diff mbox series

[v2,3/5] drm/i915/dsi: Init panel-enable GPIO to low when the LCD is initially off (v2)

Message ID 20191216205122.1850923-4-hdegoede@redhat.com (mailing list archive)
State New, archived
Headers show
Series drm/i915/dsi: Control panel and backlight enable GPIOs from VBT | expand

Commit Message

Hans de Goede Dec. 16, 2019, 8:51 p.m. UTC 
When the LCD has not been turned on by the firmware/GOP, because e.g. the
device was booted with an external monitor connected over HDMI, we should
not turn on the panel-enable GPIO when we request it.

Turning on the panel-enable GPIO when we request it, means we turn it on
too early in the init-sequence, which causes some panels to not correctly
light up.

This commits adds a panel_is_on parameter to intel_dsi_vbt_gpio_init()
and makes intel_dsi_vbt_gpio_init() set the initial GPIO value accordingly.

This fixes the panel not lighting up on a Thundersoft TST168 tablet when
booted with an external monitor connected over HDMI.

Changes in v2:
- Call intel_dsi_get_hw_state() to check if the panel is on instead of
  relying on the current_mode pointer

Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
---
 drivers/gpu/drm/i915/display/intel_dsi.h     | 2 +-
 drivers/gpu/drm/i915/display/intel_dsi_vbt.c | 7 +++----
 drivers/gpu/drm/i915/display/vlv_dsi.c       | 4 +++-
 3 files changed, 7 insertions(+), 6 deletions(-)

Comments

Jani Nikula Jan. 2, 2020, 9:14 a.m. UTC | #1 
On Mon, 16 Dec 2019, Hans de Goede <hdegoede@redhat.com> wrote:
> When the LCD has not been turned on by the firmware/GOP, because e.g. the
> device was booted with an external monitor connected over HDMI, we should
> not turn on the panel-enable GPIO when we request it.
>
> Turning on the panel-enable GPIO when we request it, means we turn it on
> too early in the init-sequence, which causes some panels to not correctly
> light up.
>
> This commits adds a panel_is_on parameter to intel_dsi_vbt_gpio_init()
> and makes intel_dsi_vbt_gpio_init() set the initial GPIO value accordingly.
>
> This fixes the panel not lighting up on a Thundersoft TST168 tablet when
> booted with an external monitor connected over HDMI.
>
> Changes in v2:
> - Call intel_dsi_get_hw_state() to check if the panel is on instead of
>   relying on the current_mode pointer
>
> Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
> Signed-off-by: Hans de Goede <hdegoede@redhat.com>
> ---
>  drivers/gpu/drm/i915/display/intel_dsi.h     | 2 +-
>  drivers/gpu/drm/i915/display/intel_dsi_vbt.c | 7 +++----
>  drivers/gpu/drm/i915/display/vlv_dsi.c       | 4 +++-
>  3 files changed, 7 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_dsi.h b/drivers/gpu/drm/i915/display/intel_dsi.h
> index de7e51cd3460..675771ea91aa 100644
> --- a/drivers/gpu/drm/i915/display/intel_dsi.h
> +++ b/drivers/gpu/drm/i915/display/intel_dsi.h
> @@ -203,7 +203,7 @@ void bxt_dsi_reset_clocks(struct intel_encoder *encoder, enum port port);
>  
>  /* intel_dsi_vbt.c */
>  bool intel_dsi_vbt_init(struct intel_dsi *intel_dsi, u16 panel_id);
> -void intel_dsi_vbt_gpio_init(struct intel_dsi *intel_dsi);
> +void intel_dsi_vbt_gpio_init(struct intel_dsi *intel_dsi, bool panel_is_on);
>  void intel_dsi_vbt_gpio_cleanup(struct intel_dsi *intel_dsi);
>  void intel_dsi_vbt_exec_sequence(struct intel_dsi *intel_dsi,
>  				 enum mipi_seq seq_id);
> diff --git a/drivers/gpu/drm/i915/display/intel_dsi_vbt.c b/drivers/gpu/drm/i915/display/intel_dsi_vbt.c
> index 8be7d6c507aa..4210f449553e 100644
> --- a/drivers/gpu/drm/i915/display/intel_dsi_vbt.c
> +++ b/drivers/gpu/drm/i915/display/intel_dsi_vbt.c
> @@ -688,17 +688,16 @@ bool intel_dsi_vbt_init(struct intel_dsi *intel_dsi, u16 panel_id)
>   * On some BYT/CHT devs some sequences are incomplete and we need to manually
>   * control some GPIOs.
>   */
> -void intel_dsi_vbt_gpio_init(struct intel_dsi *intel_dsi)
> +void intel_dsi_vbt_gpio_init(struct intel_dsi *intel_dsi, bool panel_is_on)
>  {
>  	struct drm_device *dev = intel_dsi->base.base.dev;
>  	struct drm_i915_private *dev_priv = to_i915(dev);
>  	struct mipi_config *mipi_config = dev_priv->vbt.dsi.config;
> +	enum gpiod_flags flags = panel_is_on ? GPIOD_OUT_HIGH : GPIOD_OUT_LOW;
>  
>  	if ((IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv)) &&
>  	    mipi_config->pwm_blc == PPS_BLC_PMIC) {
> -		intel_dsi->gpio_panel =
> -			gpiod_get(dev->dev, "panel", GPIOD_OUT_HIGH);
> -
> +		intel_dsi->gpio_panel = gpiod_get(dev->dev, "panel", flags);
>  		if (IS_ERR(intel_dsi->gpio_panel)) {
>  			DRM_ERROR("Failed to own gpio for panel control\n");
>  			intel_dsi->gpio_panel = NULL;
> diff --git a/drivers/gpu/drm/i915/display/vlv_dsi.c b/drivers/gpu/drm/i915/display/vlv_dsi.c
> index c1edd8857af0..d0efee09c593 100644
> --- a/drivers/gpu/drm/i915/display/vlv_dsi.c
> +++ b/drivers/gpu/drm/i915/display/vlv_dsi.c
> @@ -1759,6 +1759,7 @@ void vlv_dsi_init(struct drm_i915_private *dev_priv)
>  	struct drm_connector *connector;
>  	struct drm_display_mode *current_mode, *fixed_mode;
>  	enum port port;
> +	enum pipe pipe;
>  
>  	DRM_DEBUG_KMS("\n");
>  
> @@ -1857,7 +1858,8 @@ void vlv_dsi_init(struct drm_i915_private *dev_priv)
>  
>  	vlv_dphy_param_init(intel_dsi);
>  
> -	intel_dsi_vbt_gpio_init(intel_dsi);
> +	intel_dsi_vbt_gpio_init(intel_dsi,
> +				intel_dsi_get_hw_state(intel_encoder, &pipe));

