[input-next,4/4] ARM: dts: imx6dl-yapp4: Enable the MPR121 touchkey controller on Hydra
diff mbox series

Message ID 1567424417-3914-5-git-send-email-michal.vokac@ysoft.com
State New
Headers show
Series
  • Add polling mode to the MPR121 touchkey
Related show

Commit Message

Michal Vokáč Sept. 2, 2019, 11:40 a.m. UTC
Add the touch keyboard present on Hydra board. The controller
is connected only using I2C lines. The interrupt line is not
available hence we use the polling mode.

Signed-off-by: Michal Vokáč <michal.vokac@ysoft.com>
---
 arch/arm/boot/dts/imx6dl-yapp4-common.dtsi | 13 +++++++++++++
 arch/arm/boot/dts/imx6dl-yapp4-hydra.dts   |  4 ++++
 2 files changed, 17 insertions(+)

Patch
diff mbox series

diff --git a/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi b/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi
index e8d800fec637..49e2bcd21a00 100644
--- a/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi
+++ b/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi
@@ -4,6 +4,7 @@ 
 
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/input/input.h>
 #include <dt-bindings/pwm/pwm.h>
 
 / {
@@ -330,6 +331,18 @@ 
 		vcc-supply = <&sw2_reg>;
 		status = "disabled";
 	};
+
+	touchkeys: keys@5a {
+		compatible = "fsl,mpr121-touchkey";
+		reg = <0x5a>;
+		vdd-supply = <&sw2_reg>;
+		autorepeat;
+		linux,keycodes = <KEY_1>, <KEY_2>, <KEY_3>, <KEY_4>, <KEY_5>,
+				<KEY_6>, <KEY_7>, <KEY_8>, <KEY_9>,
+				<KEY_BACKSPACE>, <KEY_0>, <KEY_ENTER>;
+		linux,poll-interval = <50>;
+		status = "disabled";
+	};
 };
 
 &iomuxc {
diff --git a/arch/arm/boot/dts/imx6dl-yapp4-hydra.dts b/arch/arm/boot/dts/imx6dl-yapp4-hydra.dts
index f97927064750..84c275bfdd38 100644
--- a/arch/arm/boot/dts/imx6dl-yapp4-hydra.dts
+++ b/arch/arm/boot/dts/imx6dl-yapp4-hydra.dts
@@ -45,6 +45,10 @@ 
 	status = "okay";
 };
 
+&touchkeys {
+	status = "okay";
+};
+
 &usdhc3 {
 	status = "okay";
 };