[PATCH_V3,6/6] thermal: stm32: fix low threshold interrupt flood
diff mbox series

Message ID 20200110101605.24984-7-p.paillet@st.com
State Accepted
Delegated to: Daniel Lezcano
Headers show
Series
  • thermal: stm32: driver improvements
Related show

Commit Message

Pascal PAILLET-LME Jan. 10, 2020, 10:16 a.m. UTC
With the STM32 thermal peripheral, it is not possible to dump the
temperature that has caused the interrupt.
When the temperature reaches the low threshold, we generally read
a temperature that is a little bit higher than the low threshold.
This maybe due to sampling precision, and also because the CPU becomes
hotter when it quits WFI mode.
In that case, the framework does not change the trip points. This leads
to a lot of low threshold interrupts.

The fix is to set the low threshold value 0.5 degrees Celsius
below the actual request.

The problem is not so frequent with the high threshold and it would
no be a good idea to set the threshold value higher than the request.

Signed-off-by: Pascal Paillet <p.paillet@st.com>
---
 drivers/thermal/st/stm_thermal.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

Patch
diff mbox series

diff --git a/drivers/thermal/st/stm_thermal.c b/drivers/thermal/st/stm_thermal.c
index aaf25ca2f118..1cc5e6c5709e 100644
--- a/drivers/thermal/st/stm_thermal.c
+++ b/drivers/thermal/st/stm_thermal.c
@@ -321,7 +321,8 @@  static int stm_thermal_set_trips(void *data, int low, int high)
 
 	if (low > -INT_MAX) {
 		sensor->low_temp_enabled = 1;
-		ret = stm_thermal_calculate_threshold(sensor, low, &th);
+		/* add 0.5 of hysteresis due to measurement error */
+		ret = stm_thermal_calculate_threshold(sensor, low - 500, &th);
 		if (ret)
 			return ret;