@@ -402,15 +402,6 @@ static int dw_mipi_dsi_stm_probe(struct platform_device *pdev)
goto err_dsi_probe;
}
- dsi->hw_version = dsi_read(dsi, DSI_VERSION) & VERSION;
- clk_disable_unprepare(pclk);
-
- if (dsi->hw_version != HWVER_130 && dsi->hw_version != HWVER_131) {
- ret = -ENODEV;
- DRM_ERROR("bad dsi hardware version\n");
- goto err_dsi_probe;
- }
-
dw_mipi_dsi_stm_plat_data.base = dsi->base;
dw_mipi_dsi_stm_plat_data.priv_data = dsi;
@@ -423,6 +414,9 @@ static int dw_mipi_dsi_stm_probe(struct platform_device *pdev)
goto err_dsi_probe;
}
+ dsi->hw_version = dsi_read(dsi, DSI_VERSION) & VERSION;
+ clk_disable_unprepare(pclk);
+
return 0;
err_dsi_probe:
The stm mipi-dsi platform driver added a version test in commit fa6251a747b7 ("drm/stm: dsi: check hardware version") so that HW revisions other than v1.3x get rejected. The rockchip driver had no such check and just assumed register layouts are v1.3x compatible. Having such tests was a good idea because only v130/v131 layouts were supported at the time, however since adding multiple layout support in the bridge, the version is automatically checked for all drivers, compatible layouts get picked and unsupported HW is automatically rejected by the bridge, so there's no use keeping the test in the stm driver. The main reason prompting this change is that the stm driver test immediately disabled the peripheral clock after reading the version, making the bridge read version 0x0 immediately after in its own probe(), so we move the clock disabling after the bridge does the version test. Tested on STM32F769 and STM32MP1. Cc: linux-stm32@st-md-mailman.stormreply.com Reported-by: Adrian Pop <pop.adrian61@gmail.com> Tested-by: Adrian Pop <pop.adrian61@gmail.com> Tested-by: Arnaud Ferraris <arnaud.ferraris@collabora.com> Signed-off-by: Adrian Ratiu <adrian.ratiu@collabora.com> --- New in v6. --- drivers/gpu/drm/stm/dw_mipi_dsi-stm.c | 12 +++--------- 1 file changed, 3 insertions(+), 9 deletions(-)