diff --git a/drivers/regulator/rk808-regulator.c b/drivers/regulator/rk808-regulator.c
index 3fd4435..ca913fd 100644
--- a/drivers/regulator/rk808-regulator.c
+++ b/drivers/regulator/rk808-regulator.c
@@ -16,10 +16,13 @@
  * more details.
  */
 
-#include <linux/module.h>
+#include <linux/delay.h>
+#include <linux/gpio.h>
 #include <linux/i2c.h>
-#include <linux/mfd/rk808.h>
+#include <linux/module.h>
 #include <linux/of_device.h>
+#include <linux/of_gpio.h>
+#include <linux/mfd/rk808.h>
 #include <linux/regulator/driver.h>
 #include <linux/regulator/of_regulator.h>
 
@@ -36,12 +39,25 @@
 #define RK808_RAMP_RATE_6MV_PER_US	(2 << RK808_RAMP_RATE_OFFSET)
 #define RK808_RAMP_RATE_10MV_PER_US	(3 << RK808_RAMP_RATE_OFFSET)
 
+#define RK808_DVS2_POL		BIT(2)
+#define RK808_DVS1_POL		BIT(1)
+
 /* Offset from XXX_ON_VSEL to XXX_SLP_VSEL */
 #define RK808_SLP_REG_OFFSET 1
 
+/* Offset from XXX_ON_VSEL to XXX_DVS_VSEL */
+#define RK808_DVS_REG_OFFSET 2
+
 /* Offset from XXX_EN_REG to SLEEP_SET_OFF_XXX */
 #define RK808_SLP_SET_OFF_REG_OFFSET 2
 
+/* max steps for increase voltage of Buck1/2, equal 100mv*/
+#define MAX_STEPS_ONE_TIME 8
+
+struct rk808_regulator_data {
+	struct gpio_desc *dvs_gpio[2];
+};
+
 static const int rk808_buck_config_regs[] = {
 	RK808_BUCK1_CONFIG_REG,
 	RK808_BUCK2_CONFIG_REG,
@@ -70,6 +86,131 @@ static const struct regulator_linear_range rk808_ldo6_voltage_ranges[] = {
 	REGULATOR_LINEAR_RANGE(800000, 0, 17, 100000),
 };
 
