->io.set_toggle(qh, is_out, urb);
- /* init new state: toggle and NYET, maybe DMA later */
- if (usb_gettoggle(urb->dev, qh->epnum, 0))
- csr = MUSB_RXCSR_H_WR_DATATOGGLE
- | MUSB_RXCSR_H_DATATOGGLE;
- else
- csr = 0;
if (qh->type == USB_ENDPOINT_XFER_INT)
csr |= MUSB_RXCSR_DISNYET;
@@ -933,6 +905,7 @@ static void musb_bulk_nak_timeout(struct musb *musb, struct musb_hw_ep *ep,
void __iomem *epio = ep->regs;
struct musb_qh *cur_qh, *next_qh;
u16 rx_csr, tx_csr;
+ u16 toggle;
musb_ep_select(mbase, ep->epnum);
if (is_in) {
@@ -970,7 +943,8 @@ static void musb_bulk_nak_timeout(struct musb *musb, struct musb_hw_ep *ep,
urb->actual_length += dma->actual_len;
dma->actual_len = 0L;
}
- musb_save_toggle(cur_qh, is_in, urb);
+ toggle = musb->io.get_toggle(cur_qh, !is_in);
+ usb_settoggle(urb->dev, cur_qh->epnum, !is_in, toggle ? 1 : 0);
if (is_in) {
/* move cur_qh to end of queue */
@@ -22,6 +22,8 @@
* @read_fifo: platform specific function to read fifo
* @write_fifo: platform specific function to write fifo
* @busctl_offset: platform specific function to get busctl offset
+ * @get_toggle: platform specific function to get toggle
+ * @set_toggle: platform specific function to set toggle
*/
struct musb_io {
u32 (*ep_offset)(u8 epnum, u16 offset);
@@ -30,6 +32,8 @@ struct musb_io {
void (*read_fifo)(struct musb_hw_ep *hw_ep, u16 len, u8 *buf);
void (*write_fifo)(struct musb_hw_ep *hw_ep, u16 len, const u8 *buf);
u32 (*busctl_offset)(u8 epnum, u16 offset);
+ u16 (*get_toggle)(struct musb_qh *qh, int is_out);
+ u16 (*set_toggle)(struct musb_qh *qh, int is_out, struct urb *urb);
};
/* Do not add new entries here, add them the struct musb_io instead */