| Message ID | 1590695583-1327-1-git-send-email-tharvey@gateworks.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | ARM: dts: imx6qdl-gw53xx: allow boot firmware to set eth1 MAC | expand |
On Thu, May 28, 2020 at 12:53:03PM -0700, Tim Harvey wrote: > The GW53xx has a PCIe based GbE as the 2nd ethernet device. The > boot firmware will populate the local-mac-address field of the > device aliased to ethernet1 thus adding the PCIe device to > dt allows boot firmware to set its MAC address. > > Signed-off-by: Tim Harvey <tharvey@gateworks.com> Applied, thanks.
diff --git a/arch/arm/boot/dts/imx6qdl-gw53xx.dtsi b/arch/arm/boot/dts/imx6qdl-gw53xx.dtsi index 8942bec..6601d07 100644 --- a/arch/arm/boot/dts/imx6qdl-gw53xx.dtsi +++ b/arch/arm/boot/dts/imx6qdl-gw53xx.dtsi @@ -8,6 +8,7 @@ / { /* these are used by bootloader for disabling nodes */ aliases { + ethernet1 = ð1; led0 = &led0; led1 = &led1; led2 = &led2; @@ -341,6 +342,23 @@ pinctrl-0 = <&pinctrl_pcie>; reset-gpio = <&gpio1 29 GPIO_ACTIVE_LOW>; status = "okay"; + + pcie@0,0,0 { + reg = <0x0000 0 0 0 0>; + + pcie@1,0,0 { + reg = <0x0000 0 0 0 0>; + + pcie@2,4,0 { + reg = <0x2000 0 0 0 0>; + + eth1: pcie@4,0,0 { + reg = <0x0000 0 0 0 0>; + local-mac-address = [00 00 00 00 00 00]; + }; + }; + }; + }; }; &pwm2 {
The GW53xx has a PCIe based GbE as the 2nd ethernet device. The boot firmware will populate the local-mac-address field of the device aliased to ethernet1 thus adding the PCIe device to dt allows boot firmware to set its MAC address. Signed-off-by: Tim Harvey <tharvey@gateworks.com> --- arch/arm/boot/dts/imx6qdl-gw53xx.dtsi | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+)