Feels a bit scary to call into the hooks before everything is
initialized, but this seems safe. Fingers crossed.

Reviewed-by: Jani Nikula <jani.nikula@intel.com>


>  
>  	drm_connector_init(dev, connector, &intel_dsi_connector_funcs,
>  			   DRM_MODE_CONNECTOR_DSI);
diff mbox series

Patch

diff --git a/drivers/gpu/drm/i915/display/intel_dsi.h b/drivers/gpu/drm/i915/display/intel_dsi.h
index de7e51cd3460..675771ea91aa 100644
--- a/drivers/gpu/drm/i915/display/intel_dsi.h
+++ b/drivers/gpu/drm/i915/display/intel_dsi.h
@@ -203,7 +203,7 @@  void bxt_dsi_reset_clocks(struct intel_encoder *encoder, enum port port);
 
 /* intel_dsi_vbt.c */
 bool intel_dsi_vbt_init(struct intel_dsi *intel_dsi, u16 panel_id);
-void intel_dsi_vbt_gpio_init(struct intel_dsi *intel_dsi);
+void intel_dsi_vbt_gpio_init(struct intel_dsi *intel_dsi, bool panel_is_on);
 void intel_dsi_vbt_gpio_cleanup(struct intel_dsi *intel_dsi);
 void intel_dsi_vbt_exec_sequence(struct intel_dsi *intel_dsi,
 				 enum mipi_seq seq_id);
diff --git a/drivers/gpu/drm/i915/display/intel_dsi_vbt.c b/drivers/gpu/drm/i915/display/intel_dsi_vbt.c
index 8be7d6c507aa..4210f449553e 100644
--- a/drivers/gpu/drm/i915/display/intel_dsi_vbt.c
+++ b/drivers/gpu/drm/i915/display/intel_dsi_vbt.c
@@ -688,17 +688,16 @@  bool intel_dsi_vbt_init(struct intel_dsi *intel_dsi, u16 panel_id)
  * On some BYT/CHT devs some sequences are incomplete and we need to manually
  * control some GPIOs.
  */
-void intel_dsi_vbt_gpio_init(struct intel_dsi *intel_dsi)
+void intel_dsi_vbt_gpio_init(struct intel_dsi *intel_dsi, bool panel_is_on)
 {
 	struct drm_device *dev = intel_dsi->base.base.dev;
 	struct drm_i915_private *dev_priv = to_i915(dev);
 	struct mipi_config *mipi_config = dev_priv->vbt.dsi.config;
+	enum gpiod_flags flags = panel_is_on ? GPIOD_OUT_HIGH : GPIOD_OUT_LOW;
 
 	if ((IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv)) &&
 	    mipi_config->pwm_blc == PPS_BLC_PMIC) {
-		intel_dsi->gpio_panel =
-			gpiod_get(dev->dev, "panel", GPIOD_OUT_HIGH);
-
+		intel_dsi->gpio_panel = gpiod_get(dev->dev, "panel", flags);
 		if (IS_ERR(intel_dsi->gpio_panel)) {
 			DRM_ERROR("Failed to own gpio for panel control\n");
 			intel_dsi->gpio_panel = NULL;
diff --git a/drivers/gpu/drm/i915/display/vlv_dsi.c b/drivers/gpu/drm/i915/display/vlv_dsi.c
index c1edd8857af0..d0efee09c593 100644
--- a/drivers/gpu/drm/i915/display/vlv_dsi.c
+++ b/drivers/gpu/drm/i915/display/vlv_dsi.c
@@ -1759,6 +1759,7 @@  void vlv_dsi_init(struct drm_i915_private *dev_priv)
 	struct drm_connector *connector;
 	struct drm_display_mode *current_mode, *fixed_mode;
 	enum port port;
+	enum pipe pipe;
 
 	DRM_DEBUG_KMS("\n");
 
@@ -1857,7 +1858,8 @@  void vlv_dsi_init(struct drm_i915_private *dev_priv)
 
 	vlv_dphy_param_init(intel_dsi);
 
-	intel_dsi_vbt_gpio_init(intel_dsi);
+	intel_dsi_vbt_gpio_init(intel_dsi,
+				intel_dsi_get_hw_state(intel_encoder, &pipe));
 
 	drm_connector_init(dev, connector, &intel_dsi_connector_funcs,
 			   DRM_MODE_CONNECTOR_DSI);