+static int rk808_buck1_2_get_voltage_sel_regmap(struct regulator_dev *rdev)
+{
+	struct rk808_regulator_data *pdata = rdev_get_drvdata(rdev);
+	int id = rdev->desc->id - RK808_ID_DCDC1;
+	struct gpio_desc *gpio = pdata->dvs_gpio[id];
+	unsigned int val;
+	int ret;
+
+	if (IS_ERR(gpio) || gpiod_get_value(gpio) == 0)
+		return regulator_get_voltage_sel_regmap(rdev);
+
+	ret = regmap_read(rdev->regmap,
+			  rdev->desc->vsel_reg + RK808_DVS_REG_OFFSET,
+			  &val);
+	if (ret != 0)
+		return ret;
+
+	val &= rdev->desc->vsel_mask;
+	val >>= ffs(rdev->desc->vsel_mask) - 1;
+
+	return val;
+}
+
+static int rk808_buck1_2_i2c_set_voltage_sel(struct regulator_dev *rdev,
+					     unsigned sel)
+{
+	int ret, delta_sel;
+	unsigned int old_sel, tmp, val, mask = rdev->desc->vsel_mask;
+
+	ret = regmap_read(rdev->regmap, rdev->desc->vsel_reg, &val);
+	if (ret != 0)
+		return ret;
+
+	tmp = val & ~mask;
+	old_sel = val & mask;
+	old_sel >>= ffs(mask) - 1;
+	delta_sel = sel - old_sel;
+
+	/*
+	 * If directly modify the register to change the voltage, we will face
+	 * the risk of overshoot. Put it into a multi-step, can effectively
+	 * avoid this problem, a step is 100mv here.
+	 */
+	while (delta_sel > MAX_STEPS_ONE_TIME) {
+		old_sel += MAX_STEPS_ONE_TIME;
+		val = old_sel << (ffs(mask) - 1);
+		val |= tmp;
+
+		/*
+		 * i2c is 400kHz (2.5us per bit) and we must transmit _at least_
+		 * 3 bytes (24 bits) plus start and stop so 26 bits.  So we've
+		 * got more than 65 us between each voltage change and thus
+		 * won't ramp faster than ~1500 uV / us.
+		 */
+		ret = regmap_write(rdev->regmap, rdev->desc->vsel_reg, val);
+		delta_sel = sel - old_sel;
+	}
+
+	sel <<= ffs(mask) - 1;
+	val = tmp | sel;
+	ret = regmap_write(rdev->regmap, rdev->desc->vsel_reg, val);
+
+	/*
+	 * When we change the voltage register directly, the ramp rate is about
+	 * 100000uv/us, wait 1us to make sure the target voltage to be stable,
+	 * so we needn't wait extra time after that.
+	 */
+	udelay(1);
+
+	return ret;
+}
+
+static int rk808_buck1_2_set_voltage_sel(struct regulator_dev *rdev,
+					 unsigned sel)
+{
+	struct rk808_regulator_data *pdata = rdev_get_drvdata(rdev);
+	int id = rdev->desc->id - RK808_ID_DCDC1;
+	struct gpio_desc *gpio = pdata->dvs_gpio[id];
+	unsigned int reg = rdev->desc->vsel_reg;
+	unsigned old_sel;
+	int ret, gpio_level;
+
+	if (IS_ERR(gpio))
+		return rk808_buck1_2_i2c_set_voltage_sel(rdev, sel);
+
+	gpio_level = gpiod_get_value(gpio);
+	if (gpio_level == 0) {
+		reg += RK808_DVS_REG_OFFSET;
+		ret = regmap_read(rdev->regmap, rdev->desc->vsel_reg, &old_sel);
+	} else {
+		ret = regmap_read(rdev->regmap,
+				  reg + RK808_DVS_REG_OFFSET,
+				  &old_sel);
+	}
+
+	if (ret != 0)
+		return ret;
+
+	sel <<= ffs(rdev->desc->vsel_mask) - 1;
+	sel |= old_sel & ~rdev->desc->vsel_mask;
+
+	ret = regmap_write(rdev->regmap, reg, sel);
+	if (ret)
+		return ret;
+
+	gpiod_set_value(gpio, !gpio_level);
+
+	return ret;
+}
+
+static int rk808_buck1_2_set_voltage_time_sel(struct regulator_dev *rdev,
+				       unsigned int old_selector,
+				       unsigned int new_selector)
+{
+	struct rk808_regulator_data *pdata = rdev_get_drvdata(rdev);
+	int id = rdev->desc->id - RK808_ID_DCDC1;
+	struct gpio_desc *gpio = pdata->dvs_gpio[id];
+
+	/* if there is no dvs1/2 pin, we don't need wait extra time here. */
+	if (IS_ERR(gpio))
+		return 0;
+
+	return regulator_set_voltage_time_sel(rdev, old_selector, new_selector);
+}
+
 static int rk808_set_ramp_delay(struct regulator_dev *rdev, int ramp_delay)
 {
 	unsigned int ramp_value = RK808_RAMP_RATE_10MV_PER_US;
@@ -137,8 +278,9 @@ static int rk808_set_suspend_disable(struct regulator_dev *rdev)
 static struct regulator_ops rk808_buck1_2_ops = {
 	.list_voltage		= regulator_list_voltage_linear_range,
 	.map_voltage		= regulator_map_voltage_linear_range,
-	.get_voltage_sel	= regulator_get_voltage_sel_regmap,
-	.set_voltage_sel	= regulator_set_voltage_sel_regmap,
+	.get_voltage_sel	= rk808_buck1_2_get_voltage_sel_regmap,
+	.set_voltage_sel	= rk808_buck1_2_set_voltage_sel,
+	.set_voltage_time_sel	= rk808_buck1_2_set_voltage_time_sel,
 	.enable			= regulator_enable_regmap,
 	.disable		= regulator_disable_regmap,
 	.is_enabled		= regulator_is_enabled_regmap,
@@ -380,25 +522,76 @@ static struct of_regulator_match rk808_reg_matches[] = {
 	[RK808_ID_SWITCH2]	= { .name = "SWITCH_REG2" },
 };
 
