@@ -387,6 +387,8 @@ static void vc4_crtc_atomic_disable(struct drm_crtc *crtc,
{
struct drm_device *dev = crtc->dev;
struct vc4_crtc *vc4_crtc = to_vc4_crtc(crtc);
+ struct drm_encoder *encoder = vc4_get_crtc_encoder(crtc);
+ struct vc4_encoder *vc4_encoder = to_vc4_encoder(encoder);
int ret;
require_hvs_enabled(dev);
@@ -399,10 +401,16 @@ static void vc4_crtc_atomic_disable(struct drm_crtc *crtc,
ret = wait_for(!(CRTC_READ(PV_V_CONTROL) & PV_VCONTROL_VIDEN), 1);
WARN_ONCE(ret, "Timeout waiting for !PV_VCONTROL_VIDEN\n");
+ if (vc4_encoder->post_crtc_disable)
+ vc4_encoder->post_crtc_disable(encoder);
+
CRTC_WRITE(PV_CONTROL, CRTC_READ(PV_CONTROL) & ~PV_CONTROL_EN);
vc4_hvs_atomic_disable(crtc, old_state);
+ if (vc4_encoder->post_crtc_powerdown)
+ vc4_encoder->post_crtc_powerdown(encoder);
+
/*
* Make sure we issue a vblank event after disabling the CRTC if
* someone was waiting it.
@@ -430,6 +438,8 @@ static void vc4_crtc_atomic_enable(struct drm_crtc *crtc,
struct drm_device *dev = crtc->dev;
struct vc4_crtc *vc4_crtc = to_vc4_crtc(crtc);
struct vc4_crtc_state *vc4_state = to_vc4_crtc_state(crtc->state);
+ struct drm_encoder *encoder = vc4_get_crtc_encoder(crtc);
+ struct vc4_encoder *vc4_encoder = to_vc4_encoder(encoder);
require_hvs_enabled(dev);
@@ -440,17 +450,26 @@ static void vc4_crtc_atomic_enable(struct drm_crtc *crtc,
vc4_hvs_atomic_enable(crtc, old_state);
+ if (vc4_encoder->pre_crtc_configure)
+ vc4_encoder->pre_crtc_configure(encoder);
+
if (!vc4_state->feed_txp)
vc4_crtc_config_pv(crtc);
CRTC_WRITE(PV_CONTROL, CRTC_READ(PV_CONTROL) | PV_CONTROL_EN);
+ if (vc4_encoder->pre_crtc_enable)
+ vc4_encoder->pre_crtc_enable(encoder);
+
/* When feeding the transposer block the pixelvalve is unneeded and
* should not be enabled.
*/
if (!vc4_state->feed_txp)
CRTC_WRITE(PV_V_CONTROL,
CRTC_READ(PV_V_CONTROL) | PV_VCONTROL_VIDEN);
+
+ if (vc4_encoder->post_crtc_enable)
+ vc4_encoder->post_crtc_enable(encoder);
}
static enum drm_mode_status vc4_crtc_mode_valid(struct drm_crtc *crtc,
@@ -442,6 +442,13 @@ struct vc4_encoder {
struct drm_encoder base;
enum vc4_encoder_type type;
u32 clock_select;
+
+ void (*pre_crtc_configure)(struct drm_encoder *encoder);
+ void (*pre_crtc_enable)(struct drm_encoder *encoder);
+ void (*post_crtc_enable)(struct drm_encoder *encoder);
+
+ void (*post_crtc_disable)(struct drm_encoder *encoder);
+ void (*post_crtc_powerdown)(struct drm_encoder *encoder);
};
static inline struct vc4_encoder *
In the BCM2711, the setup of the HVS, pixelvalve and HDMI controller requires very precise ordering and timing that the regular atomic callbacks don't provide. Let's add new callbacks on top of the regular ones to be able to split the configuration as needed. Signed-off-by: Maxime Ripard <maxime@cerno.tech> --- drivers/gpu/drm/vc4/vc4_crtc.c | 19 +++++++++++++++++++ drivers/gpu/drm/vc4/vc4_drv.h | 7 +++++++ 2 files changed, 26 insertions(+)