mcspi: Add support for GPIO chip select lines

Commit Message

Ben Gamari Dec. 21, 2010, 5:56 p.m. UTC

None

Patch

diff --git a/arch/arm/plat-omap/include/plat/mcspi.h b/arch/arm/plat-omap/include/plat/mcspi.h
index 1254e49..ab84b8d 100644
--- a/arch/arm/plat-omap/include/plat/mcspi.h
+++ b/arch/arm/plat-omap/include/plat/mcspi.h
@@ -1,6 +1,20 @@ 
 #ifndef _OMAP2_MCSPI_H
 #define _OMAP2_MCSPI_H
 
+/**
+ * struct omap2_mcspi_csinfo - Chip Select description
+ * @line: Custom 'identity' of the CS line
+ * @set_level: Function to set the state of a given CS line
+ *
+ * This is to allow use of GPIO lines as CS lines. Allocate and initialize one
+ * in the machine init code and make spi_board_info.controller_data point to
+ * it.
+ */
+struct omap2_mcspi_csinfo {
+        unsigned line;
+        void (*set_level)(unsigned line_id, int lvl);
+};
+
 struct omap2_mcspi_platform_config {
 	unsigned short	num_cs;
 };
diff --git a/drivers/spi/omap2_mcspi.c b/drivers/spi/omap2_mcspi.c
index 2a651e6..92ccbd6 100644
--- a/drivers/spi/omap2_mcspi.c
+++ b/drivers/spi/omap2_mcspi.c
@@ -35,6 +35,7 @@ 
 #include <linux/slab.h>
 
 #include <linux/spi/spi.h>
+#include <linux/gpio.h>
 
 #include <plat/dma.h>
 #include <plat/clock.h>
@@ -235,11 +236,14 @@  static void omap2_mcspi_set_enable(const struct spi_device *spi, int enable)
 
 static void omap2_mcspi_force_cs(struct spi_device *spi, int cs_active)
 {
-	u32 l;
-
-	l = mcspi_cached_chconf0(spi);
-	MOD_REG_BIT(l, OMAP2_MCSPI_CHCONF_FORCE, cs_active);
-	mcspi_write_chconf0(spi, l);
+	if (spi->controller_data) {
+		struct omap2_mcspi_csinfo *csinfo = spi->controller_data;
+		(*csinfo->set_level)(csinfo->line, cs_active);
+	} else {
+		u32 l = mcspi_cached_chconf0(spi);
+		MOD_REG_BIT(l, OMAP2_MCSPI_CHCONF_FORCE, cs_active);
+		mcspi_write_chconf0(spi, l);
+	}
 }
 
 static void omap2_mcspi_set_master_mode(struct spi_master *master)