+static int rk808_regulator_dt_parse_pdata(struct device *dev,
+				   struct device *client_dev,
+				   struct regmap *map,
+				   struct rk808_regulator_data *pdata)
+{
+	struct device_node *np;
+	int tmp, ret, i;
+
+	np = of_get_child_by_name(client_dev->of_node, "regulators");
+	if (!np)
+		return -ENXIO;
+
+	ret = of_regulator_match(dev, np, rk808_reg_matches,
+				 RK808_NUM_REGULATORS);
+	if (ret < 0)
+		goto dt_parse_end;
+
+	for (i = 0; i < ARRAY_SIZE(pdata->dvs_gpio); i++) {
+		pdata->dvs_gpio[i] = gpiod_get_index(client_dev, "dvs", i);
+		if (IS_ERR(pdata->dvs_gpio[i])) {
+			dev_warn(dev, "there is no dvs%d gpio\n", i);
+			continue;
+		}
+
+		gpiod_direction_output(pdata->dvs_gpio[i], 0);
+
+		tmp = i ? RK808_DVS2_POL : RK808_DVS1_POL;
+		ret = regmap_update_bits(map, RK808_IO_POL_REG, tmp,
+				gpiod_is_active_low(pdata->dvs_gpio[i]) ?
+				0 : tmp);
+	}
+
+dt_parse_end:
+	of_node_put(np);
+	return ret;
+}
+
+static int rk808_regulator_remove(struct platform_device *pdev)
+{
+	struct rk808_regulator_data *pdata = platform_get_drvdata(pdev);
+	int i;
+
+	for (i = 0; i < ARRAY_SIZE(pdata->dvs_gpio); i++) {
+		if (!IS_ERR(pdata->dvs_gpio[i]))
+			gpiod_put(pdata->dvs_gpio[i]);
+	}
+
+	return 0;
+}
+
 static int rk808_regulator_probe(struct platform_device *pdev)
 {
 	struct rk808 *rk808 = dev_get_drvdata(pdev->dev.parent);
 	struct i2c_client *client = rk808->i2c;
-	struct device_node *reg_np;
 	struct regulator_config config = {};
 	struct regulator_dev *rk808_rdev;
+	struct rk808_regulator_data *pdata;
 	int ret, i;
 
-	reg_np = of_get_child_by_name(client->dev.of_node, "regulators");
-	if (!reg_np)
-		return -ENXIO;
+	pdata = devm_kzalloc(&pdev->dev, sizeof(*pdata), GFP_KERNEL);
+	if (!pdata)
+		return -ENOMEM;
 
-	ret = of_regulator_match(&pdev->dev, reg_np, rk808_reg_matches,
-				 RK808_NUM_REGULATORS);
-	of_node_put(reg_np);
+	ret = rk808_regulator_dt_parse_pdata(&pdev->dev, &client->dev,
+					     rk808->regmap, pdata);
 	if (ret < 0)
 		return ret;
 
+	platform_set_drvdata(pdev, pdata);
+
 	/* Instantiate the regulators */
 	for (i = 0; i < RK808_NUM_REGULATORS; i++) {
 		if (!rk808_reg_matches[i].init_data ||
@@ -406,7 +599,7 @@ static int rk808_regulator_probe(struct platform_device *pdev)
 			continue;
 
 		config.dev = &client->dev;
-		config.driver_data = rk808;
+		config.driver_data = pdata;
 		config.regmap = rk808->regmap;
 		config.of_node = rk808_reg_matches[i].of_node;
 		config.init_data = rk808_reg_matches[i].init_data;
@@ -425,8 +618,10 @@ static int rk808_regulator_probe(struct platform_device *pdev)
 
 static struct platform_driver rk808_regulator_driver = {
 	.probe = rk808_regulator_probe,
+	.remove = rk808_regulator_remove,
 	.driver = {
 		.name = "rk808-regulator",
+		.owner = THIS_MODULE,
 	},
 };
 
