@@ -35,8 +35,6 @@ the capability ioctls weren't implemented yet via the new way.</para>
API is to replace the ioctl's were the <link linkend="dvb-frontend-parameters">
struct <constant>dvb_frontend_parameters</constant></link> were used.</para>
-&sub-fe-get-property;
-
<section id="dtv-stats">
<title>DTV stats type</title>
<programlisting>
@@ -37,8 +37,6 @@ specification is available at
<link linkend="FE_GET_INFO">FE_GET_INFO</link>.</para>
</section>
-&sub-fe-get-info;
-
<section id="dvb-fe-read-status">
<title>Querying frontend status</title>
@@ -46,8 +44,6 @@ specification is available at
<link linkend="FE_READ_STATUS">FE_READ_STATUS</link>.</para>
</section>
-&sub-fe-read-status;
-
&sub-dvbproperty;
<section id="fe-spectral-inversion-t">
@@ -333,6 +329,9 @@ typedef enum fe_hierarchy {
</row></tbody></tgroup></informaltable>
</section>
+&sub-fe-get-info;
+&sub-fe-read-status;
+&sub-fe-get-property;
&sub-fe-diseqc-reset-overload;
&sub-fe-diseqc-send-master-cmd;
&sub-fe-diseqc-recv-slave-reply;
Move the function ioctl definitions to the end of the chapter, at their importance. That makes the document better organized, as the DVB frontend system call index will look like: open() close() ioctl FE_GET_INFO — Query DVB frontend capabilities and returns information about the front-end. This call only requires read-only access to the device ioctl FE_READ_STATUS — Returns status information about the front-end. This call only requires read-only access to the device ioctl FE_SET_PROPERTY, FE_GET_PROPERTY — FE_SET_PROPERTY sets one or more frontend properties. FE_GET_PROPERTY returns one or more frontend properties. ioctl FE_DISEQC_RESET_OVERLOAD — Restores the power to the antenna subsystem, if it was powered off due to power overload. ioctl FE_DISEQC_SEND_MASTER_CMD — Sends a DiSEqC command ioctl FE_DISEQC_RECV_SLAVE_REPLY — Receives reply from a DiSEqC 2.0 command ioctl FE_DISEQC_SEND_BURST — Sends a 22KHz tone burst for 2x1 mini DiSEqC satellite selection. ioctl FE_SET_TONE — Sets/resets the generation of the continuous 22kHz tone. ioctl FE_SET_VOLTAGE — Allow setting the DC level sent to the antenna subsystem. ioctl FE_ENABLE_HIGH_LNB_VOLTAGE — Select output DC level between normal LNBf voltages or higher LNBf voltages. ioctl FE_SET_FRONTEND_TUNE_MODE — Allow setting tuner mode flags to the frontend. Signed-off-by: Mauro Carvalho Chehab <mchehab@osg.samsung.com>