[v2,2/4] ARM: dts: qcom: Correct USB3503 GPIOs polarity
diff mbox series

Message ID 20191211144638.24676-3-m.szyprowski@samsung.com
State New
Headers show
Series
  • [v2,1/4] ARM: dts: exynos: Correct USB3503 GPIOs polarity
Related show

Commit Message

Marek Szyprowski Dec. 11, 2019, 2:46 p.m. UTC
Current USB3503 driver ignores GPIO polarity and always operates as if the
GPIO lines were flagged as ACTIVE_HIGH. Fix the polarity for the existing
USB3503 chip applications to match the chip specification and common
convention for naming the pins. The only pin, which has to be ACTIVE_LOW
is the reset pin. The remaining are ACTIVE_HIGH. This change allows later
to fix the USB3503 driver to properly use generic GPIO bindings and read
polarity from DT.

Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
---
 arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

Patch
diff mbox series

diff --git a/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts b/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts
index 26160c324802..942e3a2cac35 100644
--- a/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts
+++ b/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts
@@ -143,7 +143,7 @@ 
 				compatible = "smsc,usb3503a";
 				reg = <0x8>;
 				connect-gpios = <&gpioext2 1 GPIO_ACTIVE_HIGH>;
-				intn-gpios = <&gpioext2 0 GPIO_ACTIVE_LOW>;
+				intn-gpios = <&gpioext2 0 GPIO_ACTIVE_HIGH>;
 				initial-mode = <1>;
 			};
 		};